A method for flight-test determination of propulsive efficiency and drag
Explore the source record for details and available documents.
Bull, G.↗
Engineering topics
Bridges, P. D.
Publications and source records attributed to Bridges, P. D..
A new method for flight test determination of propulsive efficiency and drag coefficient
A flight test method is described from which propulsive efficiency as well as parasite and induced drag coefficients can be directly determined using relatively simple instrumentation and analysis techniques. The method uses information contained in the transient response in airspeed for a small power change in level flight in addition to the usual measurement of power required for level flight. Measurements of pitch angle and longitudinal and normal acceleration are eliminated. The theoretical basis for the method, the analytical techniques used, and the results of application of the method to flight test data are presented.
Bull, G.↗
Full scale visualization of the wing tip vortices generated by a typical agricultural aircraft
The trajectories of the wing tip vortices of a typical agricultural aircraft were experimentally determined by flight test. A flow visualization method, similar to the vapor screen method used in wind tunnels, was used to obtain trajectory data for a range of flight speeds, airplane configurations, and wing loadings. Detailed measurements of the spanwise surface pressure distribution were made for all test points. Further, a powered 1/8 scale model of the aircraft was designed, built, and used to obtain tip vortex trajectory data under conditions similar to that of the full scale test. The effects of light wind on the vortices were demonstrated, and the interaction of the flap vortex and the tip vortex was clearly shown in photographs and plotted trajectory data.
Cross, E. J., Jr.↗
Determining performance parameters of general aviation aircraft
A method for determining propeller efficiency and drag from flight tests, using relatively simple instrumentation, is under development at Mississippi State University. Flight test data from several simple maneuvers are combined to produce sufficient information to determine the desired parameters. Information obtained from the transient response of airspeed to a step change in power or drag in level flight is utilized. Theory is developed and results of preliminary computer studies and preliminary flight test are presented.
Bull, G.↗
Determination of cooling air mass flow for a horizontally-opposed aircraft engine installation
The relationship between the amount of cooling air flow and the corresponding flow pressure difference across an aircraft engine was investigated in flight and on the ground. The flight test results were consistent with theory, but indicated a significant installation leakage problem. A ground test blower system was used to identify and reduce the leakage. The correlation between ground test cell determined engine orifice characteristics and flight measurements showed good agreement if the engine pressure difference was based on total pressure rather than static pressure.
Miley, S. J.↗
Flight test evaluation of a method to determine the level flight performance of a propeller-driven aircraft
A flight test method has been developed for determining the level flight drag and propulsive efficiency of propeller-driven aircraft. The overall drag of the aircraft is expressed in terms of the measured increment of power required to overcome a corresponding known increment of drag, which is generated by a towed drogue. The simplest form of the governing equations, D = delta D SHP/delta SHP (where D is drag and SHP is the horsepower delivered to the propeller) is such that all of the parameters on the right side of the equation can be measured in flight. An evaluation of the governing equations has been performed using data generated by flight test of a Beechcraft T-34B.
Bridges, P. D.↗