Search NASA⌕ Search

Engineering topics

Britt, C. L., Jr.

Publications and source records attributed to Britt, C. L., Jr..

Integrated display of multi-sensor geophysical and electromagnetic flight data

Low-altitude wind shear has been identified by several aviation interests as a significant hazard to the safety of flying. The hazard may be greatest when the wind shear is due to an unpredicted and short-lived microburst occurring in the immediate flight path of an aircraft during takeoff or landing. Researchers from the NASA Langley Research Center have investigated wind shear by developing a suite of remote sensing instruments and then using these instruments in an airborne wind shear detection flight program. Among these instruments were a Doppler radar, a lidar, and an infrared sensor; these were supported by in situ measurements of aircraft and environmental parameters and by ground-based Doppler radars. The basic problem addressed was the airborne detection and measurement of meteorologically-induced wind shear sufficiently ahead of the aircraft to allow avoidance. If the remote measurements of the shear and its associated radar reflectivity did not exceed set limits, the airplane then continued through the wind shear so that in situ measurements could be made for comparison. Initial detection and vectoring to the wind shear was normally given from a ground-based Doppler weather radar and most of the wind shear events were due to microbursts, both wet and dry. This paper considers the problems of sampling the wind shear event, time and space registration among the various sensors, coordination of the various sensors' beams and sampling volumes, and also various techniques for portraying the data, both for research and for presentation. Examples are given based on data from the 1991 and 1992 NASA/FAA wind shear flights, and the results and conclusions are generalized to other flight experiments involving multi-sensor electromagnetic data sets.

Delnore, V. E.↗

Errors in radiometric remote sensing of sea-surface temperature and salinity

Techniques for remote measurement of sea-surface physical temperature and salinity using radiometric measurements from aircraft or satellite are reviewed. Studies have been conducted to determine the sensitivity of the errors in surface temperature and salinity to errors in the measured brightness temperatures using combinations of UHF, L, S, and C-band measurements. These investigations were made using values of conductivity, static dielectric constant, and relaxation time derived from the regression equations of Klein and Swift (1977). Results of the error sensitivity study are presented in the form of error contour plots which permit the calculation of errors in the estimation of the physical parameters for given errors in the raw radiometric measurements.

Britt, C. L., Jr.↗

Performance evaluation of a spaceborne scatterometer

Study results are presented showing performance capability of a spaceborne scatterometer to operationally measure ocean surface wind speed and direction. In addition, a research mode is described which will allow development of improved radar signatures for ocean, sea ice, and land targets. The study results show that a scatterometer can meet the operational requirements of + or - 2 m/s wind speed accuracy (or + or - 10%, whichever is greater) and + or - 20 deg wind direction accuracy over most of the expected ocean surface conditions. The six beam scatterometer design evaluated is shown to be skillful (greater than 90% correct) in specifying the correct wind vector solution (with a 180 deg ambiguity) from the multiple solutions derived; further improvement must rely on meteorological and pattern recognition techniques now under study.

Grantham, W. L.↗

Development of a microwave multilateration system for VTOL landing guidance

An experimental microwave multilateration system has been developed by NASA to provide highly accurate position and velocity measurements during the approach and landing phase of VTOL aircraft. The system uses an angle modulated ranging signal to provide both range and range rate measurements between an aircraft transponder and multiple ground stations. Range and range rate measurements are converted to coordinate measurements, and the coordinate information is transmitted via an integral data link to the aircraft. This paper describes the development of the multilateration system and the associated digital signal processing techniques. Advantages and disadvantages of several processing techniques are discussed. The operation and accuracy of the system as determined from both analytical studies and flight experiments will be described.

Britt, C. L., Jr.↗

Research in ground-based near-terminal area 4D guidance and control

This paper describes work being done at NASA, Langley Research Center and at the Research Triangle Institute on advanced, ground-based guidance and control for the near terminal area. Large-scale computer traffic simulations in conjunction with flight experiments with a Boeing 737 aircraft will be used to evaluate various concepts for automated terminal area metering and spacing. The all-digital real-time air traffic simulation model is described. Facilities for aircraft tracking and for interfacing the aircraft with the digital simulation are discussed, along with possible application to other types of experiments.

Britt, C. L., Jr.↗

An investigation of errors and data processing techniques for an RF multilateration system

The development of an RF Multilateration system to provide accurate position and velocity measurements during the approach and landing phase of Vertical Takeoff Aircraft operation is discussed. The system uses an angle-modulated ranging signal to provide both range and range rate measurements between an aircraft transponder and multiple ground stations. Range and range rate measurements are converted to coordinate measurements and the coordinate and coordinate rate information is transmitted by an integral data link to the aircraft. Data processing techniques are analyzed to show advantages and disadvantages. Error analyses are provided to permit a comparison of the various techniques.

Britt, C. L., Jr.↗

An investigation of vehicle dependent aspects of terminal area ATC operation.

Description of a terminal area simulation which permits analysis and synthesis of current and advanced air traffic management system configurations including ground and airborne instrumentation and new and modified aircraft characteristics. Ground elements in the simulation include navigation aids, surveillance radars, communication links, air-route structuring, ATC procedures, airport geometries, and runway handling constraints. Airborne elements include traffic samples with individual aircraft performance and operating characteristics and aircraft navigation equipment. The simulation also contains algorithms for conflict detection, conflict resolution, sequencing and pilot-controller data links.

Britt, C. L., Jr.↗