Search NASAβŒ• Search

Engineering topics

Bennett, R.

Publications and source records attributed to Bennett, R..

17 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

Erratum: Centrality-Dependent Modification of Jet-Production Rates in Deuteron-Gold Collisions at $\sqrt{𝑠_{𝑁⁒𝑁}}$ = 200 GeV [Phys. Rev. Lett. 116, 122301 (2016)]

We previously reported jet-production rates in 𝑝 + 𝑝 and 𝑑 + Au collisions at $\sqrt{𝑠_{𝑁⁒𝑁}}$ = 200 GeV recorded in 2008 with the PHENIX detector at the Relativistic Heavy Ion Collider. Subsequently, we found that electronic noise in the electromagnetic calorimeter was not completely removed by the tower-timing cuts used in the analysis. We have conducted an independent re-analysis of the data that eliminated noisy towers by removing them completely from the analysis. These cuts remove any contributions from instrumental noise, but reduce the overall acceptance for electromagnetic clusters by β‰ˆ16% and hence the overall statistical power of the data. Finally, this re-analysis found that instrumental noise in the electromagnetic calorimeter led to an artificial increase in the jet yield for both the 𝑝 + 𝑝 and 𝑑 + Au collisions.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2024

Jet modification via πœ‹ 0 -hadron correlations in Au + Au collisions at $\sqrt{s_{NN}}$ = 200 GeV

High-momentum two-particle correlations are a useful tool for studying jet-quenching effects in the quark-gluon plasma. Angular correlations between neutral-pion triggers and charged hadrons with transverse momenta in the range 4–12 GeV/𝑐 and 0.5–7 GeV/𝑐, respectively, have been measured by the PHENIX experiment in 2014 for Au + Au collisions at $\sqrt{s_{NN}}$ = 200 GeV. Suppression is observed in the yield of high-momentum jet fragments opposite the trigger particle, which indicates jet suppression stemming from in-medium partonic energy loss, while enhancement is observed for low-momentum particles. The ratio and differences between the yield in Au + Au collisions and 𝑝 + 𝑝 collisions, 𝐼 𝐴⁒𝐴 and Ξ” 𝐴⁒𝐴 , as a function of the trigger-hadron azimuthal separation, Ξ”β’πœ™, are measured for the first time at the BNL Relativistic Heavy Ion Collider. Finally, these results better quantify how the yield of low-𝑝 𝑇 associated hadrons is enhanced at wide angle, which is crucial for studying energy loss as well as medium-response effects.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2022

Steady Long-term Slip Rate on the Blue Cut Fault: Implications for Ongoing Block Rotation in the Eastern Transverse Ranges, CA

We report the Eastern Transverse Ranges (ETR) province of California contains a system of E-W-trending left-lateral faults accommodating clockwise block rotation between the San Andreas Fault (SAF) system in the Coachella Valley and the Eastern California Shear Zone (ECSZ) in the Mojave Desert. Building upon established geometric relationships, we estimate that this rotation across the ETR may transfer right-lateral strain from the SAF to the ECSZ at a time-averaged rate of ~4.3–7.7 mm/yr. Through geomorphic mapping and the analysis of 38 10 Be surface exposure samples, we derive a long-term slip rate of 1.26 Β± 0.50 (2Οƒ) mm/yr over the late Pleistocene, yet analysis of the displacement record indicates a rate decrease ~71 kya. While a rate change on this fault could have implications for possible plate boundary reorganization in this area, we argue that this slip rate variability more likely reflects routine fluctuation about a steady lifetime slip rate.

