Engineering topics

Boyden, R. P.

Publications and source records attributed to Boyden, R. P..

At least 19 records

NASA NTRS1995

Buffeting tests in a cryogenic windtunnel

Measurements of wing buffeting, using root strain gages, were made in the NASA Langley 0.3 m cryogenic wind tunnel to refine techniques which will be used in larger cryogenic facilities such as the United States National Transonic Facility (NTF) and the European Transonic Wind Tunnel (ETW). The questions addressed included the relative importance variations in frequency parameter and Reynolds number, the choice of model material (considering both stiffness and damping) and the effects of static aeroelastic distortion. The main series of tests was made on three half models of slender 65 deg delta wings with a sharp leading edge. The three delta wings had the same planform but widely differing bending stiffnesses and frequencies (obtained by varying both the material and the thickness of the wings). It was known that the steady flow on this configuration would be insensitive to variations in Reynolds number. On this wing at vortex breakdown the spectrum of the unsteady excitation is unusual, having a sharp peak at particular frequency parameter. Additional tests were made on one unswept half-wing of aspect ratio 1.5 with an NPL 9510 aerofoil section, known to be sensitive to variations in Reynolds number at transonic speeds. The test Mach numbers were M = 0.21 and 0.35 for the delta wings and to M = 0.30 for the unswept wing. On this wing the unsteady excitation spectrum is fairly flat (as on most wings). Hence correct representation of the frequency parameter is not particularly important.

Mabey, D. G.↗

NASA NTRS1994

Dynamic Stability Instrumentation System (DSIS). Volume 1: Hardware description

This paper is a hardware description manual for the Dynamic Stability Instrumentation System that is used in specific NASA Langley wind tunnels. The instrumentation system performs either a synchronous demodulation or a fast Fourier transform on dynamic balance strain gage signals, and ultimately computes aerodynamic coefficients. The DSIS consists of a double rack of instruments, a remote motor-generator set, two special stings each with motor driven shafts, and specially designed balances. The major components in the instrumentation rack include a personal computer, digital signal processor microcomputers, computer-controlled signal conditioners, function generator, digital multimeter, and an optional fast Fourier transform analyzer.

Jordan, T. L.↗

NASA NTRS1992

Further buffeting tests in a cryogenic wind tunnel

Further measurements of buffeting, using wing-root strain gauges, were made in the NASA Langley 0.3 m Cryogenic Wind Tunnel to refine techniques which will be used in larger cryogenic facilities such as the United States National Transonic Facility (NTF) and European Transonic Wind Tunnel (ETW). The questions addressed included the relative importance of variations in frequency parameter and Reynolds number, the choice of model material (considering both stiffness and damping) and the effects of static aeroelastic distortion. The main series of tests was made on half models of slender 65 deg delta wings with a sharp leading edge. The three delta wings had the same planform but widely different bending stiffness and frequencies (obtained by varying both the material and the thickness of the wings). It was known that the flow on this configuration would be insensitive to variations in Reynold number. Additional tests were made on one unswept half-wing of aspect ratio 1.5 with an NPL 9510 aerofoil section, known to be sensitive to variations in Reynolds number at transonic speeds. For brevity the test Mach numbers were restricted to M = 0.21 and 0.35 for the delta wings and to M = 0.30 for the unswept wing.

Mabey, D. G.↗

NASA NTRS1985

Status of wind tunnel magnetic suspension research

This paper reports the status of the NASA Langley Research Center program aimed at the development of the technology required for large-scale Magnetic Suspension and Balance Systems. The use of magnetic suspension of the model in a wind tunnel is seen to be the only viable method to eliminate aerodynamic interference problems arising with mechanical model-supports. The two small-scale magnetic suspension systems in operation at Langley are the only ones now active in the U.S. The general features and capabilities of these two systems and all of the ongoing research in the use of magnetic suspension are described.

Boyden, R. P.↗

NASA NTRS1983

Aerodynamic force measurements with a strain-gage balance in a cryogenic wind tunnel

Aerodynamic force measurements on a generalized 75 deg delta wing model with sharp leading edges were made with a three component internal strain gage balance in a cryogenic wind tunnel at stagnation temperatures of 300 K, 200 K, and 110 K. The feasibility of using a strain gage balance without thermal control in a cryogenic environment as well as the use of electrical resistance heaters, an insulator between the model and the balance, and a convection shield on the balance was investigated. Force and moment data on the delta wing model as measured by the balance are compared at the different temperatures while holding constant either the Reynolds number or the tunnel stagnation pressure. Tests were made at Mach numbers of 0.3 and 0.5 and at angles of attack up to 29 deg. The results indicate that it is feasible to acquire accurate force and moment data while operating at steady state thermal conditions in a cryogenic wind tunnel, either with or without electrical heaters on the balance. Within the limits of the balance accuracy, there were no apparent Reynolds number effects on the aerodynamic results for the delta wind model.

