Search NASA⌕ Search

Engineering topics

Branstetter, J. R.

Publications and source records attributed to Branstetter, J. R..

18 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

B-737 flight test of curved-path and steep-angle approaches using MLS guidance

A series of flight tests were conducted to collect data for jet transport aircraft flying curved-path and steep-angle approaches using Microwave Landing System (MLS) guidance. During the test, 432 approaches comprising seven different curved-paths and four glidepath angles varying from 3 to 4 degrees were flown in NASA Langley's Boeing 737 aircraft (Transport Systems Research Vehicle) using an MLS ground station at the NASA Wallops Flight Facility. Subject pilots from Piedmont Airlines flew the approaches using conventional cockpit instrumentation (flight director and Horizontal Situation Indicator (HSI). The data collected will be used by FAA procedures specialists to develop standards and criteria for designing MLS terminal approach procedures (TERPS). The use of flight simulation techniques greatly aided the preliminary stages of approach development work and saved a significant amount of costly flight time. This report is intended to complement a data report to be issued by the FAA Office of Aviation Standards which will contain all detailed data analysis and statistics.

Branstetter, J. R.↗
NASA NTRS1986

Use of flight simulation to develop terminal instrument procedures for transport category aircraft

In a collaborative effort between the FAA and NASA, a simulation was conducted to look at the issues involved with flying a large, widebody aircraft in the terminal area using MLS-RNAV procedures. A variety of approach paths, departure paths, and holding patterns were investigated during the course of the study, which included the participation of subject pilots. The simulation made use of paths designed by the FAA Office of Aviation Standards and employed Langley's Visual Motion Simulator (VMS) for their execution. Data obtained from this simulation will be used to support the joint FAA/USAF MLS flight test and demonstration project. This paper describes the flight simulation facility adapted to model terminal area maneuvers for jet transport aircraft using the Microwave Landing System (MLS). A description of the overall project will be presented first, along with a discussion of the guidance schemes used, followed by a description of the simulation hardware and software. A sample of the resulting data will also be presented.

Branstetter, J. R.↗
NASA NTRS1984

An investigation of the existence of a surface water layer on aircraft radomes during simulated flight in heavy precipitation

An experiment to investigate the electromagnetic attenuation effects of an impacting water spray on an aircraft weather radome was conducted in Langley's 4 X 7 m. wind tunnel equipped with a water spray system. Results indicate no significant liquid water film formed at the stagnation point of the radome under the test conditions. However, a water sheath was observed standing away from the radome surface, which could possibly have significant attenuation properties of its own. Due to the lack of fidelity in modeling both the natural environment with the tunnel apparatus and the water sheath, it is recommended that further studies be undertaken to better define the water distribution in the vicinity of the radome and measure its effect on weather radar performance.

Branstetter, J. R.↗
NASA NTRS1973

Spontaneous ignition in afterburner segment tests at an inlet temperature of 1240 K and a pressure of 1 atmosphere with ASTM jet-A fuel

A brief testing program was undertaken to determine if spontaneous ignition and stable combustion could be obtained in a jet engine afterburning operating with an inlet temperature of 1240 K and a pressure of 1 atmosphere with ASTM Jet-A fuel. Spontaneous ignition with 100-percent combustion efficiency and stable burning was obtained using water-cooled fuel spraybars as flameholders.

Schultz, D. F.↗
NASA NTRS1973

Afterburner performance of film-vaporizing V-gutters for inlet temperatures up to 1255 K

Combustion tests of five variations of an integral, spray-bar - flameholder combination were conducted in a 0.49-m-diameter duct. Emphasis was on low levels of augmentation. Fuel impinged on guide plates, mixed with a controlled amount of inlet air, vaporized, and was guided into the V-gutter wake. Combustor length was 0.92 m. Good performance was demonstrated at fuel-air ratios less than 0.025 for inlet temperatures of 920 to 1255 K. Maximum combustion efficiency occured in the vicinity of fuel-air ratios of 0.02 and was 92 to 100 percent, depending on the inlet temperature. Lean blowout fuel-air ratios were in the vicinity of 0.005. Improvements in rich-limit blowout resulted from enlarging the guide-flow passageway areas. Other means of extending the operating range are suggested. A simplified afterburner concept for application to advanced engines is described.

Branstetter, J. R.↗
NASA NTRS1958

Experimental Behavior of Pentaborane-Air Combustion Products During Expansion in a Convergent Divergent Nozzle

In order to evaluate the post combustion behavior of boric oxide, pentaborane-air mixtures, burned to completion at a combustor pressure of 3 atmospheres, were expanded through a 7.1-inch-long convergent-divergent nozzle having a 4-inch-diameter throat and an exit-to-throat area ratio of 1.68. The experimentally determined thrust performance was in good agreement with the ideal equilibrium performance at stagnation temperatures of 3300 deg R and lower. The boric oxide vapor at the combustor exit required about 400 F deg supercooling before any condensed phase was observed. For a given thrust, fuel consumption was as much as 20 percent greater than predicted from vapor-pressure data for combustor outlet temperatures i n the vicinity of 3600 deg R. A similar result could be expected in full-scale engines, since the test combustor provided an unusually long dwell time and a highly turbulent environment. During the expansion process, the vapor (when present) did not condense to the extent predicted for an equilibrium expansion process. Moreover, condensation was observed only i n the form of small, abrupt phase changes i n the subsonic flow near the throat. Friction, due to liquid boric oxide films on the nozzle surfaces, was negligible when the surface temperature was above 800 F.

PENTABORANE↗