Engineering topics

Brenner, A. C.

Publications and source records attributed to Brenner, A. C..

8 records

NASA NTRS2010

ICESat-2 Simulated Data from Airborne Altimetery

Ice, Cloud, and land Elevation Satellite-2 (ICESat-2) is scheduled to launch in 2015 and will carry onboard the Advanced Topographic Laser Altimeter System (ATLAS), which represents a new approach to spaceborne determination of surface elevations. Specifically, the current ATLAS design is for a micropulse, multibeam, photon-counting laser altimeter with lower energy, a shorter pulse width, and a higher repetition rate relative to the Geoscience Laser Altimeter (GLAS), the instrument that was onboard ICESat. Given the new and untested technology associated with ATLAS, airborne altimetry data is necessary (1) to test the proposed ATLAS instrument geometry, (2) to validate instrument models, and (3) to assess the atmospheric effects on multibeam altimeters. We present an overview of the airborne instruments and datasets intended to address the ATLAS instrument concept, including data collected over Greenland (July 2009) using an airborne SBIR prototype 100 channel, photon-counting, terrain mapping altimeter, which addresses the first of these 3 scientific concerns. Additionally, we present the plan for further simulator data collection over vegetated and ice covered regions using Multiple Altimeter Beam Experimental Lidar (MABEL), intended to address the latter two scientific concerns. As the ICESAT-2 project is in the design phase, the particular configuration of the ATLAS instrument may change. However, we expect this work to be relevant as long as ATLAS pursues a photon-counting approach.

Brunt, Kelly M.↗

NASA NTRS2001

Motion of Major Ice Shelf Fronts in Antarctica from Slant Range Analysis of Radar Altimeter Data, 1978 - 1998

Slant range analysis of radar altimeter data from the Seasat, Geosat, ERS-1 and ERS-2 databases are used to determine barrier location at particular times, and estimate barrier motion (km/yr) for major Antarctic ice shelves. The barrier locations, which are the seaward edges or fronts of floating ice shelves, advance with time as the ice flows from the grounded ice sheets and retreat whenever icebergs calve from the fronts. The analysis covers various multiyear intervals from 1978 to 1998, supplemented by barrier location maps produced elsewhere for 1977 and 1986. Barrier motion is estimated as the ratio between mean annual ice shelf area change for a particular interval, and the length of the discharge periphery. This value is positive if the barrier location progresses seaward, or negative if the barrier location regresses (break-back). Either positive or negative values are lower limit estimates because the method does not detect relatively small area changes due to calving or surge events. The findings are discussed in the context of the three ice shelves that lie in large embayments (the Filchner-Ronne, Amery, and Ross), and marginal ice shelves characterized by relatively short distances between main segments of grounding line and barrier (those in the Queen Maud Land sector between 10.1 deg. W and 32.5 deg. E, and the West and Shackleton ice shelves). All the ice shelves included in the study account for approximately three-fourths of the total ice shelf area of Antarctica, and discharge approximately two-thirds of the total grounded ice area.

Zwally, H. J.↗

NASA NTRS1993

Postprocessing of satellite altimetry return signals for improved sea surface topography accuracy

Retracked southern ocean data from the first 34 repeat cycles of the Geosat Exact Repeat Mission are analyzed. The difference between the surface heights calculated from the retracked data and the original on-board estimate is less than 10 cm for significant wave heights (SWH) lower than 10 m but increases to about 1.0 m at an SWH of 18 m. The electromagnetic (EM) bias coefficient calculated using the retracked data is generally slightly less than that using the unretracked data and does not decrease as much with SWH as to the EM bias coefficients calculated from the unretracked data. A map of the sea surface height variability of the southern ocean created using the retracked data shows differences from variability maps created using the unretracked data in regions of high wave heights. This study shows that retracking will improve altimeter precision.

