Search NASA⌕ Search

Engineering topics

Burns, George

Publications and source records attributed to Burns, George.

Proton radiation effects on electronic defect states in MOCVD-grown (010) β -Ga 2 O 3

The impact of 1.8 MeV proton irradiation on metalorganic chemical vapor deposition grown (010) β-Ga 2 O 3 Schottky diodes is presented. It is found that after a 10.8 × 10 13 cm –2 proton fluence the Schottky barrier height of (1.40 ± 0.05 eV) and the ideality factor of (1.05 ± 0.05 ) are unaffected. Capacitance–voltage extracted net ionized doping curves indicate a carrier removal rate of 268 ± 10 cm –1 . The defect states responsible for the observed carrier removal are studied through a combination of deep level transient and optical spectroscopies (DLTS/DLOS) as well as lighted capacitance–voltage (LCV) measurements. The dominating effect on the defect spectrum is due to the E c -2.0 eV defect state observed in DLOS and LCV. This state accounts for ~75 % of the total trap introduction rate and is the primary source of carrier removal from proton irradiation. Of the DLTS detected states, the E c -0.72 eV state dominated but had a comparably smaller contribution to the trap introduction. These two traps have previously been correlated with acceptor-like gallium vacancy-related defects. Several other trap states at E C -0.36, E C -0.63, and E C -1.09 eV were newly detected after proton irradiation, and two pre-existing states at E C -1.2 and E C -4.4 eV showed a slight increase in concentration after irradiation, together accounting for the remainder of trap introduction. However, a pre-existing trap at E c -0.40 eV was found to be insensitive to proton irradiation and, therefore, is likely of extrinsic origin. Furthermore, the comprehensive defect characterization of 1.8 MeV proton irradiation damage can aid the modeling and design for a range of radiation tolerant devices.

42 ENGINEERING↗

Full-field surface roughness

The various embodiments presented herein relate to utilizing light in conjunction with an optical Fourier transform to examine and quantify roughness of a surface. The surface includes a plurality of flaked particles. The surface is illuminated with a light beam, wherein light reflected from the surface passes through an f-theta lens and is collected at a light sensitive array (LSA). The LSA comprises light sensitive pixels. For an arrangement where the flakes are conformal with the surface, a low degree of light scattering occurs at the surface. For a surface comprising tipped and/or tilted flakes, a correlating degree of scattering of the incident light beam occurs. The surface roughness is quantified based upon the distribution of angular reflections of the scattered light represented in an image formed through use of the LSA.

36 MATERIALS SCIENCE↗