Search NASA⌕ Search

Engineering topics

Boettinger, W. J.

Publications and source records attributed to Boettinger, W. J..

Phase-field model for isothermal phase transitions in binary alloys

A new phase field model is described which models isothermal phase transitions between ideal binary alloy solution phases. Equations are developed for the temporal and spatial variation of the phase field, which describes the identity of the phase, and of the composition. An asymptotic analysis, as the gradient energy coefficient of the phase field becomes small, was conducted. From the analysis, it is shown that the model recovers classical sharp interface models of this situation when the interfacial layers are thin, and they show how to relate the parameters appearing in the phase field model to material and growth parameters in real systems. Further, three stages of temporal evolution are identified: the first corresponding to interfacial genesis which occurs very rapidly; the second to interfacial motion controlled by the local energy difference across the interface and diffusion; the last taking place on a long time scale in which curvature effects are important and which correspond to Ostwald ripening. The results of the numerical calculations are presented.

Wheeler, A. A.↗

The NBS: Processing/Microstructure/Property Relationships in 2024 Aluminum Alloy Plates

As received plates of 2024 aluminum alloy were examined. Topics covered include: solidification segregation studies; microsegregation and macrosegregation in laboratory and commercially cast ingots; C-curves and nondestructive evaluation; time-temperature precipitation diagrams and the relationships between mechanical properties and NDE measurements; transmission electron microscopy studies; the relationship between microstructure and properties; ultrasonic characterization; eddy-current conductivity characterization; the study of aging process by means of dynamic eddy current measurements; and Heat flow-property predictions, property degradations due to improve quench from the solution heat treatment temperature.

Ives, L. K.↗

Solutal convection induced macrosegregation and the dendrite to composite transition in off-eutectic alloys

The effect of solute gradient induced convection during vertical solidification on the macrosegregation of Pb-rich Pb-Sn off-eutectic alloys is determined experimentally as a function of composition and growth rate. In many cases macrosegregation is sufficient to prevent the plane front solidification of the alloy. The transition from dendritic to composite structure is found to occur when the composition of the solid is close enough to the eutectic composition to satisfy a stability criterion based on the ratio of the liquid temperature gradient to growth rate. A vertical or horizontal magnetic field of 0.1 T (1 kilogauss) does not reduce macrosegregation, but downward solidification (liquid below solid) virtually eliminates macrosegregation in small (3 mm) diameter samples.

Boettinger, W. J.↗

Effect of gravity on coupled convective and interfacial instabilities during directional solidification

Instabilities occurring during the directional constant-rate solidification of a dilute solution of tin in lead are investigated as a function of gravity with particular emphasis on small constant gravitational accelerations. Two types of instabilities have been identified: (1) convective type that corresponds to long wavelengths, and (2) morphological type that corresponds to short wavelengths. These instabilities are coupled but while the convective instabilities depend strongly on gravity, the morphological instabilities are practically independent of gravity. For low velocities, the convective instabilities occur at much lower solute concentrations than the morphological instabilities, whereas at high velocities the reverse is true.

Coriell, S. R.↗

X-ray topographic observations of magnetic domains in Czochralski-grown nickel single crystals in anomalous transmission geometry

The anomalous transmission effect has been observed in nickel single crystals grown by the Czochralski technique. Sample crystals prepared for X-ray topography are 1.5 to 2.5 cm in diameter and thicker than 0.4 mm; the product of the ordinary linear absorption coefficient and thickness ranges from 17 to 45 for Cu K-alpha radiation. Topographs taken with an asymmetric-crystal-topographic (ACT) camera have revealed extremely straight line images and rectangular arrangements of short line-segment images, along with the images of crystal imperfections. The line images change their arrangement upon application of magnetic fields. These images are attributed to magnetic domains in the interior of crystals. The formation of domain walls near the crystal surface is also observed and distinguished clearly from magnetic domains in the bulk with the use of the ACT camera.

Kuriyama, M.↗