Brenner, A. C.↗

NASA NTRS1992

A global mean sea surface based upon GEOS 3 and Seasat altimeter data

A mean sea surface relative to the International Union of Geodesy 1980 Geodetic Reference System reference ellipsoid has been derived from Seasat and GEOS 3 altimeter measurements. This surface, called MSS-9012, has been computed on a grid of 1/8 deg resolution. The surface covers the global ocean between 70 deg N and 72 deg S. Comparisons are made between MSS-9012 and ocean bathymetry. The eastern extent of the Chain Fracture Zone in the Gulf of Guinea is more apparent in the altimetry than in the bathymetry data, as are many other features. The combination of data from the two satellites has successfully retrieved more information about the sea surface than was previously possible using only Seasat data.

Marsh, J. G.↗

NASA NTRS1990

Comparisons between Geosat and Seasat tracking over non-ocean surfaces

The differences in both the quantity and quality of the nonocean measurements of the Geosat and Seasat altimeters due to the tracker modifications and satellite and antenna design changes are presented. The Geosat tracker exhibits more agility over the rougher surfaces and therefore is able to maintain lock better than Seasat. Large off-nadir attitude excursions created differences in Geosat tracking between cycles. The Geosat altimeter was at times able to track over surfaces Seasat could not, but sometimes the acquisition problem was worse. It is observed that Geosat yields denser coverage, but over land Seasat measurements yield a better overall picture of the general topography. It is concluded that the Geosat elevation data set over land can best be utilized to augment the information obtained from the Seasat data and is most useful when investigating topography at scales less than 100 km.

Brenner, A. C.↗

NASA NTRS1983

Surface elevation contours of Greenland and Antarctic ice sheets

Preliminary results from Seasat radar altimetry over Antarctica north of 72 deg S and Greenland south of 72 deg N are presented. Surface elevations of the ice sheets, obtained from computer retracking of the radar altimeter waveforms, are contoured at 50-m intervals for Greenland and at 100-m intervals for Antarctica. Elevation differences at orbital crossover points are analyzed to obtain a precision of 1.9 m; this figure is partly determined by radial errors of approximately 1.0 m in orbital determination and partly by noise due to ice surface irregularities. Adjustment of the radial components of the orbits to minimize the differences in elevations at crossovers over a small, relatively flat region reduces the rms difference to 0.25 m, which is indicative of the optimum precision obtainable over the ice sheets. However, the precision degrades as the slope of the surface or amplitude of the undulations increases, yielding an overall precision of + or - 1.6 m.

Zwally, H. J.↗

NASA NTRS1983

Analysis and retracking of continental ice sheet radar altimeter waveforms

The Seasat-1 radar altimeter data set acquired over both the Antarctic and Greenland continental ice sheets is analyzed to obtain corrected ranges to the ice surface. The radar altimeter functional response over the continental ice sheets is considerably more complex than over the oceans. Causal factors identified in this complicated response include sloping surfaces, undulating ice surfaces with characteristic wavelengths on the same spatial scale as the altimeter beam-limited footprint, off-track reflections, and dynamic lag of the altimeter tracking circuit. Retracking methods using the altimeter return pulse waveforms give range corrections that are typically several meters. The entire set of Seasat-1 altimetry over the continental ice sheets is being retracked by fitting a multi-parameter function to each waveform. Many waveforms have double ramps indicating near-normal reflections from two distinct portions of the ice surface within the altimeter beam. Two independent range measurements differing by less than 25 m are obtained from retracking the double-ramp waveforms.

Martin, T. V.↗

NASA NTRS1983

Slope-induced errors in radar altimetry over continental ice sheets

Altimeter measurements of ranges to modelled irregular surfaces are simulated and two correction schemes are used to reconstruct the modelled surfaces from the simulated data. When the cross-track slope is negligible, the problem can be treated as two-dimensional and the relocation method is preferred to the slope correction method. In a two-dimensional test case, 85 percent of the slope-induced rms error was removed by the relocation method. The mean error along profiles of about 75 km or longer is usually reduced more than the rms error. An alternative slope correction scheme, which uses the local slope to calculate the expected error, is less effective in the two-dimensional case. Over a simulated three-dimensional surface, where groundtracks are widely spaced and cross-track slopes are significant, the slope-correction method must be used in at least the cross-track direction.

Brenner, A. C.↗