Search NASA⌕ Search

Engineering topics

Brar, Victor W.

Publications and source records attributed to Brar, Victor W..

9 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

Enhancing two-photon spontaneous emission in rare earths using graphene and graphene nanoribbons

The enhancement of two-photon spontaneous emission (2PSE) from trivalent and divalent rare earth ions in proximity to graphene and graphene nanoribbons is calculated for achievable experimental conditions using a combination of finite difference time domain simulations and direct computation of transition rates between energy levels in rare earths. For Er 3+ , we find that the 2PSE rate is initially 8 orders lower than the single-photon spontaneous emission rate but that, with enhancement, 2PSE can reach 2.5% of the overall decay. When graphene nanoribbons are used, we also show that the emission of free-space photon pairs from Er 3+ at 3–3.2 μ⁢m via 2PSE can be increased by ~400. Our calculations show significantly less relative graphene-enhanced 2PSE than previous works, and we attribute this variation to differences in emitter size and assumed graphene mobility. Here, we also show that the internal energy structure of the ion can have an impact on the degree of 2PSE enhancement achievable and find that divalent rare earths are more favorable.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2023

Thickness-Dependent Cross-Plane Thermal Conductivity Measurements of Exfoliated Hexagonal Boron Nitride

Submicrometer-thick layers of hexagonal boron nitride (hBN) exhibit high in-plane thermal conductivity and useful optical properties, and serve as dielectric encapsulation layers with low electrostatic inhomogeneity for graphene devices. Despite the promising applications of hBN as a heat spreader, the thickness dependence of its cross-plane thermal conductivity is not known, and the cross-plane phonon mean free paths (MFPs) have not been measured. We measure the cross-plane thermal conductivity of hBN flakes exfoliated from bulk crystals. We find that submicrometer thick flakes exhibit thermal conductivities up to 8.1 ± 0.5 W m –1 K –1 at 295 K, which exceeds previously reported bulk values by more than 60%. Surprisingly, the average phonon mean free path is found to be several hundred nanometers at room temperature, a factor of 5 larger than previous predictions. When planar twist interfaces are introduced into the crystal by mechanically stacking multiple thin flakes, the cross-plane thermal conductivity of the stack is found to be a factor of 7 below that of individual flakes with similar total thickness, thus providing strong evidence that phonon scattering at twist boundaries limits the maximum phonon MFPs. These results have important implications for hBN integration in nanoelectronics and improve our understanding of thermal transport in twodimensional materials.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Imaging the breaking of electrostatic dams in graphene for ballistic and viscous fluids

The charge carriers in a material can, under special circumstances, behave as a viscous fluid. Here, in this work, we investigated such behavior by using scanning tunneling potentiometry to probe the nanometer-scale flow of electron fluids in graphene as they pass through channels defined by smooth and tunable in-plane p-n junction barriers. We observed that as the sample temperature and channel widths are increased, the electron fluid flow undergoes a Knudsen-to-Gurzhi transition from the ballistic to the viscous regime characterized by a channel conductance that exceeds the ballistic limit, as well as suppressed charge accumulation against the barriers. Our results are well modeled by finite element simulations of two-dimensional viscous current flow, and they illustrate how Fermi liquid flow evolves with carrier density, channel width, and temperature.

Science & Technology - Other Topics↗
DOE OSTI2021

A simple numerical method for evaluating heat dissipation from curved wires with periodic applied heating

In many situations, the dual-purpose heater/thermometer wires used in the three-omega method – one of the most precise and sensitive techniques for measuring the thermal conductivity of thin films and interfaces – must include bends and curves to avoid obstructions on the surface of a sample. Although the three-omega analysis assumes that the heating wire is infinitely long and straight, recent experimental work has demonstrated that in some cases curved-wire geometries can be used without introducing detectable systematic error. We describe a general numerical method that can be used to calculate the temperature of three-omega heating wires with arbitrary wire geometries. Furthermore, this method provides experimentalists with a simple quantitative procedure for calculating how large the systematic error caused by a particular wire asymmetry will be. We show calculations of two useful cases: a straight wire with a single bend of arbitrary angle and a wire that forms a circle. We find that the amplitude of the in-phase temperature oscillations near a wire that forms a circle differs from the prediction using the analytic straight-line source solution by <12%, provided that the thermal penetration depth is less than ten times the radius of curvature of the wire path. The in-phase temperature amplitude 1.5 wire widths away from a 90° bend in a wire is within 11% of the straight-line source prediction for all penetration depths greater than the wire width. Our calculations indicate that the straight-line source solution breaks down significantly when the wire bend angle is less than 45°.

77 NANOSCIENCE AND NANOTECHNOLOGY↗
DOE OSTI2020

Three-omega thermal-conductivity measurements with curved heater geometries

The three-omega method, a powerful technique to measure the thermal conductivity of nanometer-thick films and the interfaces between them, has historically employed straight conductive wires to act as both heaters and thermometers. When investigating stochastically prepared samples such as two-dimensional materials and nanomembranes, residue and excess material can make it difficult to fit the required millimeter-long straight wire on the sample surface. There are currently no available criteria for how diverting three-omega heater wires around obstacles affects the validity of the thermal measurement. In this Letter, we quantify the effect of the wire curvature by performing three-omega experiments with a wide range of frequencies using both curved and straight heater geometries on SiO 2 /Si samples. When the heating wire is curved, we find that the measured Si substrate thermal conductivity changes by only 0.2%. Similarly, we find that wire curvature has no significant effect on the determination of the thermal resistance of an ~65 nm SiO 2 layer, even for the sharpest corners considered here, for which the largest measured ratio of the thermal penetration depth of the applied thermal wave to radius of curvature of the heating wire is 4.3. This result provides useful design criteria for three-omega experiments by setting a lower bound for the maximum ratio of the thermal penetration depth to wire radius of curvature.

77 NANOSCIENCE AND NANOTECHNOLOGY↗
DOE OSTI2020

Semi-adsorption-controlled growth window for half-Heusler FeVSb epitaxial films

The electronic, magnetic, thermoelectric, and topological properties of Heusler compounds (composition XYZ or X 2 YZ) are highly sensitive to stoichiometry and defects. Here we establish the existence and experimentally map the bounds of a semi-adsorption-controlled growth window for semiconducting half-Heusler FeVSb films, grown by molecular beam epitaxy (MBE). We show that due to the high volatility of Sb, the Sb stoichiometry is self-limiting for a finite range of growth temperatures and Sb fluxes, similar to the growth of III-V semiconductors such as GaSb and GaAs. Films grown within this window are nearly structurally indistinguishable by x-ray diffraction (XRD) and reflection high energy electron diffraction (RHEED). Here, the highest electron mobility and lowest background carrier density are obtained towards the Sb-rich bound of the window, suggesting that Sb vacancies may be a common defect. Similar semi-adsorption-controlled bounds are expected for other ternary intermetallics that contain a volatile species Z = {Sb, As, Bi}, e.g., CoTiSb, LuPtSb, GdPtBi, and NiMnSb. However, outstanding challenges remain in controlling the remaining Fe/V (X/Y) transition metal stoichiometry.

36 MATERIALS SCIENCE↗