Engineering topics

Byvik, C. E.

Publications and source records attributed to Byvik, C. E..

At least 19 records

NASA NTRS1993

Development of superconducting YBa2Cu3O(x) wires with low resistance electrical contacts

Materials exhibiting superconductivity above liquid nitrogen temperatures (77 K) will enable new applications of this phenomena. One of the first commercial applications of this technology will be superconducting magnets for medical imaging. However, a large number of aerospace applications of the high temperature superconducting materials have also been identified. These include magnetic suspension and balance of models in wind tunnels and resistanceless leads to anemometers. The development of superconducting wires fabricated from the ceramic materials is critical for these applications. The progress in application of a patented fiber process developed by Clemson University for the fabrication of superconducting wires is reviewed. The effect of particle size and heat treatment on the quality of materials is discussed. Recent advances made at Christopher Newport College in the development of micro-ohm resistance electrical contacts which are capable of carrying the highest reported direct current to this material is presented.

Buoncristiani, A. M.↗

NASA NTRS1990

Spectroscopic Analysis Of Insulating Crystal Fibers

New method provides rapid characterization of optical properties. Technique for determining optical properties of insulating single-crystal fibers developed and applied to sapphire, spinel, and YAIO crystalline host fibers doped with triply ionized titanium. Crystal fibers grown more rapidly and less expensively.

Buoncristiani, A. M.↗

NASA NTRS1990

The effect of electron irradiation on YBa2Cu3O(x) with gold bead contacts

The effect of 1-MeV electron irradiation, up to a total dose of 5.7 x 10 to the 17th electrons/sq cm at room temperature on YBa2Cu3O(x) was investigated using gold bead contacts made by the melting technique. The superconducting transition temperature Tc, the critical current density Jc at 77 K, the normal-state resistivity, and the contact resistance for gold bead contacts were measured as a function of fluence on the same samples without disturbing the contacts. Tc remained constant at 91 K, and Jc at 77 K remained constant around 90 A/sq cm. The normal-state resistivity increased systematically by about 15 percent for the total dose. Finally, the surface contact resistance at 77 K remained less than 4.2 microohm sq cm throughout the radiations. These studies took place over an 8-month period, and subsequent measurements indicate that the results are definitely due to radiation effects and not aging effects. It is concluded that the superconductor YBa2Cu3O(x) with gold bead contacts would perform well in a space environment of electron irradiation.

Caton, R.↗

NASA NTRS1990

Low-resistance noble metal contacts to high-temperature superconductors

Low-resistance contacts were made to both YBa2Cu3O(7-x) and Bi2BaSr2Cu2O8, and to related superconducting compounds by melting gold or silver pads onto the samples before the final oxygen treatment. Scanning electron microscope studies show that both gold and silver do not diffuse far from the contact area. The surface contact resistivity of the best contacts made by the melting technique has an upper limit value in the 10 to the -8th ohm sq cm range at 77 K. This contact resistivity shows no significant change in its value over a period of 17 months. Furthermore, an electron radiation dose of 5.7 x 10 to the 17th electron/sq cm only doubled the contact resistivity.

Selim, R.↗

NASA NTRS1989

Optical materials for space based laser systems

The design features and performance characteristics of a sensitized holmium laser applicable to differential lidar and Doppler windshear measurements are presented, giving attention to the optimal choice of sensitizing/activating dopant ions. This development of a 2-micron region eye-safe laser, where holmium is sensitized by either hulium or erbium, has called for interionic energy transfer processes whose rate will not result in gain-switched pulses that are excessively long for atmospheric lidar and Doppler windshear detection. The application of diamond films for optical component hardening is noted.

