Search NASA⌕ Search

Engineering topics

Burger, A.

Publications and source records attributed to Burger, A..

At least 37 records · Page 2

Photoluminescence of CdTe Crystals Grown by Contactless PVT Method

High quality CdTe crystals with resistivities higher than 10(exp 8) Omega cm were grown by the 'contactless' PVT (physical vapor transport) technique. Group III elements In and Al, and the transition metal Sc were introduced at the nominal level of about 6 ppm to the source material. Low-temperature photoluminescence (PL) has been employed to identify the origins of PL emissions of the crystals. It was found that the emission peaks at 1.584 eV and 1.581 eV exist only in the In-doped crystal. The result suggests that the luminescence line at 1.584 eV is associated with Cd-vacancy/indium complex. The intensity of the broadband centered at 1.43 eV decreases dramatically with introduction of Sc.

Palosz, W.↗

Photoluminescence of CdTe Crystals Grown by Physical Vapor Transport

High quality CdTe crystals with resistivities higher than 10(exp 8) omega cm were grown by the physical vapor transport technique. Indium, Aluminum, and the transition metal Scandium were introduced at the nominal level of about 6 ppm to the source material. Low-temperature photoluminescence (PL) has been employed to identify the origins of PL emissions of the crystals. The emission peaks at 1.584 eV and 1.581 eV were found only in the In-doped crystal. The result suggests that the luminescence line at 1.584 eV is associated with Cd-vacancy/indium complex. The intensity of the broadband centered at 1.43 eV decreases strongly with introduction of Sc.

Curreri, Peter A.↗

Photoluminescence of CdTe Crystals Grown by Physical Vapor Transport

High quality CdTe crystals with resistivities higher than 10(exp 8) omega cm were grown by the physical vapor transport technique. Indium, Aluminum, and the transition metal Scandium were introduced at the nominal level of about 6 ppm to the source material. Low-temperature photoluminescence (PL) has been employed to identify the origins of PL emissions of the crystals. The emission peaks at 1.584 eV and 1.581 eV were found only in the In-doped crystal. The result suggests that the luminescence line at 1.584 eV is associated with Cd-vacancy/indium complex. The intensity of the broadband centered at 1.43 eV decreases strongly with introduction of Sc.

Palosz, W.↗

Gravity Effects in Carbon Nanotube Growth by Thermal Chemical Vapor Deposition

Carbon nanotubes are synthesized using thermal chemical vapor deposition. The sizes of these carbon nanotubes (CNT) are quite uniform and the length of the tube is up to several tens of micrometers. With the substrate surface normal either along or against the gravity vector, different growth orientations of CNT are observed by scanning electron microscopy although the Raman spectra are similar for samples synthesized at different locations. These results suggest the gravitation effects in the growth of long and small diameter CNT.

Zhu, S.↗

Growth Orientation of Carbon Nanotubes by Thermal CVD

Carbon nanotubes with a few shells are synthesized using thermal chemical vapor depositions. The sizes of these carbon nanotubes (CNT) are quite uniform and the length is up to several tens of micrometers. With the particular substrate location for which the substrate surface is normal along or against the gravity vector, different growth orientations of CNT are observed by scanning electron microscopy, though the Raman spectra for samples at different locations are similar to each other. The results suggest the gravitation effects in growth of the long and small diameter CNT.

Zhu, S.↗

Characterization of a Structural Transformation of Carbon Nanotube Materials by Raman Spectroscopy

Raman spectra of carbon nanotubes and carbon microstructure materials synthesized on Si substrates by pulsed laser vaporization have been measured in the range of 50/cm to 4500/cm with the excitation of He-Ne laser. It is found that the formation of nanotubes depends strongly on the growth temperatures and high quality multi-wall and single-wall nanotubes were produced at 700 and 990 C, respectively. The Raman spectra of one sample grown at 700 C were found to be dependent on the excitation intensity. The spectra of the sample suggest that the structure is similar to that of multi-wall nanotubes at low excitation intensity (2.5 kW/sq cm) and it converts to the structure of single-wall nanotubes at higher intensity (25 kW/sq cm). Measurements taken while cycling the light intensity indicate a reversible structural transition.

Cui, Y.↗

A Structural Transition of Carbon Nanotubes?

