Engineering topics

Block, P. J. W.

Publications and source records attributed to Block, P. J. W..

24 records · Page 2

NASA NTRS1979

Evaluation of a vortex model of turbulent cavity flow

A two dimensional discrete vortex model is applied to turbulent flow over a cavity at a Reynolds number based on cavity half length of approximately 500,000. These model predictions are compared with experimental data on a time average and on a spectral basis. The comparisons indicate that the vortex model reproduces the mean velocity profiles of this complex flow, while the turbulent intensity and Reynolds stress profiles are overpredicted in magnitude. Spectral analyses show that the vortex model introduces unrealistic low frequency power which becomes less dominant as the model becomes more disordered. The spectral power distribution of the model in this state is nearly in agreement with that of the data, somewhat too low at the higher frequencies and too high at the lower frequencies. The model is shown to be capable of reproducing the cavity feedback oscillation phenomenon.

Hardin, J. C.↗

NASA NTRS1977

Measurements of the tonal component of cavity noise and comparison with theory

The frequency of the tonal noise generated by a flow-excited rectangular cavity was measured using Mach numbers ranging from 0.05 to 0.40, and cavity length-to-depth ratios varying from 0.1 to 8. The data are used to evaluate a current prediction method, and good agreement is shown. Measurements of the minimum streamwise cavity length required for oscillation were also made.

Block, P. J. W.↗

NASA NTRS1977

An experimental investigation of airframe component interference noise

Measurements of noise produced by a model of a wheel well (rectangular cavity), landing gear (wheel and strut), and flap at Mach numbers of 0.18 and 0.40 have been made in an anechoic flow facility. Individual component noise and component interference noise are described in terms of the OASPL, spectra, and streamwise or flyover directivity patterns. Areas of significant sound generation are illuminated and causes of these noise sources are suggested. Results from an acoustic imaging technique are used to point out other source regions not discernible by simple far-field measurements.

Block, P. J. W.↗

NASA NTRS1976

Noise response of cavities of varying dimensions at subsonic speeds

An expression for the Strouhal number of lengthwise cavity oscillations is obtained which includes the effect of length-to-depth ratio. This expression, which agrees well with the experimental data, is also used to predict the Mach number at which cavity acoustic response is maximum. Interaction between lengthwise and depthwise modes is seen to occur at Mach numbers from 0.1 to 0.5. Cavity shape is shown to affect the noise spectra in generating either a broadband or narrowband signal.

Block, P. J. W.↗

NASA NTRS1976

An experimental study of the aeroacoustics of a subsonic jet impinging normal to a large rigid surface

This paper presents results from an experimental study of unsteady surface pressures and far-field noise produced by a subsonic jet impinging normal to a large, rigid, flat surface. The tests were performed in an anechoic room for jet Mach numbers from 0.54 to 0.85, and for jet-to-surface heights of from 5 to 10 jet diameters. Results showed that the root-mean-square surface pressure levels were proportional to jet dynamic pressure and were independent of jet height for radial distances from the stagnation point greater than 3 jet diameters. Far-field measurements indicated a significant increase in noise over that of a free jet for all cases of impingement. Cross spectral calculations between the surface and the far field suggested that at a Mach number of 0.70 and a height of 5 jet diameters the additional noise originated mainly in the outer edge of the impingement region between 1 and 3 jet diameters from the stagnation point.

Preisser, J. S.↗

NASA NTRS1975

Measurements of farfield sound generation from a flow-excited cavity

Results of 1/3-octave-band spectral measurements of internal pressures and the external acoustic field of a tangentially blown rectangular cavity are compared. Proposed mechanisms for sound generation are reviewed, and spectra and directivity plots of cavity noise are presented. Directivity plots show a slightly modified monopole pattern. Frequencies of cavity response are calculated using existing predictions and are compared with those obtained experimentally. The effect of modifying the upstream boundary layer on the noise was investigated, and its effectiveness was found to be a function of cavity geometry and flow velocity.

Block, P. J. W.↗