Engineering topics
Publications and source records attributed to Burke, J. J..
Our immediate objective is to understand the limitations of guided-wave and grating coupler devices in their application to optical data storage. Our long-range goal is to develop and validate design codes for integrated optic devices. The principal research activity was in the development of numerical models for the design of a blue wavelength integrated optical source for data storage applications.
Results of experiments designed to demonstrate spectrally selective absorption in dielectric waveguides on semiconductor substrates are reported. These experiments were conducted with three waveguides formed by sputtering films of PSK2 glass onto silicon-oxide layers grown on silicon substrates. The three waveguide samples were studied at 633 and 532 nm. The samples differed only in the thickness of the silicon-oxide layer, specifically 256 nm, 506 nm, and 740 nm. Agreement between theoretical predictions and measurements of propagation constants (mode angles) of the six or seven modes supported by these samples was excellent. However, the loss measurements were inconclusive because of high scattering losses in the structures fabricated (in excess of 10 dB/cm). Theoretical calculations indicated that the power distribution among all the modes supported by these structures will reach its steady state value after a propagation length of only 1 mm. Accordingly, the measured loss rates were found to be almost independent of which mode was initially excited. The excellent agreement between theory and experiment leads to the conclusion that low loss waveguides confirm the predicted loss rates.
Fukui et al. (1979) and Stegeman et al. (1982) have shown theoretically that surface plasmon polaritons can be guided over long distances by thin metal films bounded by identical dielectric media. In principle, the possibility arises for the propagation of highly localized fields. In order to obtain long propagation distances, most of the energy will have to be carried outside the metal. THis makess it necessary to operate near the mode cutoff condition. In the present investigation, it is shown that very small air gaps between the metal and dielectric surfaces will cause the mode to become radiative, and, therefore, no longer bounded to the metal film. Calculations show that gaps of dimension 100 A and less can cause severe problems in geometries relying on long range surface plasmon polaritons. High refractive index liquids placed in the gaps should alleviate these problems.
Surface polaritons guided by symmetric double metal film structures are analyzed, with particular attention given to the attenuation of the two long-range modes that occur. It is found that long-range surface plasmon polariton modes do exist for double electrode structures over a limited range of material parameters. Guided by thin metal electrodes, surface plasmon polaritons can achieve millimeter plus propagation distances in the near infrared. It is pointed out that if the slab is electrooptic, then very low voltages will be needed to manipulate the waves. The fact that long-range modes exist simultaneously with junction tunnel plasmons may be of use in providing directional radiation from light-emitting junctions or the inverse process of light to electrical energy conversion.
Surface-plasmon polaritons guided by thin, lossy metallic films bounded by dissimilar dielectric media are investigated. New solutions to the dispersion relation are found, representing waves that are leaky (radiative) in one of the dielectrics. The new waves are interpreted in terms of the coupling of a damped surface plasmon at one interface with continuum modes at the other. Their excitation by end-fire coupling techniques is suggested.
A number of high-resolution images of Jupiter's northern hemisphere were received from the imaging photopolarimeter (IPP) aboard Pioneer 11 in 1974. Erratic scanning of the IPP caused severe distortions in three scientifically important images, which until now have never been satisfactorily restored. New rectification and enhancement techniques, implemented on up-to-date image processing hardware, yielding images of sufficient quality to enable full scientific exploitation of the photometric data are reported.
The imaging photopolarimeter on Pioneer Saturn provided spin-scan images of Saturn's cloudtops. Only subtle departures from a uniform brightness distribution were apparent, except in the polar regions. At other latitudes the images show only a few features; they primarily support the conclusion that the visible atmosphere is a deep haze. Belts and zones are seen, and some detail in a zone near + or - 60 deg latitude. The North Equatorial Belt consists of two dark belts separated by a brighter zone exhibiting longitudinal structure.
The geometric distortions attendant to spin-scan imaging were extraordinarily manifest in the Pioneer encounter with Saturn. By overlapping graphical predictions of these distortions with raster scans of the raw intensity data, both displayed to the same scale on a Versatec printer-plotter, it is possible to determine the precise geometry of a data-taking sequence. The predictions are quite sensitive to the assumed dimensions of Saturn and its rings. It is accordingly concluded that the ratio of polar to equatorial radius is 0.91 and that the Encke gap is 133,500 km from Saturn's center.
A unique set of photometric and polarimetric observations made by the imaging photopolarimeter aboard the Pioneer spacecraft shortly after it penetrated the ring plane from above on its way to closest approach is reported. The bright planet limb is observed through the rings, which themselves weakly reflect direct sunlight. Polarizations range from 41% (16%) at the extreme planet limb to 2% (1.5%) at the darkest part of the B ring in the blue (red) channel. Detailed structure of the A ring is evident, most notably the Encke gap.
Results of Pioneer 11 imaging photopolarimeter observations of Saturn, its rings, and Titan are presented. The imaging photopolarimeter is a pointable telescope with an aperture of 2.5 cm and passbands of 390 to 500 to 720 nm which uses the spin of the spacecraft to scan across an object. Images of the Saturn system and of the rings are presented, and the absence of a D ring, structures in the C, B and A rings and the Cassini division and the discoveries of the F ring and the provisionally named Pioneer division separating it from the A ring are reported. A mean particle size less than 15 meters is estimated from estimates of total ring mass and the optical depth of the B ring. The discovery of the satellite 1979 S 1 at 2.53 Saturn radii is also noted. Models of the vertical aerosol structure of Saturn's atmosphere are compared with the polarization data, and it is indicated that the density of cloud particles decreases with altitude with a scale height about one fourth that of the gas, and that an optical depth of one is to be found at 750 mbar.
Images of Saturn received from Pioneer 11 suffer from geometrical distortions due to the curvilinear scan lines and the unequal sampling intervals in orthogonal directions, which are inherent in spin-scan imaging. In this paper geometrical image rectification by polynomial transformation based on control points is discussed. Factors that affect the accuracy of reconstruction are shown to include the spatial distribution and spatial density of control points, and the order of the polynomial distortion model. A computer implementation of the technique is described.
The signal-to-noise (S/N) ratio to be expected when a 180 deg rotationally shearing interferometer is used for image recovery at the diffraction limit of a large telescope is computed. The variance and covariance of the irradiance fluctuations at the detector array are shown to yield measures of the high-frequency spatial spectrum of the source. Four fundamental sources of noise are considered: temporal fluctuations of the source, space-time fluctuations of the atmosphere, shot noise in the detected photocurrents, and the effects of finite sampling. S/N is found to be directly proportional to the angular resolution of the telescope, the single-frame integration time, the square root of the number of frames, the cube of the operating wavelength, the quantum efficiency of the detector, and the average spectral irradiance from the source on the pupil. It is inversely proportional to the cube of the field angle subtended by the source (or part thereof) under study.
Ultrahigh speed electro-optical systems employing fiber optics
The need for a stable source of low-frequency power is often encountered in studies of recording-instruments performance. Indeed, in laboratory work involving the design and analysis of servo mechanisms in general, a low-frequency signal source is of paramount importance. The generator described herein was designed specifically to serve as a signal source for determination of the frequency characteristics of the various recording instruments in use at this Laboratory. Flexibility and convenience of operation in the dynamic testing of recording instruments characterize the generator which has been evolved.