Search NASA⌕ Search

Engineering topics

Betti, R.

Publications and source records attributed to Betti, R..

189 records · Page 11

The experimental plan for cryogenic layered target implosions on the National Ignition Facility—The inertial confinement approach to fusion

Ignition requires precisely controlled, high convergence implosions to assemble a dense shell of deuterium-tritium (DT) fuel with ρR>~1 g/cm 2 surrounding a 10 keV hot spot with ρR ~ 0.3 g/cm 2 . A working definition of ignition has been a yield of ~1 MJ. At this yield the α-particle energy deposited in the fuel would have been ~200 kJ, which is already ~10 × more than the kinetic energy of a typical implosion. The National Ignition Campaign includes low yield implosions with dudded fuel layers to study and optimize the hydrodynamic assembly of the fuel in a diagnostics rich environment. The fuel is a mixture of tritium-hydrogen-deuterium (THD) with a density equivalent to DT. The fraction of D can be adjusted to control the neutron yield. Yields of ~10 14-15 14 MeV (primary) neutrons are adequate to diagnose the hot spot as well as the dense fuel properties via down scattering of the primary neutrons. X-ray imaging diagnostics can function in this low yield environment providing additional information about the assembled fuel either by imaging the photons emitted by the hot central plasma, or by active probing of the dense shell by a separate high energy short pulse flash. The planned use of these targets and diagnostics to assess and optimize the assembly of the fuel and how this relates to the predicted performance of DT targets is described. It is found that a good predictor of DT target performance is the THD measurable parameter, Experimental Ignition Threshold Factor, ITFX ~ Y × dsf 2.3 , where Y is the measured neutron yield between 13 and 15 MeV, and dsf is the down scattered neutron fraction defined as the ratio of neutrons between 10 and 12 MeV and those between 13 and 15 MeV.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

High-performance inertial confinement fusion target implosions on OMEGA

The Omega Laser Facility is used to study inertial confinement fusion (ICF) concepts. This paper describes progress in direct-drive central hot-spot (CHS) ICF, shock ignition (SI) and fast ignition (FI) since the 2008 IAEA FEC conference. CHS cryogenic deuterium–tritium (DT) target implosions on OMEGA have produced the highest DT areal densities yet measured in ICF implosions (~300 mg cm -2 ). Integrated FI experiments have shown a significant increase in neutron yield caused by an appropriately timed high-intensity, high-energy laser pulse.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Effect of Collisionality on Kinetic Stability of the Resistive Wall Mode

The impact of collisionless, energy-independent, and energy-dependent collisionality models on the kinetic stability of the resistive wall mode is examined for high pressure plasmas in the National Spherical Torus Experiment. Future devices will have decreased collisionality, which previous stability models predict to be universally destabilizing. In contrast, in kinetic theory reduced ion-ion collisions are shown to lead to a significant stability increase when the plasma rotation frequency is in a stabilizing resonance with the ion precession drift frequency. When the plasma is in a reduced stability state with rotation in between resonances, collisionality will have little effect on stability.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Development of a Polar Drive Shock Ignition Platform on the National Ignition Facility

Shock ignition, a new concept for igniting thermonuclear fuel, offers the possibility for a near-term test of high-gain inertial confinement fusion on the National Ignition Facility at less than 1MJ drive energy and without the need for new laser hardware. In shock ignition, compressed fusion fuel is separately ignited by a strong late-time laser-driven shock and, because capsule implosion velocities are significantly lower than those required for conventional hotpot ignition, fusion energy gains of ~60 may be achievable on NIF at laser drive energies around ~0.5MJ, extending to ~100 at 1MJ. Because of the simple all-DT target design, its in-flight robustness, the potential need for only 1D SSD beam smoothing, minimal early time LPI preheat, and use of present (indirect drive) laser hardware, this target should be easier to field on NIF than a conventional direct-drive hotspot ignition target. A key immediate need is to determine the adequacy of low-mode drive uniformity and shock symmetry under NIF polar drive for the convergence ratios envisaged for these targets. Accordingly, we propose a set of phased experiments employing room temperature hydro-equivalent CH shells to (a) optimize NIF polar-drive symmetry and shock coupling under a combination of beam repointing, partial defocusing and phasing the time-dependent power balance from quad to quad, and (b) characterize the resulting laser-plasma interactions. The objective is to determine the optimum laser drive specifications that will then enable the fielding of a full cryogenic high-gain shock-ignition target on NIF ca. 2014.

42 ENGINEERING↗

Proton radiography of dynamic electric and magnetic fields in laser-produced high-energy-density plasmas

Time-gated, monoenergetic-proton radiography provides unique measurements of the electric (E) and magnetic (B) fields produced in laser-foil interactions and during the implosion of inertial-confinement-fusion capsules. These experiments resulted in the first observations of several new and important features: (1) observations of the generation, decay dynamics, and instabilities of megagauss B fields in laser-driven planar plastic foils, (2) the observation of radial E fields inside an imploding capsule, which are initially directed inward, reverse direction during deceleration, and are likely related to the evolution of the electron pressure gradient, and (3) the observation of many radial filaments with complex electromagnetic field striations in the expanding coronal plasmas surrounding the capsule. The physics behind and implications of such observed fields are discussed.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Overview of Results from the National Spherical Torus Experiment (NSTX)

The mission of NSTX is the demonstration of the physics basis required to extrapolate to the next steps for the spherical torus (ST), such as a plasma facing component test facility (NHTX) or an ST based component test facility (ST-CTF), and to support ITER. Key issues for the ST are transport, and steady state high β operation. To better understand electron transport, a new high-k scattering diagnostic was used extensively to investigate electron gyro-scale fluctuations with varying electron temperature gradient scale-length. Results from n = 3 braking studies are consistent with the flow shear dependence of ion transport. New results from electron Bernstein wave emission measurements from plasmas with lithium wall coating applied indicate transmission efficiencies near 70% in H-mode as a result of reduced collisionality. Improved coupling of High Harmonic Fast-Waves has been achieved by reducing the edge density relative to the critical density for surface wave coupling. In order to achieve high bootstrap current fraction, future ST designs envision running at very high elongation. Plasmas have been maintained on NSTX at very low internal inductance l i ~0.4 with strong shaping (κ ~ 2.7, δ ~ 0.8) with β N approaching the with-wall beta limit for several energy confinement times. By operating at lower collisionality in this regime, NSTX has achieved record non-inductive current drive fraction f NI ~71%. Instabilities driven by super-Alfv´enic ions will be an important issue for all burning plasmas, including ITER. Fast ions from NBI on NSTX are super-Alfv´enic. Linear TAE thresholds and appreciable fast-ion loss during multi-mode bursts are measured and these results are compared to theory. The impact of n > 1 error fields on stability is a important result for ITER. RWM/RFA feedback combined with n=3 error field control was used on NSTX to maintain plasma rotation with β above the no-wall limit. Other highlights are: results of lithium coating experiments, momentum confinement studies, scrape-off layer width scaling, demonstration of divertor heat load mitigation in strongly shaped plasmas, and coupling of CHI plasmas to OH ramp-up. These results advance the ST towards next step fusion energy devices such as NHTX and ST-CTF

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