Buoncristiani, A. M.↗

NASA NTRS1988

Spectroscopic analysis of insulating crystal fibers

A new technique is described for investigating the optical properties of solid-state laser materials using single-crystal fibers grown by a laser-heated pedestal-growth technique. Single-crystal fiber samples can be prepared more rapidly and less expensively than crystals grown by more conventional methods; however, they are smaller and less uniform, making spectroscopic measurements difficult. A simple procedure for extracting the optical absorption and emission spectra of insulating crystal fibers is demonstrated with a titanium-doped sapphire fiber sample; results are comparable to those from Czochralski-grown material.

Buoncristiani, A. M.↗

NASA NTRS1988

Effects of tensile stress on the R lines of Cr(3+) in a sapphire fiber

The spectroscopic properties of a crystalline sapphire fiber unintentionally dOed with Cr(3+) are investigated. It is found that tensile stress produces blue shifts of the R lines and changes in their radiative lifetimes and integrated intensities that can be correlated to stress-induced changes of the crystal-field parameters.

Liu, Huimin↗

NASA NTRS1988

Rugged low-resistance contacts to YBa2Cu3O(x)

Rugged low-resistance contacts to a high-T(c) superconductor YBa2Cu3O(x) were made by melting gold onto the sample surface, where it diffused into the sample pores making a strong mechanical contact in the form of a bead. Contact resistances lower than 50 microohm were obtained, allowing passage, without heating, of a direct current of about 5 A while the sample remained in the superconducting state at 20 K. Results of SEM and of contact-resistance, critical-current, and shear-strength measurements on these contacts are included.

Caton, R.↗

NASA NTRS1988

Free-flying experiment to measure the Schawlow-Townes linewidth limit of a 300 THz laser oscillator

Recent advances in laser diode-pumped solid state laser sources permit the design and testing of laser sources with linewidths that approach the Schawlow-Townes limit of 1 Hz/mW of output power. Laser diode pumped solid state ring oscillators have been operated with CW output power levels of 25 mW at electrical efficiencies that exceed 6 percent. These oscillators are expected to operate for lifetimes that approach those of the laser diode sources which is now approaching 20,000 hours. The efficiency and lifetime of these narrow linewidth laser sources will enable space measurements of gravity waves, remote sensing applications (including local range rate and measurements), and laser sources for frequency and time standards. A free-flight experiment, 'SUNLITE', is being designed to measure the linewidth of this all-solid-state laser system.

Byer, R. L.↗

NASA NTRS1988

Advances in solid state laser technology for space and medical applications

Recent developments in laser technology and their potential for medical applications are discussed. Gas discharge lasers, dye lasers, excimer lasers, Nd:YAG lasers, HF and DF lasers, and other commonly used lasers are briefly addressed. Emerging laser technology is examined, including diode-pumped lasers and other solid state lasers.

Byvik, C. E.↗

NASA NTRS1988

Laser induced fluorescence of dental caries

Significant differences between the optical spectra taken from sound regions of teeth and carious regions have been observed. These differences appear both in absorption and in laser induced fluorescence spectra. Excitation by the 488 nm line of an argon ion laser beam showed a peak in the emission intensity around 553 nm for the sound dental material while the emission peak from the carious region was red-shifted by approximately 40 nm. The relative absorption of carious region was significantly higher at 488 nm; however its fluorescence intensity peak was lower by an order of magnitude compared to the sound tooth. Implications of these results for a safe, reliable and early detection of dental caries are discussed.

Albin, S.↗

NASA NTRS1986

Calculating Charge Transport in Semiconductors

Method, called flux method, improvement over conventional methods, easy to use, and applies in operating regime not accessible to conventional macroscopic methods. Key concept of flux method follows behavior of particle flux rather than concentration of particles. Method not subject to limitations that follow from local or infinitesimal analysis.

