Engineering topics

Bolton, John F.

Publications and source records attributed to Bolton, John F..

4 records

NASA NTRS1989

Extremely lightweight space telescope mirrors with integrated active figure control

A concept for an extremely lightweight primary mirror for a large space telescope is proposed. The mirror uses a sandwich structure composed of aluminum faceplates with an aluminum foam core. Modal analysis indicates that a fundamental frequency of 100 Hz can be obtained for a 6 meter diameter mirror with a tapered back and having a total mass of about 3500 kg. An array of thermal actuators embedded in the mirror corrects for figure errors. Such an active thermal figure control system does not have a quick response, but is well suited to space applications where disturbances have relatively long time constants. The advantage of thermal actuators is very high reliability, a primary concern in any space system requiring a large number of actuators.

Bely, Pierre Y.↗

NASA NTRS1987

The scatterometer for DIRBE

A scatterometer for monitoring the performance degradation of an infrared instrument in the Diffuse Infrared Background Experiment (DIRBE) due to contamination of the primary mirror is described. The scatterometer monitors the scattered light from an off-axis internal source to provide a measure of the integrity of the optical system. Preliminary results indicate that the measured BRDF of the primary mirror is two orders of magnitude worse than the specification, and thus may be unacceptable.

Bolton, John F.↗

NASA NTRS1987

Space ten-meter telescope (STMT) - Structural and thermal feasibility study of the primary mirror

The structural and thermal behavior of a ten-meter primary mirror for a space optical/near-IR telescope in geosynchronous orbit is studied. The glass-type lightweighted mirror is monolithic, of the double arch type, and is supported at only three points. The computer programs SSPTA (thermal), NASTRAN (finite element), and ACCOS V (optical) are used in sequence to determine the temperature, deformation, and optical performance of the mirror. A mirror temperature of 130 K or less appears to be obtainable by purely passive means. With a fused silica or standard Zerodur blank, thermally-induced deformation is unacceptable and cannot be fully corrected by an active secondary mirror over the desired field. Either active thermal control or a blank of lower thermal expansion coefficient would be required.

Bely, Pierre Y.↗

NASA NTRS1986

A technique for the optical analysis of deformed telescope mirrors

The NASTRAN-ACCOS V programs' interface merges structural and optical analysis capabilities in order to characterize the performance of the NASA Goddard Space Flight Center's Solar Optical Telescope primary mirror, which has a large diameter/thickness ratio. The first step in the optical analysis is to use NASTRAN's FEM to model the primary mirror, simulating any distortions due to gravitation, thermal gradients, and coefficient of thermal expansion nonuniformities. NASTRAN outputs are then converted into an ACCOS V-acceptable form; ACCOS V generates the deformed optical surface on the basis of these inputs, and imaging qualities can be determined.

Bolton, John F.↗