Engineering topics

Britcher, Colin

Publications and source records attributed to Britcher, Colin.

7 records

NASA NTRS2018

Further Development of an Electromagnetic Position Sensor for a Wind Tunnel MSBS

An Electromagnetic Position Sensor (EPS) was successfully developed in the 1960’s for the MIT “6-inch” Magnetic Suspension and Balance System. An updated version remains in use today, based on analog electronics. This paper will review the hardware revisions made to successfully adapt the system for use in sensing 3 degrees-of-freedom motion of small spherical or near-spherical suspended models. Practical challenges related to electrical noise sensitivity and stray coupling paths will be discussed. Preliminary analysis of alternative demodulation approaches, including digital signal processing, will be reviewed.

Britcher, Colin↗

NASA NTRS2018

Static and Dynamic Testing of Blunt Bodies in a Subsonic Magnetic Suspension Wind Tunnel

The MIT 6-inch magnetic suspension wind tunnel is used in two configurations to measure lift forces of two blunt bodies and produce free-to-pitch oscillations driven by capsule static stability and dynamic instabilities. Lift tests show that static aerodynamic data can be measured on a magnetically levitated model without moment control. Free-to- oscillate results show that magnetic suspension balance system (MSBS) can produce capsule dynamics suitable for extracting static and dynamic stability data.

Schoenenberger, Mark↗

NASA NTRS2015

Feasibility of Dynamic Stability Measurements of Planetary Entry Capsules Using MSBS

The feasibility of conducting dynamic stability testing of planetary entry capsules at low supersonic Mach numbers using a Magnetic Suspension and Balance System (MSBS) is reviewed. The proposed approach would employ a spherical magnetic core, exert control in three degrees-of-freedom (i.e. x, y, z translations) and allow the model to freely rotate in pitch, yaw, and roll. A proof-of-concept system using an existing MSBS electromagnet array in a subsonic wind tunnel is described, with future potential for development of a new system for a supersonic wind tunnel.

Britcher, Colin↗

NASA NTRS1998

Magnetic Suspension Technology Development

This Cooperative Agreement, intended to support focused research efforts in the area of magnetic suspension systems, was initiated between NASA Langley Research Center (LaRC) and Old Dominion University (ODU) starting January 1, 1997. The original proposal called for a three-year effort, but funding for the second year proved to be unavailable, leading to termination of the agreement following a 5-month no-cost extension. This report covers work completed during the entire 17-month period of the award. This research built on work that had taken place over recent years involving both NASA LARC and the Principal Investigator (PI). The research was of a rather fundamental nature, although specific applications were kept in mind at all times, such as wind tunnel Magnetic Suspension and Balance Systems (MSBS), space payload pointing and vibration isolation systems, magnetic bearings for unconventional applications, magnetically levitated ground transportation and electromagnetic launch systems. Fundamental work was undertaken in areas such as the development of optimized magnetic configurations, analysis and modelling of eddy current effects, control strategies for magnetically levitated wind tunnel models and system calibration procedures. Despite the termination of this Cooperative Agreement, several aspects of the research work are currently continuing with alternative forms of support.

Britcher, Colin↗

NASA NTRS1997

Research Related to Multi Degree of Freedom Magnetic Suspensions

This thesis covers the activities associated with (1) recommissioning of the 6-inch Magnetic Suspension and Balance System (MSBS) and (2) enhancing the Annular Suspension and Pointing System (ASPS). These activities continue the program of research in the multi degree of freedom magnetic suspension program at Old Dominion University. The 6-inch MSBS is a large gap magnetic suspension system used as a model support and balance system in wind tunnels. The first stage of recommissioning of the 6-inch MSBS for the 6-inch subsonic wind tunnel is performed. Experimental data and computational results for the magnetic field distribution of the MSBS are given and compared with the estimated magnetic field strength. The comparison indicates that the magnet system is still operating as designed. The Electromagnetic Position Sensor used in the 6-inch MSBS is analyzed before its find reinstatement. The ASPS is a small gap magnetic suspension system providing orientation, mechanical isolation and fine pointing of space payloads. The control system of the ASPS is improved by designing a new code to realize red time control over the system. The original Proportional-Derivative controller is upgraded to a Proportional-Integral-Derivative controller. This progress leads to a system which is more stable and robust with less noise. This new controller is generic and can be adapted to the 6-inch MSBS. Finally, future work on these two systems is proposed.

Britcher, Colin↗

NASA NTRS1994

Preliminary eddy current modelling for the large angle magnetic suspension test fixture

This report presents some recent developments in the mathematical modeling of the Large Angle Magnetic Suspension Test Fixture (LAMSTF) at NASA Langley Research Center. It is shown that these effects are significant, but may be amenable to analysis, modeling and measurement. A theoretical framework is presented, together with a comparison of computed and experimental data.

Britcher, Colin↗

NASA NTRS1988

An experimental investigation of the aerodynamic characteristics of slanted base ogive cylinders using magnetic suspension technology

An experimental investigation is reported on slanted base ogive cylinders at zero incidence. The Mach number range is 0.05 to 0.3. All flow disturbances associated with wind tunnel supports are eliminated in this investigation by magnetically suspending the wind tunnel models. The sudden and drastic changes in the lift, pitching moment, and drag for a slight change in base slant angle are reported. Flow visualization with liquid crystals and oil is used to observe base flow patterns, which are responsible for the sudden changes in aerodynamic characteristics. Hysteretic effects in base flow pattern changes are present in this investigation and are reported. The effect of a wire support attachment on the 0 deg slanted base model is studied. Computational drag and transition location results using VSAERO and SANDRAG are presented and compared with experimental results. Base pressure measurements over the slanted bases are made with an onboard pressure transducer using remote data telemetry.

Alcorn, Charles W.↗