Search NASA⌕ Search

Engineering topics

Britten, Jerald A.

Publications and source records attributed to Britten, Jerald A..

Metal-overcoated grating and method

Metallic overcoated diffraction gratings are particularly useful for high average power laser pulse compression. A dielectric oxide layer is attached to an etch-stop layer, where the dielectric oxide layer comprises a grating pattern including grating lines. Sidewalls of the grating lines taper together toward an upper surface of the dielectric oxide layer. A metallic overcoat is attached to the etch-stop layer and the dielectric oxide layer.

Nguyen, Hoang T.↗

Isotropic etchback method of linewidth tailoring multilayer dielectric diffraction gratings for improvement of laser damage resistance and diffraction efficiency

A method of fabricating a multilayer dielectric (MLD) diffraction grating by providing a multilayer stack having a grating layer, and anisotropically etching the grating layer to form grating lines having an initial lineheight, an initial linewidth, and an initial grating duty cycle, that are greater than a target lineheight, a target linewidth, and a target grating duty cycle, respectively. An isotropic wet etch solution is then used to etch back the grating lines to the target lineheight, the target linewidth, and the target grating duty cycle so as to minimize electric field intensities and maximize diffraction efficiency for a given set of MLD illumination conditions.

Britten, Jerald A.↗

Symmetric out-of-plane configurations of diffractive gratings and method

Grating pair architectures used for short pulse stretching, compression and pulse shaping are enabled for use at arbitrary use angles without inducing spatial frequency chirp. These symmetric out-of-plane diffractive grating arrangements are capable of adding or removing spatial, temporal and angular chirp at any incidence angle.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Active cooling of pulse compression diffraction gratings for high energy, high average power ultrafast lasers

Laser energy absorption and subsequent heat removal from diffraction gratings in chirped pulse compressors poses a significant challenge in high repetition rate, high peak power laser development. In order to understand the average power limitations, we have modeled the time-resolved thermo-mechanical properties of current and advanced diffraction gratings. We have also developed and demonstrated a technique of actively cooling Petawatt scale, gold compressor gratings to operate at 600W of average power - a 15x increase over the highest average power petawatt laser currently in operation. As a result, combining this technique with low absorption multilayer dielectric gratings developed in our group would enable pulse compressors for petawatt peak power lasers operating at average powers well above 40kW.

42 ENGINEERING↗