Engineering topics
Publications and source records attributed to Broussard, P. H..
Detector, intended for use with longwall shearer, determines when cut has pierced through coal layer. Accelerometer measures hardness of material struck by penetrometer ram, while reflectometers measure reflectivity of surface on either side of penetrometer. Signals are combined in voting circuit that indicates "coal" or "shale", depending on information supplied by three sensors. It distinguishes by differences in accelerometer waveforms.
A penetrometer for coal-shale interface detection is presented. It is used with coal cutting equipment consisting of a reciprocating hammer, having an accelerometer mounted thereon to measure the impact of the hammer as it penetrates the ceiling or floor surface of a mine. Additionally, a pair of reflectometers simultaneously view the same surface, and the outputs from the accelerometer and reflectometers are detected and jointly registered to determine when an interface between coal and shale is being cut through.
Processes involved in remote control mining (fragmentation, material handling, ground and environmental control) are discussed with reference to longwall shear mining, the method which affords the greatest potential for the use of teleoperated systems. The breakup and haulage procedures are outlined, with attention to environmental control subsystems, i.e., noise and dust abatement. A description of a four-legged chock, attached to a section of a face conveyor and operated remotely, is presented.
Hydrodynamic conical and spherical spiral grooved grease bearings replacement of gyro ball bearings for extended space missions