The superior properties of carbon nanotubes (CNT) are good for many applications. A possible temperature-related structural transition is found in the CNT, which may suggest new applications of CNT. CNT materials have been synthesized on Si substrates by pulsed laser vaporization in various temperatures and pressures. Raman spectroscopy and scanning electron microscopy are used to determine the CNT structure and morphology. It is found that the formation of nanotubes depends strongly on the growth temperatures and high quality multi-wall and single-wall nanotubes were produced at 700 and 990 C, respectively. The radial breath modes of Raman spectra measured in the range of 50 cm(exp -1) to 300 cm(exp -1), indicate that one of samples grown at 700 C is to be dependent on the excitation intensity. The spectra of the sample suggest that the structure is similar to that of multi-wall nanotubes at low excitation intensity (2.5 kW per square centimeter) and it converts to the structure of single-wall nanotubes at higher intensity (25 kW per square centimeter). Measurements taken while cycling the light intensity suggests a reversible transition.

Zhu, Shen↗

Orientational Growth of Carbon Nanotube for Applications

Since the superior properties of multi-wall carbon nanotubes (MWCNT) could improve numerous devices such as electronics and sensors, many efforts have been made in investigating the growth mechanism of MWCNT to synthesize high quality MWCNT. Most applications require uniform aligned CNT. In this presentation, a directional growth of CNT will be reported. Carbon nanotubes are synthesized using thermal chemical vapor deposition. Temperature and pressure are two important growth parameters for fabricating carbon nanotubes. It is found that the nanotube diameter distribution mainly depends on the growth-temperature. With the substrate surface normal either along or against the gravity vector, different growth orientations of MWCNT are observed by scanning electron microscopy although the Raman spectra are similar for samples synthesized at different locations. The sizes of these carbon nanotubes in each sample are quite uniform and the length of the tube is up to several tens of micrometers. These results suggest the gravitation effects in the growth of long and small diameter CNT.

Zhu, Shen↗

Beer Law Constants and Vapor Pressures of HgI2 over HgI2(s,l)

The optical absorption spectra of the vapor phase over HgI2(s,l) were measured for wavelengths between 200 and 600 nm. The spectra show that the sample sublimed congruently into HgI2 with no Hg or I2 absorption spectrum observed. The Beer's Law constants for 15 wavelengths between 200 and 440 nm were determined. From these constants the vapor pressure of H912, P, was established as a function of temperatures for the liquid and the solid Beta-phases. The expressions correspond to the enthalpies of vaporization and sublimation of 15.30 and 20.17 Kcal/mole, respectively, for the liquid and the Beta-phase HgI2. The difference in the enthalpies gives an enthalpy of fusion of 4.87 Kcal/mole and the intersection of the two expressions gives a melting point of 537 K.

Su, Ching-Hua↗

The Preparation Conditions of Chromium Doped ZnSe and Their Effect on The Infrared Luminescence Properties

We report the investigation by photoluminescence lifetime measurements of the near-IR emissions from a series of chromium-doped ZnSe samples, correlated to their preparation conditions. The samples were polycrystalline or single crystals prepared by post growth diffusion doping or single crystals doped during growth by the Physical Vapor Transport method. Room temperature lifetime values between 6 and 8 microseconds were measured for samples with Cr (2+) concentrations from low 10 (exp 17) to high 10 (exp 18) per cubic centimeter range. Lifetime data taken down to 78 K was found to be rather temperature independent, reconfirming previous reports indicating a quantum yield of the corresponding emission of close to 100% at room temperature. A strong decrease in the room temperature lifetime was found for chromium concentrations higher than 10 (exp 19) per cubic centimeter.

Burger, A.↗

The Preparation Conditions of Chromium Doped ZnSe and Their Effect on the Infrared Luminescence Properties

We report the investigation by photoluminescence lifetime measurements of the near-IR emissions from a series of chromium-doped ZnSe samples, correlated to their preparation conditions. The samples were polycrystalline or single crystals prepared by post growth diffusion doping or single crystals doped during growth by the physical vapor transport method. Room temperature lifetime values between 6 and 8 micro seconds were measured for samples with Cr2+ from low 10(exp 17) to high 10(exp 18) / cubic cm range. Lifetime data taken down to 78 K was found to be rather temperature independent, reconfirming previous reports indicating a quantum yield of the corresponding emission of close to 100% at room temperature. A strong decrease in the room temperature lifetime was found for chromium concentrations higher than 10(exp 19) / cubic CM.

Burger, A.↗

Crystal Growth of ZnSe and Related Ternary Compound Semiconductors by Vapor Transport

Complete and systematic ground-based experimental and theoretical analyses on the Physical Vapor Transport (PVT) of ZnSe and related ternary compound semiconductors have been performed. The analyses included thermodynamics, mass flux, heat treatment of starting material, crystal growth, partial pressure measurements, optical interferometry, chemical analyses, photoluminescence, microscopy, x-ray diffraction and topography as well as theoretical, analytical and numerical analyses. The experimental results showed the influence of gravity orientation on the characteristics of: (1) the morphology of the as-grown crystals as well as the as-grown surface morphology of ZnSe and Cr doped ZnSe crystals; (2) the distribution of impurities and defects in ZnSe grown crystals; and (3) the axial segregation in ZnSeTe grown crystals.

