Search NASA⌕ Search

Engineering topics

Bradford, R.

Publications and source records attributed to Bradford, R..

200 mm sensor development using bonded wafers

Sensors fabricated from high resistivity, float zone, silicon material have been the basis of vertex detectors and trackers for the last 30 years. The areas of these devices have increased from a few square cm to > 200m 2 for the existing CMS tracker. High Luminosity Large Hadron Collider (HL-LHC), CMS and ATLAS tracker upgrades will each require more than 200 m 2 of silicon and the CMS High Granularity Calorimeter (HGCAL) will require more than 600 m 2 . The cost and complexity of assembly of these devices is related to the area of each module, which in turn is set by the size of the silicon sensors. In addition to large area, the devices must be radiation hard, which requires the use of sensors thinned to 200 microns or less. The combination of wafer thinning and large wafer diameter is a significant technical challenge, and is the subject of this work. In this paper we describe work on development of thin sensors on 200 mm wafers using wafer bonding technology. Results of development runs with float zone, Silicon-on-Insulator and Silicon-Silicon bonded wafer technologies are reported.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Measurements of Nonsinglet Moments of the Nucleon Structure Functions and Comparison to Predictions from Lattice QCD for Q 2 = 4 GeV 2

We present extractions of the nucleon non-singlet moments utilizing new precision data on the deuteron F 2 structure function at large Bjorken-x determined via the Rosenbluth separation technique at Jefferson Lab Experimental Hall C. These new data are combined with a complementary set of data on the proton previously measured in Hall C at similar kinematics and world data sets on the proton and deuteron at lower x measured at SLAC and CERN. The new Jefferson Lab data provide coverage of the upper third of the x range, crucial for precision determination of the higher moments. In contrast to previous extractions, these moments have been corrected for nuclear effects in the deuteron using a new global fit to the deuteron and proton data. The obtained experimental moments represent an order of magnitude improvement in precision over previous extractions using high x data. Furthermore, recent exciting developments in Lattice QCD calculations provide a first ever comparison of these new experimental results with calculations of moments carried out at the physical pion mass, as well as an innovative approach which first calculates the quark distributions directly before determining moments.

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Measurement of Muon Antineutrino Quasielastic Scattering on a Hydrocarbon Target at E ν ~3.5 GeV

We have isolated ν¯ μ charged-current quasielastic (QE) interactions occurring in the segmented scintillator tracking region of the MINERvA detector running in the NuMI neutrino beam at Fermilab. We measure the flux-averaged differential cross section, dσ/dQ², and compare to several theoretical models of QE scattering. Good agreement is obtained with a model where the nucleon axial mass, M A , is set to 0.99 GeV/c² but the nucleon vector form factors are modified to account for the observed enhancement, relative to the free nucleon case, of the cross section for the exchange of transversely polarized photons in electron-nucleus scattering. Our data at higher Q² favor this interpretation over an alternative in which the axial mass is increased.

Fields, L.↗

Measurement of Muon Neutrino Quasielastic Scattering on a Hydrocarbon Target at E ν ~3.5 GeV

We report a study of ν μ charged-current quasielastic events in the segmented scintillator inner tracker of the MINERvA experiment running in the NuMI neutrino beam at Fermilab. The events were selected by requiring a μ⁻ and low calorimetric recoil energy separated from the interaction vertex. We measure the flux-averaged differential cross section, dσ/dQ², and study the low energy particle content of the final state. Deviations are found between the measured dσ/dQ² and the expectations of a model of independent nucleons in a relativistic Fermi gas. We also observe an excess of energy near the vertex consistent with multiple protons in the final state.

Fiorentini, G. A.↗

Coal conversion and synthetic-fuel production

Report evaluates potential coal gasification and synthetic-fuel production technologies for 1985 to 1990. Book includes overview of present and future technical and economic potential, ways of evaluating gasification facility designs, discussion of promising processes, characterization of potential markets, and list of available gasification systems.

Bradford, R.↗

Advanced technology applications for second and third general coal gasification systems

The historical background of coal conversion is reviewed and the programmatic status (operational, construction, design, proposed) of coal gasification processes is tabulated for both commercial and demonstration projects as well as for large and small pilot plants. Both second and third generation processes typically operate at higher temperatures and pressures than first generation methods. Much of the equipment that has been tested has failed. The most difficult problems are in process control. The mechanics of three-phase flow are not fully understood. Companies participating in coal conversion projects are ordering duplicates of failure prone units. No real solutions to any of the significant problems in technology development have been developed in recent years.

Bradford, R.↗

Space industrialization studies - An overview

An overview of NASA's current planning for a space industrialization program is described as an introduction to the papers on Space Industrialization being presented by Rockwell International Corporation and Science Applications Incorporated. Background information is presented that outlines the integrated planning process which resulted in specific long range goals and objectives being formulated for NASA programs in technology, environment, resources, earth science, communications, space exploration, aeronautics, and an expanded application of space called space industrialization. Program objectives for NASA's Industrialization of Space and studies on potential near term supporting elements (Space Platform, Large Space Structures, Orbital Operations Capabilities Development, Space Manufacturing Module) are discussed.

Priest, C.↗