Engineering topics

Burgess, C P

Publications and source records attributed to Burgess, C P.

7 records

NASA NTRS1940

The frequencies of cantilever wings in beam and torsional vibrations

Methods are described for calculating the period and frequency of vibration of cantilever wings and similar structures in which the weight and moment of inertia vary along the span. Both the beam and torsional frequencies may be calculated by these methods. The procedure is illustrated by examples. It is shown that a surprisingly close approximation to the beam frequency may be obtained by a very brief calculation in which the curvature of the wing in vibration is assumed to be constant. A somewhat longer computation permits taking account of the true curvature of the beam by a series of successive approximations which are shown to be strongly convergent. Analogous methods are applied to calculations of the torsional frequency. For the first approximation it is assumed that the angle of twist varies linearly alone the semispan. True variation of the twist is computed by successive approximations which are strongly convergent, as in the case of beam vibrations.

Burgess, C P↗

NASA NTRS1930

Speed and Deceleration Trials of U.S.S. Los Angeles

The trials reported in this report were instigated by the Bureau of Aeronautics of the Navy Department for the purpose of determining accurately the speed and resistance of the U. S. S. "Los Angeles" with and without water recovery apparatus, and to clear up the apparent discrepancies between the speed attained in service and in the original trials in Germany. The trials proved very conclusively that the water recovery apparatus increases the resistance about 20 per cent, which is serious, and shows the importance of developing a type of recovery having less resistance. Between the American and the German speed trials without water recovery there remains an unexplained discrepancy of nearly 6 per cent in speed at a given rate of engine revolutions. Warping of the propeller blades and small cumulative errors of observation seem the most probable causes of the discrepancy. It was found that the customary resistance coefficients C, are 0.0242 and 0.0293 without and with the water recovery apparatus, respectively. The corresponding values of the propulsive coefficient K, are 56.7 and 44.6. If there is an error in these figures, it is probably in a slight overestimate of C, and an underestimate of K. The maximum errors are almost certainly less than 5 per cent. No scale effect was detected indicating variation of C with respect to velocity (author)

De France, S J↗

NASA NTRS1930

Flight Tests on U.S.S. Los Angeles. Part II : Stress and Strength Determination

The tests described in this report furnished data on the actual aerodynamic forces, and the resulting stresses and bending moments in the hull of the U. S. S. "Los Angeles" during as severe still-air maneuvers as the airship would normally be subjected to, and in straight flight during as rough air as is likely to occur in service, short of squall or storm conditions. The maximum stresses were found to be within the limits provided for in accepted practice in airship design. Normal flight in rough air was shown to produce forces and stresses about twice as great as the most severe still-air maneuvers. No light was thrown upon the forces which might occur in extreme or exceptional conditions, such as the storm which destroyed the "Shenandoah". The transverse aerodynamic forces on the hull proper were found to be small and irregular. Owing to the necessity of conserving helium, it was impossible to fly the airship in a condition of large excess of buoyancy or weight in order to determine the air pressure distribution at a fixed angle of pitch. However, there is every reason to believe that in that condition the forces on the actual airship are as close to the wind-tunnel results as can be determined by present type of pressure measuring apparatus. It is considered that most important data obtained are the coefficients of tail-surface forces and hull-bending moments. These are tabulated in this report.

Burgess, C P↗

NASA NTRS1930

The torsional strength of wings

This report describes a simple method for calculating the position of the elastic axis of a wing structure having any number of spars. It is shown that strong drag bracing near the top and bottom of a wing greatly increases the torsional strength. An analytical procedure for finding the contribution of the drag bracing to the torsional strength and stiffness is described, based upon the principle of least work, and involving only one unknown quantity. A coefficient for comparing the torsional rigidity of different wings is derived in this report.

Burgess, C P↗

NASA NTRS1925

Forces on Airships in Gusts

In this report it is shown that determining the instantaneous angle of pitch, the acceleration of the gust is as important as its maximum velocity or yaw. Hitherto it has been assumed that the conditions encountered in gusts could be approximately represented by considering the airship to be at an instantaneous angle of yaw or pitch (according to whether the gust is horizontal or vertical), the instantaneous angle being tan to the (-1) power (v/v), where v is the component of the velocity of the gust at right angles to the longitudinal axis of the ship, and v is the speed of the ship. An expression is derived for this instantaneous angle in terms of the speed and certain aerodynamic characteristics of the airship, and of the maximum velocity and the acceleration of the gust, and the application of the expression to the determination of the forces on the ship is illustrated by numerical examples.

Burgess, C P↗

NASA NTRS1924

A method of determining the dimensions and horsepower of an airship for any given performance

A simple and easily applied method of calculating the dimensions and horsepower necessary for an airship to have any given performance is described and illustrated by examples. The method includes means for estimating the changes in performance or in size when modifications or new features are introduced into a design, involving increase or saving in weights, or changes in resistance or propulsive efficiency.

Burgess, C P↗

NASA NTRS1923

Bending moments, envelope, and cable stresses in non-rigid airships

This report describes the theory of calculating the principal stresses in the envelope of a nonrigid airship used by the Bureau of Aeronautics, United States Navy. The principal stresses are due to the gas pressure and the unequal distribution of weight and buoyancy, and the concentrated loads from the car suspension cables. The second part of the report deals with the variations of tensions in the car suspension cables of any type of airship, with special reference to the rigid type, due to the propeller thrust or the inclination of the airship longitudinally.

Burgess, C P↗