Su, Ching-Hua↗

In-Situ Optical Determination of Thermomechanical Properties of ZnSe and ZnTe Crystals

At temperatures above 1/2 T(sub m), the generation and movement of dislocations may result due to the load created by the weight of the crystal itself The deformation may be expected to increase the line defect density and may result in generation of low angle grain boundaries, especially in the regions of the crystal attached to the ampule. It has often been suspected that elimination of this effect in space can improve crystallinity of crystals grown under microgravity conditions, however, a direct experimental proof of such relation is still missing. In this work we have designed and built a system of in-situ optical detection and measurement of the mechanical deformations of a crystal wafer under its own weight, and studied the deformation effects as a function of temperature. The results of the measurements for ZnSe and ZnTe crystal wafers will be presented.

Burger, A.↗

Vapor Growth and Characterization of Cr-Doped ZnSe Crystals

Cr-doped ZnSe single crystals were grown by a self-seeded physical vapor transport technique in both vertical (stabilized) and horizontal configurations. The source materials were mixtures of ZnSe and CrSe. Growth temperatures were in the range of 1140-1150 C and the furnace translation rates were 1.9-2.2 mm/day. The surface morphology of the as-grown crystals was examined by scanning electron microscopy (SEM) and atomic force microscopy (AFM). Different features of the as-grown surface of the vertically and horizontally grown crystals suggest that different growth mechanisms were involved in the two growth configurations. The [Cr] doping levels were determined to be in the range of 1.8-8.3 x 10 (exp 19) cm (exp -3) from optical absorption measurements. The crystalline quality of the grown crystals were examined by high-resolution triple-crystal X-ray diffraction (HRTXD) analysis.

Su, Ching-Hua↗

Vapor Growth and Characterization of Cr-Doped ZnSe Crystals

Cr-doped ZnSe single crystals were grown by self-seeded physical vapor transport technique under both vertical (stabilized) and horizontal configurations. The source materials were mixtures of ZnSe and CrSe. The growth temperatures were in the range of 1140 to 1150C and the furnace translation rates were 1.9 to 2.2 mm/day. The surface morphology of the as-grown crystals was examined by scanning electron microscopy (SEM) and atomic force microscopy (AFM). The different features on the as-grown surface of the vertically and horizontally grown crystals suggests that different growth mechanisms were involved for the two growth configurations. The [Cr] doping levels were determined to be in the range of 1.8 to 8.3 x 10(exp 19)/cubic centimeter from optical absorption measurements. The crystalline quality of the grown crystals were examined by high resolution triple crystal X-ray diffraction (HRTXD) analysis.

Su, Ching-Hua↗

Surface Morphology of Undoped and Doped ZnSe Films

Rare-earth doped ions in polar II-VI semiconductors have recently played an important role in the optical properties of materials and devices. In this study, undoped ZnSe and erbium doped ZnSe films were grown by radio frequency (RF) magnetron sputtering method. Atomic Force Microscopy (AFM) was used together with optical microscopy and UV-Vis spectroscopy to characterize the films. Doped samples were found to have higher surface roughness and quite different surface morphology compared to that of undoped samples. The grown films generally show a relatively smooth and uniform surface indicating that they are of overall good quality. The impact of plasma etching on ZnSe:Er film examined under AFM is also discussed.

George, T.↗

Photorefractive effect in CdMnTe:V Crystal

We present two-wave mixing result obtained with a CdMnTe:V crystal. A photorefractive gain coefficient of 0.20 /cm was observed at 633 nm with the signal-to-pump ratio being of the order of 10(exp -3). This crystal was grown by vertical Bridgman Technique and doped with Vanadium during the growth. The crystal were of good optical quality and showed high resistivity. Room temperature absorption and low temperature photoluminescence studies comparing the band edge and defect center at the doped and undoped CdMnTe crystal will also be discussed.

Pour, K. M.↗

Surface Passivation of CdZnTe Detector by Hydrogen Peroxide Solution Etching

The spectral resolution of room temperature nuclear radiation detectors such as CdZnTe is usually limited by the presence of conducting surface species that increase the surface leakage current. Studies have shown that the leakage current can be reduced by proper surface preparation. In this study, we try to optimize the performance of CdZnTe detector by etching the detector with hydrogen peroxide solution as function of concentration and etching time. The passivation effect that hydrogen peroxide introduces have been investigated by current-voltage (I-V) measurement on both parallel strips and metal-semiconductor-metal configurations. The improvements on the spectral response of Fe-55 and 241Am due to hydrogen peroxide treatment are presented and discussed.

Hayes, M.↗