Search NASA⌕ Search

Engineering topics

Burnette, C. F.

Publications and source records attributed to Burnette, C. F..

Bayesian classification of polarimetric SAR images using adaptive a priori probabilities

The problem of classifying earth terrain by observed polarimetric scattering properties is tackled with an iterative Bayesian scheme using a priori probabilities adaptively. The first classification is based on the use of fixed and not necessarily equal a priori probabilities, and successive iterations change the a priori probabilities adaptively. The approach is applied to an SAR image in which a single water body covers 10 percent of the image area. The classification accuracy for ocean, urban, vegetated, and total area increase, and the percentage of reclassified pixels decreases greatly as the iteration number increases. The iterative scheme is found to improve the a posteriori classification accuracy of maximum likelihood classifiers by iteratively using the local homogeneity in polarimetric SAR images. A few iterations can improve the classification accuracy significantly without sacrificing key high-frequency detail or edges in the image.

Van Zyl, J. J.↗

Inference of geophysical parameters from multifrequency polarimetric radar observations and model inversion

In summer 1988 an intensive field experiment was conducted in the vicinity of the Pisgah lava flow in the Mojave Desert. Physical properties such as microtopography, composition, soil moisture, and dielectric constant were measured at five sites representing surfaces with rms heights varying from less than one centimeter to tens of centimeters. In addition, polarimetric radar images at P-band, L-band, and C-band were acquired at three different incidence angles with the NASA/JPL airborne imaging radar polarimeter. Using trihedral corner reflectors deployed in the area prior to imaging, the L- and C-band images were calibrated to provide sigma0 values for each resolution element in the scene. The results of inferring geophysical parameters such as rms surface height and correlation length of the measured surfaces by fitting the observed signatures with those predicted by the small-perturbation model are presented: for smoother surfaces, the rms height values inferred are in good agreement with in situ measurements.

Van Zyl, J. J.↗