58 GEOSCIENCES↗
DOE OSTI2022

Systematic study of nuclear effects in p + Al , p + Au , d + Au , and He 3 + Au collisions at s N N = 200 GeV using Ο€ 0 production

The PHENIX Collaboration presents a systematic study of inclusive Ο€ 0 production from p + p , p + Al , p + Au , d + Au , and He 3 + Au collisions at s N N = 200 GeV . Measurements were performed with different centrality selections as well as the total inelastic, 0–100%, selection for all collision systems. For 0–100% collisions, the nuclear-modification factors, R x A , are consistent with unity for p T above 8 GeV / c , but exhibit an enhancement in peripheral collisions and a suppression in central collisions. The enhancement and suppression characteristics are similar for all systems for the same centrality class. It is shown that for high- p T - Ο€ 0 production, the nucleons in the d and He 3 interact mostly independently with the Au nucleus and that the counterintuitive centrality dependence is likely due to a physical correlation between multiplicity and the presence of a hard scattering process. These observations disfavor models where parton energy loss has a significant contribution to nuclear modifications in small systems. Nuclear modifications at lower p T resemble the Cronin effectβ€”an increase followed by a peak in central or inelastic collisions and a plateau in peripheral collisions. The peak height has a characteristic ordering by system size as p + Au > d + Au > He 3 + Au > p + Al . For collisions with Au ions, current calculations based on initial-state cold nuclear matter effects result in the opposite order, suggesting the presence of other contributions to nuclear modifications, in particular at lower p T .

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
DOE OSTI2020

Commissioning Status of the Linac for the Facility for Rare Isotope Beams

The Facility for Rare Isotope Beams will be completed in late 2021. Here, we report here on the current efforts to commission the first stages of the 200-MeV/u superconducting, continuous wave heavy-ion linac. The statuses of the cryogenic plant and its distribution system, the accelerator cryomodule commissioning and operations, the ion source and front end transport development, the radio-frequency quadrupole commissioning, and then beam dynamics development to support high-power operation are reviewed. Plans for commissioning the remainder of the linac systems are presented.

43 PARTICLE ACCELERATORS↗
NASA NTRS2003

EEPROM bit failure investigation

This paper reports the investigation findings concerning of the EEPROM single bit failures that were observed on a recent NASA space mission.

EEPROM↗
NASA NTRS1995

The Powerstick Development

Proof of concept testing has been performed on a 'powerstick' trickle charger, which uses heat from a radioisotope heater unit to charge spacecraft batteries. The type of unit being tested uses a bismuth-telluride thermoelectric converter to produce roughly 40 mW at 15 V. This is much less power than a radioisotope thermoelectric generator (RTG), but the cost and level of environmental concern are also much less.

spacecraft power radioisotope heater unit RHU↗
NASA NTRS1995

Lithium Battery Space Experiment

The In-Space Technology Experiments Program selected the Jet Propulsion Laboratory to conduct a Phase A study of the Lithium Battery Experiment. The experiment will mark the first time a rechargeable lithium battery will be flown in space. The operation of the battery involves lithium deposition and dissolution processed. Micro gravity influences these processes significantly. The experiment will check the rate capability, discharge voltage, capacity and the phenomena affecting cycle life. The paper describes the design and methodology of this experiment.

Mueller, R.β†—
NASA NTRS1995

Lithium Battery Space Experiment

The Jet Propulsion Laboratory will test a lithium battery (Li- TiS2) in orbit and examine the battery after it is returned to Earth. The results will be used to suggest design changes for a battery that may eventually be 3-4 times lighter than the equivalent NiCd battery.

battery↗
NASA NTRS1995

Planetary and Deep Space Requirements for Photovoltaic Solar Arrray

Most spacecraft are powered by nuclear sources. Now, on smaller, low-cost missions, photovoltaic arrays are being planned. Because they may be exposed to high temperatures and radiation when exploring the inner planets, cell materials and array structures must be able to perform at high incidence angles.

photovoltaic arrays, cell materials, array structu↗
NASA NTRS1992

A mobile robot system for ground servicing operations on the space shuttle

A mobile system for space shuttle servicing, the Tessellator, has been configured, designed and is currently being built and integrated. Robot tasks include chemical injection and inspection of the shuttle's thermal protection system. This paper outlines tasks, rationale, and facility requirements for the development of this system. A detailed look at the mobile system and manipulator follow with a look at mechanics, electronics, and software. Salient features of the mobile robot include omnidirectionality, high reach, high stiffness and accuracy with safety and self-reliance integral to all aspects of the design. The robot system is shown to meet task, facility, and NASA requirements in its design resulting in unprecedented specifications for a mobile-manipulation system.

Dowling, K.β†—