Boyden, R. P.↗

NASA NTRS1982

Results of buffet tests in a cryogenic wind tunnel

Buffet tests on two semispan wing models with different leading edge sweep show that it is feasibile to use the standard dynamic wing root bending moment technique in a cryogenic wind tunnel. One model was a slender 65 deg swept delta wing with sharp leading edges. The other model was an unswept wing of aspect ratio 1.5 with a British NPL 9510 airfoil section. The results for the 65 deg swept delta wing indicate the importance of matching the reduced frequency parameter in model tests for planforms which are sensitive to reduced frequency parameter if quantitative buffet measurements are required. The unique ability of a pressurized cryogenic wind tunnel to separate the effects of Reynolds number and of static aeroelastic distortion by variations in the tunnel stagnation temperature and pressure were demonstrated.

Boyden, R. P.↗

NASA NTRS1981

The development of cryogenic wind tunnels and their application to maneuvering aircraft technology

Cryogenic wind tunnels are considered as a means of studying high Reynolds number (Re) complicated flows encountered by high maneuvering lift and high angles of attack characteristic of modern fighter aircraft. Large decreases in the viscous force while the inertial force remains constant are provided by the use of cryogenic facilities. A 2.5 m square tunnel is nearing completion at the National Transonic Facility (NTF), and will be driven by synchronous motors having a total power of 120,000 hp. The tunnel, using N2 as the cryogenic fluid, will allow large Re sweeps at constant dynamic pressure and dynamic pressure, and aeroelastic sweeps at constant Re; full altitude (air density) and acceleration force simulation will also be possible. Advances in model and strain gage balance technologies for use at the NTF are outlined, and experiments with buffet are described.

Polhamus, E. C.↗

NASA NTRS1981

Preliminary results of buffet tests in a cryogenic wind tunnel

Buffet tests of two wings with different leading-edge sweep show that it is feasible to use the standards wing root bending moment technique in a cryogenic wing tunnel. The results for the 65 deg sweep delta wing indicate the importance of matching the reduced frequency parameter in model tests for planforms which are sensitive to reduced frequency parameter if quantitative buffet measurements are required. The unique ability of a pressurized cryogenic wind tunnel to separate the effects of Reynolds number and of aeroelastic distortion by variations in the tunnel stagnation temperature and pressure was demonstrated.

Boyden, R. P.↗

NASA NTRS1978

Subsonic dynamic stability characteristics of two close-coupled canard-wing configurations

The pitch, yaw, and roll damping, as well as the oscillatory stability in pitch and in yaw, were measured for two canard wing configurations with wing sweeps of 44 deg and 60 deg. Tests were made at free stream Mach numbers of 0.3, 0.4, and 0.7 and for angles of attack from about -4 deg to 20 deg. The effects of various components such as the canard, nose strakes, wings, vertical tail, and horizontal tail were determined. The basic canard wing, vertical tail configurations generally had positive damping in pitch, yaw, and roll. The effect of the canard was generally beneficial except for its tendency to decrease the oscillatory directional stability.

Boyden, R. P.↗

NASA NTRS1978

Transonic static and dynamic stability characteristics of a finned projectile configuration

Static and dynamic stability tests were made of a finned projectile configuration with the aft-mounted fins arranged in a cruciform pattern. The tests were made at free stream Mach numbers of 0.7, 0.9, 1.1, and 1.2 in the Langley 8-foot transonic pressure tunnel. Some of the parameters measured during the tests were lift, drag, pitching moment, pitch damping, and roll damping. Configurations tested included the body with undeflected fins, the body with various fin deflections for control, and the body with fins removed. Theoretical estimates of the stability derivatives were made for the fins on configuration.

Boyden, R. P.↗

NASA NTRS1978

Subsonic roll damping of a model with swept-back and swept-forward wings

The aerodynamic roll damping and the yawing moment due to roll rate characteristics were investigated at subsonic speeds for a model with either sweptback or swept forward wings. The tests were made in the Langley high speed 7 by 10 foot tunnel for Mach numbers between 0.3 and 0.7. The configuration with a 60 deg sweptback wing had positive damping in roll up to the maximum test angle of attack of almost 20 deg. The 32 deg swept forward wing configuration had positive damping in roll at the lower angles of attack, but there was a decrease in damping and negative damping in roll was measured at the highest angles of attack.

