Search NASA⌕ Search

Engineering topics

Bullard, Jeffrey W.

Publications and source records attributed to Bullard, Jeffrey W..

5 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Natural carbonation of portland cement with synthetic zeolite Y as a supplementary cementitious material

Risks associated with carbonation are a key limitation to greater replacement levels of ordinary portland cement (OPC) by supplementary cementitious materials (SCMs). The addition of pozzolanic SCMs in OPC alters the hydrate assemblage by forming phases like calcium-(alumina)-silicate-hydrate (C-(A)-S-H). The objective of the present study was to elucidate how such changes in hydrate assemblage influence the chemical mechanisms of carbonation in a realistic OPC system. Here, in this paper, we show that synthetic zeolite Y (faujasite) is a highly reactive pozzolan in OPC that reduces the calcium content of hydration products via prompt consumption of calcium hydroxide from the evolving phase assemblage prior to CO 2 exposure. Suppression of portlandite at moderate to high zeolite Y content led to a more damaging mechanism of carbonation by disrupting the formation of a passivating carbonate layer. Without this layer, carbonation depth and CO 2 uptake are increased. Binders containing 12–18% zeolite Y by volume consumed all the calcium hydroxide from OPC during hydration and reduced the Ca/(Si+Al) ratio of the amorphous products to near 0.67. In these cases, higher carbonation depths were observed after exposure to ambient air with decalcification of C-(A)-S-H as the main source of CO 2 buffering. Binders with either 0% or 4% zeolite Y contained calcium hydroxide in the hydrated microstructure, had higher Ca/(Si+Al) ratios, and formed a calcite-rich passivation layer that halted deep carbonation. Although the carbonated layer in the samples with 12% and 18% zeolite Y contained 70% and 76% less calcite than the OPC respectively, their higher carbonation depths resulted in total CO 2 uptakes that were 12x greater than the OPC sample. Passivation layer formation in samples with calcium hydroxide explains this finding and was further supported by thermodynamic modeling. High Si/Al zeolite additives to OPC should be balanced with the calcium content for optimal carbonation resistance.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Topological controls on aluminosilicate glass dissolution: Complexities induced in hyperalkaline aqueous environments

Abstract Fly ash, an aluminosilicate composite consisting of disordered (major) and crystalline (minor) compounds, is a low‐carbon alternative that can partially replace ordinary portland cement (OPC) in the binder fraction of concrete. Therefore, understanding the reactivity of fly ash in the hyperalkaline conditions prevalent in concrete is critical to predicting concrete's performance; including setting and strength gain. Herein, temporal measurements of the solution composition (using inductively coupled plasma‐optical emission spectrometry: ICP‐OES) are used to assess the aqueous dissolution rate of monophasic synthetic aluminosilicate glasses analogous to those present in technical fly ashes, under hyperalkaline conditions (10 ≤ pH ≤ 13) across a range of temperatures (25°C ≤ T≤45°C). The dissolution rate is shown to depend on the average number of topological constraints per atom within the glass network (n c , unitless), but this dependence weakens with increasing pH (>10). This is postulated to be on account of: (a) time‐dependent changes in the glass’ surface structure, that is, the number of topological constraints; and/or (b) a change in the dissolution mechanism (eg from network hydrolysis to transport control). The results indicate that the topological description of glass dissolution is most rigorously valid only at very short reaction times (ie at high undersaturations), especially under conditions of hyperalkalinity. These findings provide an improved basis to understand the underlying factors that affect the initial and ongoing reactivity of aluminosilicate glasses such as fly ash in changing chemical environments, for example, when such materials are utilized in cementitious composites.

Oey, Tandré↗
DOE OSTI2020

Calcium nitrate: A chemical admixture to inhibit aggregate dissolution and mitigate expansion caused by alkali-silica reaction

Alkali-silica reaction (ASR) is a significant cause of the degradation of concrete structures. ASR results from the dissolution of reactive silicate aggregates and the subsequent formation of damaging, expansive ASR gels. Despite the prevalence of ASR, so far only lithium-based chemical admixtures have been shown to be successful in mitigating its deleterious effects. Herein, dissolved calcium nitrate (Ca(NO 3 ) 2 : CN) is demonstrated to reduce ASR-induced expansion caused by the use of sodium borosilicate (NBS) glass as a model reactive aggregate. The significance of reductions of NBS-glass dissolution and mortar-bar expansion rates is discussed, with special focus on highlighting the mechanism by which calcium nitrate mitigates ASR, i.e., by the inhibition of aggregate dissolution. This study reveals a new and cost-effective pathway to suppress aggregate dissolution and ASR in concrete based on the dosage of soluble alkaline-earth additives.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Dissolution and initial hydration behavior of tricalcium aluminate in low activity sulfate solutions

Influences of alkali or alkaline earth sulfates on the hydration of cubic tricalcium aluminate (C 3 A) were evaluated by in situ dissolution rate measurements, by ex situ near-surface composition measurements with secondary ion mass spectrometry, and by in situ synchrotron X-ray diffraction to monitor precipitation of hydration products. Both slight reductions in dissolution rate and cation-specific interactions with the solid were observed. The near-surface Ca/Al ratio is significantly lower after some dissolution and the electrolyte cations are incorporated within the surface with different affinities (Mg 2+ > K + > Na + ). An interfacial dissolution-reprecipitation mechanism may explain the observations as well as, or better than, a simple cation exchange. The sulfate concentration in solution affects the rates of both C 3 A dissolution and precipitation of hydration products. Aditionally, sulfate ions likely adsorb at the hydrous Al-rich surface layer, thereby reducing the dissolution rate of aluminates and delaying the precipitation of aluminate hydration products.

36 MATERIALS SCIENCE↗