Byvik, C. E.↗

NASA NTRS1986

Development in tunable solid state lasers with high spectral purity, high efficiency and long lifetime for differential absorption lidar

The paper presents a review of tunable vibronic solid state lasers for DIAL measurements and provides new experimental results for tunable Ti:sapphire lasers, materials development, and spectral bandwidth narrowing through injection control. Pulsed injection control of a Ti:sapphire laser with a 2.5-pm narrow band pulsed dye laser and with another Ti:sapphire laser is demonstrated with nearly complete energy extraction, indicating homogeneous line broadening. The status of tunable solid state lasers in the 1.6-2.3 micron range for DIAL measurements of trace gases, and development trends for lasers with reduced cryogenic cooling needs, are included. The effects of laser gain on optical damage, energy extraction, and amplified spontaneous emission are indicated for several tunable lasers.

Hess, R. V.↗

NASA NTRS1985

Analysis of vibronic transitions in titanium doped sapphire using the temperature of the fluorescence spectra

An analysis of the fluorescence spectra of titanium-doped sapphire crystals for temperatures ranging from 13 to 578 K is made. Zero- and multiphoton assisted electronic transitions are observed at temperatures below 125 K. Zero-phonon transition energies agree with previously reported measured and predicted values. Photon-assisted transitions suggest that two principle modes of lattice vibrations with energies of 220 and 260/cm are coupled to the electronic 2T2g state. A single phonon energy of 173/cm is observed to couple to the 2Eg electronic state. Crossover energy is estimated to be about 11,800/cm using a simple harmonic approximation. Lineshape analysis is performed. The fluorescence lifetime as measured to be a constant 3.9 microsec below 150 k decreasing to 2.9 microsec at 300 K.

Byvik, C. E.↗

NASA NTRS1985

Solar-Assisted Oxidation of Toxic Cyanide

In solar-assisted oxidation technique, oxygen-bearing air bubbled through cyanide solution in which platinized powdered TiO2 is suspended. Light from either artifical source or natural Sunlight irradiates. Experiments demonstrated this technique effective in reducing concentration of cyanide to levels well below those achieved by other methods. Results suggest effective and inexpensive method for oxidizing cyanide in industrial wastewaters.

Byvik, C. E.↗

NASA NTRS1985

Method for determining the point of zero zeta potential of semiconductor

A method to determine the potential of zero charge of an unpowdered semiconductor material is presented. The semiconductor material is used as the working electrode of a standard three electrode photoelectrochemical cell. The onset potential of the semiconductor material is measured at several different cell temperatures. The slope of the graph of onset potential versus temperature is used to compute the potential of zero charge.

Reichman, B.↗

NASA NTRS1985

Absorption and fluorescence of alexandrite and of titanium in sapphire and glass

The fluorescence and absorption data for titanium in crystalline sapphire and titanium doped into two silicate and one phosphate glass structures are analyzed. It is observed that the Ti-doped silicate glass sample exhibits no absorption related to the Ti(III) ion, the Ti-doped phosphate glass is deep blue, the absorption line width of the glass samples are a factor of two larger than that of sapphire, and the absorption peak for the Ti in the glass shifted about 100 nm to the red from the Ti:sapphire absorption peak. This shift reveals that the Ti(III) ion is sensitive to the crystalline environment and not to the glass environment. The photoluminescence spectra for Ti-doped sapphire and alexandrite are compared. It is detected that the Ti:sapphire exhibits a broader spectrum than that for alexandrite with a peak at 750 nm. The three zero phonon transitions of Ti:Al2O3 at liquid nitrogen temperatures are studied.

Byvik, C. E.↗

NASA NTRS1984

Photoelectrochemical cells including chalcogenophosphate photoelectrodes

Photoelectrochemical cells employing chalcogenophosphate (MPX3) photoelectrodes are described where M is selected from the group of transition metal series of elements beginning with scandium (atomic number 21) through germanium (atomic number 32) yttrium (atomic number 39) through antimony (atomic number 51) and lanthanum (atomic number 57) through polonium (atomic number 84); P is phosphorus; and X is selected from the chalogenide series consisting of sulfur, selenium, and tellurium. These compounds have bandgaps in the desirable range from 2.0 eV to 2.2 eV for the photoelectrolysis of water and are stable when used as photoelectrodes for the same.

Reichman, B.↗