Boyden, R. P.↗

NASA NTRS1977

Dynamic stability characteristics of the combination space shuttle orbiter and ferry vehicle

Subsonic forced-oscillation tests of a 0.015 scale model of the space shuttle orbiter/747 ferry vehicle were conducted in the Langley high speed 7- by 10-foot tunnel at Mach numbers of 0.2, 0.4, and 0.5 for angles of attack up to 12 deg. Tests were made of the basic 747 airplane, of the modified 747 (tip fins and struts added), of the ferry configuration, (747 plus orbiter at an incidence angle of 3 deg), and of the approach and landing test configuration (747 plus orbiter at an incidence angle of 6 deg).

Freeman, D. C., Jr.↗

NASA NTRS1976

Subsonic and transonic dynamic stability characteristics of the space shuttle launch vehicle

An investigation has been conducted to determine the subsonic and transonic dynamic stability characteristics of a 0.015 scale model of the space shuttle launch vehicle. These tests were conducted in the Langley 8-foot transonic pressure tunnel over a Mach number range from 0.3 to 1.2. Forced oscillation equipment was used to determine the damping characteristics of several configurations about all three axes. The test results show that the model exhibited positive damping in pitch except at the highest Mach number (1.2) where there was a region of negative damping at 2 deg angle of attack. The yawing oscillation tests show that the model exhibited nonlinearities and negative damping at Mach numbers of 0.3 and 0.6. The model exhibited positive roll damping throughout the test angle of attack and Mach range.

Freeman, D. C., Jr.↗

NASA NTRS1976

Supersonic dynamic-stability derivatives of the space shuttle launch vehicle

An investigation was made to determine the dynamic stability characteristics of a 0.015-scale model of the space shuttle launch vehicle at supersonic speeds. These tests were made at angles of attack from -10 deg to 10 deg at Mach numbers of 2.00, 2.86, 3.96, and 4.63. The complete launch vehicle, consisting of the orbiter, external tank, and solid rocket boosters, has positive damping in pitch, roll, and yaw over the angle-of-attack and Mach number range. The orbiter external tank configuration has a region of negative angles pitch damping for small negative of attack at a Mach number of 2.00. At all other test conditions, the orbiter external tank configuration has positive damping about all three axes.

Boyden, R. P.↗

NASA NTRS1976

Supersonic dynamic stability characteristics of a space shuttle orbiter

Supersonic forced-oscillation tests of a 0.0165-scale model of a modified 089B Rockwell International shuttle orbiter were conducted in a wind tunnel for several configurations over a Mach range from 1.6 to 4.63. The tests covered angles of attack up to 30 deg. The period and damping of the basic unaugmented vehicle were calculated along the entry trajectory using the measured damping results. Some parameter analysis was made with the measured dynamic derivatives. Photographs of the test configurations and test equipment are shown.

Freeman, D. C., Jr.↗

NASA NTRS1975

Subsonic and transonic dynamic stability characteristics of a space shuttle orbiter

Subsonic and transonic forced oscillation tests of a 0.0165-scale model of a modified 089B space shuttle orbiter were made in the Langley 8-foot transonic pressure tunnel. The period and damping of the basic unaugmented vehicle were calculated along the entry trajectory utilizing these measured dynamic data. Some parameter analyses were made with the measured dynamic derivatives.

Boyden, R. P.↗

NASA NTRS1975

Experimental pitch-, yaw-, and roll-damping characteristics of a shuttle orbiter at Mach number 8

Wind tunnel tests were conducted to measure the pitch-, yaw-, and roll-damping characteristics of a modified 089B shuttle orbiter. These tests were conducted for NASA-Langley at the von Karman Gas Dynamics Facility of the Arnold Engineering Development Center. Data were obtained utilizing the small amplitude forced-oscillation technique at angles of attack of -4.9 to 26.5 deg at Reynolds numbers, based on model length, of 1,180,000 to 4,820,000. The orbiter was dynamically stable in pitch, yaw, and roll, and the pitch derivatives were dependent on Reynolds number, while the roll derivatives were independent of Reynolds number.

Uselton, B. L.↗

NASA NTRS1974

Aerodynamic roll damping of a T-tail transport configuration

The aerodynamic roll damping and the yawing moment due to roll rate for a model of a T-tail transport with aft-mounted engines were measured by means of a small-amplitude forced-oscillation mechanism. The tests were made for Mach numbers between 0.21 and 0.80 over a range of angles of attack from about minus 4 deg to 22 deg. The basic configuration had positive damping in roll at low angles of attack with regions of low positive and negative damping for angles of attack above 8 deg to 10 deg. There was good agreement between the theoretical estimates of the roll damping for the wing alone and the experimental results at an angle of attack of 0 deg for Mach numbers of 0.60 and less. The T-tail configuration and the engine nacelles mounted aft on the fuselage did not significantly affect either the damping in roll or the yawing moment due to roll rate.

Boyden, R. P.↗