Search NASA⌕ Search

Engineering topics

Bruce Anderson

Publications and source records attributed to Bruce Anderson.

10 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2020

Understanding and Improving Model Representation of Aerosol Optical Properties for a Chinese Haze Event Measured During KORUS-AQ

KORUS-AQ was an international cooperative air quality field study in South Korea that measured local and remote sources of air pollution affecting the Korean Peninsula during May–June 2016. Some of the largest aerosol mass concentrations were measured during a Chinese haze transport event (24 May). Air quality forecasts using the WRF-Chem model with aerosol optical depth (AOD) data assimilation captured AOD during this pollution episode but overpredicted surface particulate matter concentrations in South Korea, especially PM2.5, often by a factor of 2 or larger. Analysis revealed multiple sources of model deficiency related to the calculation of optical properties from aerosol mass that explain these discrepancies. Using in situ observations of aerosol size and composition as inputs to the optical properties calculations showed that using a low-resolution size bin representation (four bins) underestimates the efficiency with which aerosols scatter and absorb light (mass extinction efficiency). Besides using finer-resolution size bins (8–16 bins), it was also necessary to increase the refractive indices and hygroscopicity of select aerosol species within the range of values reported in the literature to achieve better consistency with measured values of the mass extinction efficiency (6.7 m2 g−1 observed average) and light-scattering enhancement factor (f(RH)) due to aerosol hygroscopic growth (2.2 observed average). Furthermore, an evaluation of the optical properties obtained using modeled aerosol properties revealed the inability of sectional and modal aerosol representations in WRF-Chem to properly reproduce the observed size distribution, with the models displaying a much wider accumulation mode. Other model deficiencies included an underestimate of organic aerosol density (1.0 g cm−3 in the model vs. observed average of 1.5 g cm−3) and an overprediction of the fractional contribution of submicron inorganic aerosols other than sulfate, ammonium, nitrate, chloride, and sodium corresponding to mostly dust (17 %–28 % modeled vs. 12 % estimated from observations). These results illustrate the complexity of achieving an accurate model representation of optical properties and provide potential solutions that are relevant to multiple disciplines and applications such as air quality forecasts, health impact assessments, climate projections, solar power forecasts, and aerosol data assimilation.

Pablo E. Saide↗
NASA NTRS2018

TPSAS-NF1676L-30150-DND

Validation of science data products from the Stratospheric Aerosol and Gas Experiment (SAGE) III, installed on the International Space Station (ISS) in March 2017, requires intercomparison with validated data sources. The SAGE III/ISS mission is actively utilizing in-situ profile measurements from balloon packages, consisting of a standard meteorological radiosonde, ozonesonde, and frost-point hygrometer, that were launched coincident with SAGE III/ISS overpass opportunities. Some packages have included an aerosol sonde. This provides regional correlations of ozone, water vapor and aerosol extinction between the in-situ measurement data and the SAGE III/ISS profile products. In addition, ground-based LIDAR measurements and aircraft-based measurements of ozone, water vapor, aerosol extinction and nitrogen dioxide will provide additional validation data for correlation with the SAGE III/ISS data products. Initial results of the mission directed validation program will be presented. When possible, operation and launch times were modified to improve the temporal and spatial coincidence between the measurements. Results and progress utilizing LIDAR and balloon-borne aerosol observations are discussed herein, while intercomparisons that make use of ozone sondes is are presented in the companion poster by Kizer et al.

Travis Knepp↗
NASA NTRS2015

TPSAS-NF1676L-22701-DND

The next generation of aerosol satellite instruments will include multi-spectral polarimetric measurements to retrieval aerosol size distribution and refractive index (Hasekamp et al., 2011; NRC, 2007). Refractive index is the “only means of constraining aerosol chemical composition from space” for passive sensors (Mischenko et al., 2007). A number of methods have been developed to derive refractive index from combined optical and electrical mobility sizing instruments (e.g., the “Alignment Method” of Hand and Kreidenweis, 2002). In this work, we evaluate the sensitivity of two, commercially-available, high-resolution optical particle counters for determining the size-resolved refractive index of laboratory-generated aerosols when used with a modified form of the Alignment Method.

Stephen Zimmerman↗
NASA NTRS2011

TPSAS-NF1676L-13040-DND

We examine the feasibility of using airborne lidar data to: 1) infer CRC Convair-580 profiles of submicrometer fraction (SMF) over land (which is the fraction of aerosols with diameters less than 1 micrometer and is closely related to FMF) and 2) provide a proxy for CCN. If these initial Aerosol Extinction Aerosol Effective Radius feasibility studies prove successful, we will then apply these methodologies in subsequent studies to examine the feasibility of using CALIPSO data in a similar manner. We use data acquired by the NASA Langley Research Center airborne High Spectral Resolution Lidar (HSRL) during several recent field missions conducted by NASA, the Department of Energy, and NOAA. The airborne HSRL, which has acquired over 300 hours of data coincident with CALIPSO overpasses, measures aerosol extinction (532 nm), backscatter (532 and 1064 nm), and depolarization (532 and 1064 nm) profiles and thereby provides a dataset directly applicable to the CALIPSO measurements. During several of these field campaigns, airborne in situ measurements were acquired simultaneously within the HSRL “curtains” thereby facilitating direct correlations of the lidar observables to in situ measurements of particle size and composition, including SMF and CCN concentration. Previous studies have used simultaneous in situ measurements of SMF and Angström exponents derived from in situ scattering (Anderson et al., 2005) and remote sensing extinction (Redemann et al. 2009) measurements to build empirical relationships between these parameters. We adopt a similar approach and investigate relationships between the lidar observables, such as backscatter and extinction Angström exponents, with the coincident airborne in situ measurements of SMF and CCN concentration.

