Engineering topics

Buzzard, Robert J.

Publications and source records attributed to Buzzard, Robert J..

3 records

NASA NTRS1991

Mode-II-Fracture Specimen And Holder

Test specimen and loading frame developed for fatigue and fracture testing of materials under mode-II (sliding-mode) loading. Assembly placed in compression-testing machine. Loads directed oppositely along centerline cause self-similar crack to propagate. Enables consistently accurate alignment of specimens before insertion of specimen/frame assemblies into compression-testing machine. Makes design attractive for testing in hostile environments in which access to machine or furnace limited. Additional feature, with little or no modification, placed horizontally into impact testing machine and subjected to loading at high speeds.

Buzzard, Robert J.↗

NASA NTRS1988

Mode 2 fracture mechanics

Current development of high-performance rolling element bearings for aircraft engines (up to 3 million DN, where DN is the product of shaft diameter in millimeters and speed in revolutions per minute) has aroused concern about fatigue crack growth in the inner bearing race that leads to catastrophic failure of the bearing and the engine. A failure sequence was postulated by Srawley, and an analytical program was undertaken to simulate fatigue crack propagation in the inner raceway of such a bearing. A fatigue specimen was developed at NASA by which fatigue data may be obtained relative to the cracking problems. The specimen may be used to obtain either mode 2 data alone or a combination of mixed-mode (1 and 2) data as well and was calibrated in this regard. Mixed-mode fracture data for M-50 bearing steel are presented, and a method for performing reversed-loading tests is described.

Buzzard, Robert J.↗

NASA NTRS1988

Calibration of a Mode II test specimen

Mode II and Mode I calibrations of the NASA Lewis Research Center Mode II fatigue specimen were performed experimentally over crack length to specimen width ratios (a/W) of 0.5 to 0.9. Mode II displacements were measured both at the specimen notch mouth and at the intersection of the notch with the centerline of the loading pin holes. Mode I displacements were measured across the span of the specimen at the loading pins' centerline. Analytical stress intensity factor coefficients for both Mode II and Mode I are also presented.

Buzzard, Robert J.↗