Engineering topics

Brent W. Pomeroy

Publications and source records attributed to Brent W. Pomeroy.

3 records

NASA NTRS2024

Computational Techniques to Generate Space Launch System Aerodynamic Databases

This document describes the reasoning and trade studies used to evaluate tools for constructing the aerodynamic lineload databases for the liftoff and transition phases of flight for the Space Launch System. Three computational fluid dynamics codes (USM3D, FUN3D, Kestrel) were investigated with various turbulence models, as well as detached eddy simulation variants for the launch vehicle in free air and in proximity to the tower. Decisions were made mostly based on results from brief developmental studies performed in response to specific, unforeseen challenges that were encountered in the analysis of a given configuration. The need to develop databases in a timely manner, as well as accurately capture the expected leeward-wake flowfield characteristics, led to the selection of the Kestrel flow solver with its delayed detached eddy simulation method, the Spalart-Allmaras turbulence model, and the adaptive mesh refinement capability in the off-body Cartesian grid region.

Karen A. Deere↗

NASA NTRSDate not supplied

Ground Wind Loads on the Space Launch System’s Mobile Launcher Crew Access Arm

An aerodynamic database for the crew access arm during deployment is generated. While initial attempts used data derived from wind tunnel testing, limitations lead to the use of computational fluid dynamics to improve analysis. This computational data compared favorably to the experimental data increasing confidence in both. Further analysis lead to simplification showing the ability to build the database with a single relative wind variable which takes into account both arm deployment angle and wind direction. Eventually geometric simplifications and conservative results lead to the use of simulations of the CAA alone to build the database.Finally these static conditions are then compared to a dynamic simulation where the CAA rotates into position to test the quasi-steady state assumptions used to generate the database. The dynamic case showed an increase in the moment of interest but within acceptable bounds for now.

SLS↗

NASA NTRSDate not supplied

Application of the CATNLF Design Method to a Transonic Transport Empennage Using CDISC

A novel Crossflow Attenuated Natural Laminar Flow (CATNLF) design method has been developed to achieve laminar flow on aircraft empennage at transonic flight conditions. This approach has been applied to the design of a nonlifting vertical tail using CDISC, a knowledgebased aerodynamic design tool developed at the NASA Langley Research Center. A horizontal tail was also designed using an enhanced CATNLF design approach for low-lift components. CDISC was coupled with USM3D-ME, a Navier-Stokes computational fluid dynamics solver. Stability and transition software was used to determine the laminar extent on the surfaces. Results indicate laminar flow can be sustained at midcruise conditions to about x/c=0.40 on the vertical tail and as much as x/c=0.65 on the horizontal tail lower surface. Transonic longitudinal off-design analysis indicates minimal change in the laminar extent. However, nonzero sideslip angles at transonic conditions can cause premature transition relative to the midcruise condition.

Brent W. Pomeroy↗