Richard Ferrare↗
NASA NTRSDate not supplied

TPSAS-NF1676L-21952-DND

DISCOVER-AQ was a 4-year NASA project aimed to improve the interpretation of total column satellite observations to help diagnose near-surface conditions relating to air quality. During DISCOVER-AQ HSRL-2 was flown onboard the NASA Langley B200 King Air. A suite of in-situ instruments was flown onboard NASA Wallops P-3B aircraft which spiraled up and down over a number of ground stations. The two aircraft flew coordinated flight tracks, both flying over several designated ground stations with close time coincidence, allowing for colocation of measurements from the in situ instruments suite and the HSRL-2. HSRL-2 is the first multiwavelength airborne lidar system that provides profiles of 3β (backscatter)+2α(extinction),allowing the retrieval of microphysical parameters like number, surface-area, and volume concentrations, and effective radius.

Patricia Sawamura↗
NASA NTRSDate not supplied

TPSAS-NF1676L-23266-DND

Currently, near-surface air quality information (e.g. PM_2.5) must be inferred from column-integrated quantities (i.e. Aerosol Optical Thickness – AOT) obtained by passive remote sensing from downward-looking satellite instruments. Such retrievals must address the following questions: What do we use for the height of the aerosols? Mixed Layer (ML) height? Can we assume that near-surface aerosol extinction is about the same as the mean aerosol extinction in the ML? How well is near-surface extinction related to surface PM_2.5? How well can column AOT be used to infer near-surface aerosol extinction and PM_2.5?

Richard Ferrare↗
NASA NTRSDate not supplied

Survey of microphysical properties of marine boundary-layer clouds in the Western North Atlantic

Oceanic low level clouds strongly affect the atmospheric radiation budget. Uncertainties in their microphysical properties and cover currently limit the accuracy of climate predictions. Further, studies quantifying the relative importance of aerosol and dynamics on cloud properties in specific meteorological regimes are poorly constrained by observations in the Western North Atlantic boundary layer. Low level clouds were measured during the Aerosol Cloud meTereology Interactions oVer the western ATlantic Experiment (ACTIVATE) campaign in winter and summer 2020. The two NASA LaRC research aircraft HU-25 Falcon and UC-12 B-200 King Air conducted 35 simultaneous flights to investigate aerosol-cloud interactions of maritime clouds and their impact on radiation. Number concentration, liquid water content, ice water content, and particle size distribution in the size range of 3 µm to 1460 µm in diameter were measured with the fast forward scattering cloud probe (FCDP) and 2-dimensional optical array imaging probe (2D-S) onboard the Falcon. Here, we present an overview of late winter (February-March) and late summer (August-September) oceanic cloud properties in the region 65°W to 80°W and 30°N to 40°N. We compare cloud properties in these two seasons and investigate their dependence on meteorological parameters and aerosol abundance. In a case study, we present cloud observations in a cold air outbreak event on 1 March 2020 with a specific focus on mixed-phase clouds.

microphysical properties↗
NASA NTRSDate not supplied

Transient Aircraft Soot Emissions Indicate That Steady-State Measurements Likely Underestimate Real-World, Take-Off Emissions: Time-Varying Aircraft Take-Off Emissions Indices Measured at Los Angeles International Airport

Aircraft engine emissions are unique among mobile pollution sources in that their impacts affect the local air quality near airports as well as upper tropospheric composition and climate over regional-to-hemispheric scales. Furthermore, air travel and its resulting emissions are expected to rebound from the recent COVID-related lows to increase dramatically over the next several decades. Given the multi-decade service lifetime of many commercial aircraft, it is critically important to quantitatively understand the real-world emissions coming from these engines in order to inform environmental assessment and modelling activities. Here, we present a detailed analysis of aircraft emissions during take-off operations at Los Angeles International Airport. The data were collected as part of the NASA Alternative Fuel Effects on Contrails and Cruise Emissions (ACCESS) project in May 2014, and the dataset is publicly available as described by Moore et al. [1]. In particular, we focus on the time-varying nature of the plume concentrations where clear differences in particle size and non-volatile particle fraction are observed during the early portion of the take-off plume relative to the later portion of the plume. We compare the transient emissions indices measured here to engine certification values in the International Civil Aviation Organization (ICAO) Emissions Databank, which suggests that steady-state measurements may underestimate the real-world, non-volatile particle emissions. The implications of this finding for modelling aircraft particle emissions will be discussed.

Richard H. Moore↗