Pseudocapacitance and performance stability of quinone-coated carbon onions
Explore the source record for details and available documents.
Engineering topics
Publications and source records attributed to Brown, G. M..
Explore the source record for details and available documents.
The photoelectrochemical stability and surface-alteration characteristics of doped and undoped n-type ZnO single-crystal photoanode electrodes were investigated. The single-crystal ZnO photoanode properties were analyzed using current-voltage measurements plus spectral and time-dependent quantum-yield methods. These measurements revealed a distinct anodic peak and an accompanying cathodic surface degradation process at negative potentials. The features of this peak depended on time and the NaOH concentration in the electrolyte, but were independent of the presence of electrode illumination. Current measurements performed at the peak indicate that charging and discharging effects are apparently taking place at the semiconductor/electrolyte interface. This result is consistent with the significant reactive degradation that takes place on the ZnO single crystal photoanode surface and that ultimately leads to the reduction of the ZnO surface to Zn metal. The resulting Zn-metal reaction products create unusual, dendrite-like, surface alteration structural features that were analyzed using x-ray diffraction, energy-dispersive analysis, and scanning electron microscopy. ZnO doping methods were found to be effective in increasing the n-type character of the crystals. Higher doping levels result in smaller depletion widths and lower quantum yields, since the minority carrier diffusion lengths are very short in these materials.
The effects of compositionally induced changes on the semiconducting properties, optical response, chemical stability, and overall performance of KTaO3 photo-anodes in photoelectrochemical cells have been investigated. Single crystals of n-type Ca- and Ba-doped KTaO3 with carrier concentrations ranging from 0.45 - 11.5 x 1019 cm-3 were grown and characterized as photoanodes for hydrogen production in basic aqueous electrolytes. The photoelectrochemical properties of the crystals, including the photocurrent, photovoltage, and flat-band potential in contact with 8.5 M NaOH(aq) were relatively independent of whether Ca or Ba was used to produce the semiconducting form of KTaO3. All of the Ca- or Ba- doped KTaO3 single crystal photoanodes were chemically stable in the electrolyte; and based on the open-circuit potential and the band-edge positions, they were capable of unassisted photochemical H2 and O2 evolution from H2O. The minority carrier diffusion lengths values were small and comparable to the depletion region width. Photoanodic currents were only observed for photo-anode illumination with light above the band gap (i.e., < 340 nm). The maximum external quantum yield occurred at = 1 nm (4.85 eV), and the depletion width plus the minority carrier diffusion length ranged from 20 to 65 nm for the various KTaO3-based photoanode materials.
The StarLight mission scheduled to launch June 2006, will demonstrate the separated spacecraft technologies of formation flying, precision formation, estimation, and long baseline stellar interferometry.
This paper describes a strategy that provides maxium assurance that Cassini's Saturn orbit insertion (SOI) will be successful.
Explore the source record for details and available documents.
Three new and independent methods of predicting the magnitude of a forthcoming sunspot maximum are suggested. The longest lead time is given by the first method, which is based on a terrestrial parameter measured during the declining phase of the preceding cycle. The second method, with only a slightly shorter foreknowledge, is based on an interplanetary parameter derived around the commencement of the cycle in question (sunspot minimum). The third method, giving the shortest prediction lead-time, is based entirely on solar parameters measured during the initial progress of the cycle in question. Application of all three methods to forecast the magnitude of the next maximum (Cycle 21) agree in predicting that it is likely to be very similar to that of Cycle 18.
Apollo 11 lunar igneous rocks mineralogical, chemical and petrological features by optical and electron microscopy and X ray spectrometry
Vibrating objects phase determined by time average and real time holographic interferometry
Solid state ionization p-n junction detectors