Search NASASearch

Engineering topics

Brenner, A.

Publications and source records attributed to Brenner, A..

ICESat's Laser Measurements of Polar Ice, Atmosphere, Ocean, and Land

The Ice, Cloud and Land Elevation Satellite (ICESat) mission will measure changes in elevation of the Greenland and Antarctic ice sheets as part of NASA's Earth Observing System (EOS) of satellites. Time-series of elevation changes will enable determination of the present-day mass balance of the ice sheets, study of associations between observed ice changes and polar climate, and estimation of the present and future contributions of the ice sheets to global sea level rise. Other scientific objectives of ICESat include: global measurements of cloud heights and the vertical structure of clouds and aerosols; precise measurements of land topography and vegetation canopy heights; and measurements of sea ice roughness, sea ice thickness, ocean surface elevations, and surface reflectivity. The Geoscience Laser Altimeter System (GLAS) on ICESat has a 1064 nm laser channel for surface altimetry and dense cloud heights and a 532 nm lidar channel for the vertical distribution of clouds and aerosols. The accuracy of surface ranging is 10 cm, averaged over 60 m diameter laser footprints spaced at 172 m along-track. The orbital altitude will be around 600 km at an inclination of 94 deg with a 183-day repeat pattern. The onboard GPS receiver will enable radial orbit determinations to better than 5 cm, and star-trackers will enable footprints to be located to 6 m horizontally. The spacecraft attitude will be controlled to point the laser beam to within +/- 35 m of reference surface tracks at high latitudes. ICESat is designed to operate for 3 to 5 years and should be followed by successive missions to measure ice changes for at least 15 years.

Zwally, H. J.

Comparison of radar-altimetry data over Greenland with surface topography derived from airborne laser altimetry

During the Summers of 1991, 1992, and 1993, NASA flew a scanning laser altimeter over transects of the Greenland ice sheet. Airplane location was measured precisely using differential Global Positioning System (GPS) surveying techniques. This allowed all altimetry data to be reduced to an estimate of ice surface elevations relative to the Earth ellipsoid. Repeat flights over the same areas indicate data consistency to 10 to 20 cm. Many of the aircraft flights were made along the ERS-1 'radar-altimeter footprint track' for a commissioning phase orbit. Rigorous comparison between the ERS-1 altimeter measurements and those from the laser altimeter will require analysis of individual ERS-1 altimeter waveforms, and since the information needed to do this is not yet available, results from comparison of TOPEX (Topology Ocean Experiment) Poseidon (T/P) radar altimetry data with laser data obtained at the northernmost limit of the T/P orbits are presented.

Thomas, R. H.

Global mean sea surface computation based upon a combination of SEASAT and GEOS-3 satellite altimeter data

A mean sea surface map was computed for the global ocean areas between 70 deg N latitude and 62 deg S latitude based upon the 70 day SEASAT and 3.5 year GEOS-3 altimeter data sets. The mean sea surface is presented in the form of a global contour map and a 0.25 deg x 0.25 deg grid. A combination of regional adjustments based upon crossover techniques and the subsequent adjustment of the regional solutions into a global reference system was employed in order to minimize the effects of radial orbit error. A global map of the crossover residuals after the crossover adjustments are made is in good agreement with earlier mesoscale variability contour maps based upon the last month of SEASAT collinear data. This high level of agreement provides good evidence that relative orbit error was removed to the decimeter level on a regional basis. This represents a significant improvement over our previous maps which contained patterns, particularly in the central Pacific, which were due to radial orbit error. Long wavelength, basin scale errors are still present with a submeter amplitude due to errors in the PGS-S4 gravity model. Such errors can only be removed through the improvement of the Earth's gravity model and associated geodetic parameters.

Marsh, J. G.

Electrodeless electrolysis

Electrodeless electrolysis of solid ionic conductors and fused salts without contact leads, using electron beams and glow discharge

Brenner, A.