Engineering topics

Bowers, W. D.

Publications and source records attributed to Bowers, W. D..

3 records

NASA NTRS1992

Field-Domain Ion Spectrometry

Field-domain ion spectrometry (FDIS) is variant of established technique known as ion-mobility spectrometry. Operates at atmospheric pressure and only requires small pump to draw air sample into instrument. Strength of retarding electric field varied to distinguish among ions of different mobilities. New concept offers potential for development of small, (hand-held), low-power, portable devices detecting airborne chemical substances in real-time at concentrations at parts-per-billion level.

Bowers, W. D.↗

NASA NTRS1991

A 200 MHz surface acoustic wave resonator mass microbalance

The development of a 200 MHz SAW instrument based on an SAW resonator instead of a conventional delay line is reported. The instrument is small, compact, and uses two separate 200 MHz resonataor crystals which operate in the dual difference mode. The difference frequency stability is better than 5 x 10 to the -9th (+ or - 1 Hz) which is comparable to a 10 MHz bulk crystal and at least an order of magnitude better than other commercially available SAW delay lines that operate at comparable frequencies. The mass sensitivity is about 9 x 10 to the 10th Hz sq cm/g. Response to temperature change is found to be about 20 Hz/C from -30 C to 30 C. Response to pressure is found to be linear from 760 to 415 Torr at 3 Hz/Torr. Detection limits for HCl vapors were determined to be in the low ppb range using an SAW resonator coated with triethanolamine.

Bowers, W. D.↗

NASA NTRS1989

Surface acoustic-wave piezoelectric crystal aerosol mass microbalance

The development of a particulate mass-sensing instrument based on a quartz-crystal microbalance and enhanced with the new surface acoustic-wave (SAW) technology is reported. Mass sensitivity comparisons of a 158-MHz SAW piezoelectric microbalance and a conventional 10-MHz quartz-crystal microbalance show that the SAW crystal is 266 times more sensitive, in good agreement with the theoretical value of 250. The frequency stability of a single SAW resonator is 6 parts in 10 to the 8th over 1 min. The response to temperature changes is found to be very linear over the range +30 to -30 C. A strong response to 15 ppm SO2 has been demonstrated on a chemically coated SAW crystal.

Bowers, W. D.↗