Engineering topics
Publications and source records attributed to Budney, T. J..
"Ruggedized" version of the STD microcomputer bus withstands rigors of space-flight. Could be used as a basis for microcomputers in other hazardous environments, including those at high and low temperatures, those in vacuum, or those subject to extreme shock and vibration.
The STRAP V system was developed to provide higher accuracy and lower limit cycle fine pointing (+ or - 7 arcseconds) in all three axes at targets which cannot be tracked by startrackers or solar trackers. The system provides an increase in pointing performance over that obtainable with the STRAP IV (1) Attitude Control System (ACS). The STRAP IV concept of third axis updates is utilized to reduce pointing errors, using the flight-proven STRAP III (2) system as a first stage. Flight aspect photographs and telemetry records show that the STRAP V objectives have been met. The STRAP IV major error contributors have been significantly reduced and the tracking flexibility has been increased with only minor error contributions. Attention is given to the basic STRAP III control modes, major STRAP IV system error sources, tuned restrained inertial gyros (TRIGs), the programmable sequence timer, the STRAP V control box, third axis update, system gyro alignments, and STRAP V operational capabilities.
Previous space flight computers have been costly in terms of both hardware and software. The Ruggedized STD Bus Microcomputer is based on the commercial Mostek/Pro-Log STD Bus. Ruggedized PC cards can be based on commercial cards from more than 60 manufacturers, reducing hardware cost and design time. Software costs are minimized by using standard 8-bit microprocessors and by debugging code using commercial versions of the ruggedized flight boards while the flight hardware is being fabricated.
The high level language FORTH is used for the electronic control of the Space Shuttle-based Ultraviolet Imaging Telescope, in a flight computer system which minimizes costs. The greater part of the breadboard version of the flight computer is assembled from commercially available components, reducing novel circuit design features and permitting simultaneous development of both hardware and software. The commercial boards are then refabricated on aluminum core heat conducting stock, using high reliability parts to produce the flight versions of the system. The system's ground support equipment employs a MINC-25 minicomputer which performs such functions as flight computer software development, PROM programming, test and integration support, and flight operations support. The implementation of these concepts in flight computer telescope controls is described.
The STRAP IV attitude control system was designed, tested, and successfully launched to provide stable high accuracy pointing at nontrackable X-ray sources. On its initial flight (May 19, 1972), the STRAP IV control system updated its high accuracy, rate integrating gyros on two successive stellar targets and then maneuvered the rocket body to point the experimental payload at two separate X-ray sources and an X-ray-free background location. The third axis, which remained under the control of a coarse free gyro, was updated by a technique of successive star-target coordinate transformation to ensure the correct fine-axis azimuth alignment for the high accuracy inertial maneuvers. Pointing accuracies of 4 arc min with limit cycle stability of less than 20 arc sec peak to peak were obtained on all targets.