Engineering topics

Blackwelder, R. F.

Publications and source records attributed to Blackwelder, R. F..

5 records

NASA NTRS2007

Initiation of Turbulent Spots in a Laminar Boundary Layer by Rigid Falling Particulates

A transitional laminar boundary layer is developed on a 1m wide km long flat plate in a 0.6m deep water channel with a freestream velocity of 15-50 cm/s. A particulate dispenser under computer control ejects individual particles having diameters of 1/3 delta into the free stream. The particulates are introduced with an initial velocity of U(sub infinity) in the direction of the free stream. They have differing specific gravities of 1.03-2.7 which introduces an additional non-dimensional parameter relating the time taken to traverse the boundary layer to the convective time scale. The particulates produce a wake in the upper region of the boundary layer as they sink towards the wall. Visualization data taken over the range 5 x 10(exp 4) less than Re(sub x) less than 5 x 10(exp 5) indicate that turbulent spots are produced by the disturbances due to the wake rather than by the particulates themselves. This suggests that the spot formation process in this case may be inviscid in nature and may not be strongly influenced by the presence of the wall.

Blackwelder, R. F.↗

NASA NTRS1988

The effects of longitudinal roughness elements upon the turbulent boundary layer

Velocity profiles and bursting statistics were measured in the presence of cylindrical longitudinal roughness elements (LREs) and compared to similar work by Johansen and Smith (1986). An algorithm was devised to detect low speed streaks (LSS) from the hot-wire rake data, allowing an estimation of the LREs' ability to reduce spatial randomness of the sublayer structure. The velocity profiles agree with Johansen and Smith's result that the effects of the LREs are felt only for y(+) less than about 15. The analysis of the bursting statistics and LSS algorithm output shows that the flow relaxes back to a flat plate boundary layer between the LREs. A crude first approximation is that the LREs simply impose the no-slip boundary condition at an elevation equivalent to their diameter. While the LREs might serve as a nucleation site for the LSS, spatial randomness of the structure is affected only very close to the LREs.

Blackwelder, R. F.↗

NASA NTRS1983

Analogies between transitional and turbulent boundary layers

One of the interesting aspects of transitional and turbulent boundary layers is the development of counter-rotating streamwise vortices near the wall. The most regular pattern is found in a boundary layer on a concave wall where the generation mechanism is known to be the Goertler instability. The origin of these vortices in other translational and turbulent boundary layers is presently unknown. Since the counter-rotating vortices are located in a region of strong shear, low-speed fluid is pumped away from the wall which coalesces into regions of low momentum lying between the vortices. As this pumping action continues, localized inflectional velocity profiles become apparent in the transitional and turbulent boundary layers. The oscillations which develop upon these profiles scale with the local thickness and velocity difference in the same manner as the two-dimensional steady free shear layer stability problems. The oscillations grow to large amplitude and break down into new turbulence in both the transitional and turbulent boundary layers.

Blackwelder, R. F.↗

NASA NTRS1981

On the growth of turbulent regions in laminar boundary layers

Turbulent spots evolving in a laminar boundary layer on a nominally zero pressure gradient flat plate are investigated. The plate is towed through an 18 m water channel, using a carriage that rides on a continuously replenished oil film giving a vibrationless tow. Turbulent spots are initiated using a solenoid valve that ejects a small amount of fluid through a minute hole on the working surface. A novel visualization technique that utilizes fluorescent dye excited by a sheet of laser light is employed. Some new aspects of the growth and entrainment of turbulent spots, especially with regard to lateral growth, are inferred from the present experiments. To supplement the information on lateral spreading, a turbulent wedge created by placing a roughness element in the laminar boundary layer is also studied both visually and with probe measurements. The present results show that, in addition to entrainment, another mechanism is needed to explain the lateral growth characteristics of a turbulent region in a laminar boundary layer. This mechanism, termed growth by destabilization, appears to be a result of the turbulence destabilizing the unstable laminar boundary layer in its vicinity. To further understand the growth mechanisms, the turbulence in the spot is modulated using drag-reducing additives and salinity stratification.

Gad-El-hak, M.↗

NASA NTRS1979

Longitudinal vortices in a transitioning boundary layer

Naturally occurring spanwise variations of the streamwise velocity component, characteristic of longitudinal vortices embedded in a transitioning boundary layer were explored using hot-wire anemometers. A vibrating ribbon introduced stable or unstable Tollmien-Schlichting waves into the laminar boundary layer. These damped or growing disturbances always developed a strong three dimensional pattern even though no spanwise perturbations were artificially induced. Changing the radius of the leading edge and other modifications to the flat plate, wind tunnel and boundary layer did not alter the spanwise wavelength of the vortices.

Anders, J. B.↗