Search NASA⌕ Search

Engineering topics

C. I. Honniball

Publications and source records attributed to C. I. Honniball.

4 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2022

Simulated Lunar Surface Hydration Measurements using Multispectral Lidar at 3 µm

Accurately measuring the variability of spectroscopic signatures of hydration (H2O + OH) on the illuminated lunar surface at 3 µm as a function of latitude, lunar time of day, and composition is crucial to determining the generation and destruction mechanisms of OH species and understanding the global water cycle. A prime complication in analysis of the spectroscopic feature is the accurate removal of thermal emission, which can modify or even eliminate the hydration feature depending on the data processing methods used and assumptions made. An orbital multispectral lidar, with laser illumination at key diagnostic wavelengths, would provide uniform, zero-phase geometry, complete latitude and time of day coverage from a circular polar orbit, and is agnostic to the thermal state of the surface. We have performed measurement simulations of a four-wavelength multispectral lidar using spectral mixtures of hydrated mid-ocean ridge basalt (MORB) glasses and lunar regolith endmembers to assess the lidar performance in measuring hydration signatures on the lunar surface. Our results show a feasible system with wavelengths at 1.5 µm, 2.65 µm, 2.8 µm, and 3.1 µm can measure lunar hydration with a precision of 52 ppm (1σ) or better. These results, combined with the uniform measurement capabilities of multispectral lidar make it a valuable spectroscopic technique for elucidating mechanisms of OH/H2O generation, migration, and destruction.

D. R. Cremons↗
NASA NTRS2021

Hydroxylation of Apollo 17 Soil Sample 78421 by Solar Wind Protons

Hydroxylation by solar wind protons has been simulated in our laboratory on Apollo 17 lunar sample 78421, a very mature regolith sample that is rich with agglutinates (68%). The goal of this study was to determine the rate of hydroxyl formation and their thermal stability by monitoring changes in the SiOH (hydroxyl) stretching band near 3 μm using diffuse reflectance FTIR spectroscopy (DRIFTS). A 2 keV H2+ ion beam was used to simulate proton implantation on 78421 and on a crushed fused silica sample. We find that the OH band does not change unless the samples have been annealed in vacuum prior to irradiation. Qualitatively, the OH bands for the fused silica and 78421 are very different. The OH band for fused silica is centered at 2.74 μm and is relatively sharp ranging from 2.67 - 3.1 μm at full-width-at-half-maximum (FWHM), while the OH band for 78421 is centered at 3.0 μm and ranges from 2.74 - 3.37 μm at FWHM. The increase in wavelength and broadened nature of the OH band in 78421 may be associated with the OH’s proximity to surface defects and/or lattice vacancies. The lack of the H2O bending mode at 6.1 μm indicates that any adsorbed terrestrial H2O is below our detection limit, and therefore the H2O stretching mode at 2.9 μm is not significantly contributing to the broad 3 μm OH band and implies that proton implantation by itself does not lead to water formation. To simulate the maximum dayside temperature on the lunar surface, the lunar sample was heated after proton irradiation. The proton induced OH concentration was reduced by as much as 25% after heating to 400 K (127 °C).

Apollo 17↗
NASA NTRS2020

Telescopic Observations of Lunar Hydration: Variations and Abundance

Prior to 2009, the Moon was believed to be anhydrous. However, observations by three spacecraft revealed a hydrated surface by reporting a 3 μm absorption band attributed to hydroxyl and possibly molecular water. The Moon Mineralogy Mapper (M3) spectrometer, onboard the Chandrayaan-1 spacecraft is mainly used to study the lunar 3 μm band but its spectral range ends at 3 μm. The limited wavelength range of M3 has allowed observed variations in the 3 μm band to be called into question due to uncertainties in thermal corrections. To investigate the validity of variations in the lunar 3 μm band, we used the SpeX infrared spectrograph at the NASA InfraRed Telescope Facility at Maunakea Observatory in Hawaiʻi. With SpeX, we are able to obtain lunar data over a wavelength range of 1.67 to 4.2 μm at 1 – 2 km spatial resolution. The long wavelengths provide strong constraints on thermal emission corrections. We confirm that the 3 μm band varies with lunar time of day as well as with latitude and composition. Each observation reveals strong variations in abundances of hydroxyl and possibly molecular water. The data reveal a decrease in abundance with increasing lunar local time, an asymmetric trend about the equator that favors the southern latitudes, and higher concentrations in highland regions. The longer wavelengths provided by SpeX have allowed us to examine variations in the 3 μm band and provide definitive evidence that the variations are due to changes in hydration.

C. I. Honniball↗