Search NASA⌕ Search

Engineering topics

Cai, Xuqing

Publications and source records attributed to Cai, Xuqing.

Incorporating Diurnal and Meter-Scale Variations of Ambient CO 2 Concentrations in Development of Direct Air Capture Technologies

To be implemented on climate-relevant scales, direct air capture of CO 2 (DAC) will require large capital-intensive facilities and careful attention to cost minimization. In making decisions among potential sites for DAC facilities, all of the factors that will impact process cost and efficiency should be considered. In this paper we focus on a factor that has previously received little attention in the DAC community, namely variations in atmospheric conditions on hourly time scales and length scales of meters. We present data curated from extensive previous studies of biosphere-atmosphere fluxes with observations of CO 2 concentration, temperature, and relative humidity (RH) with hourly resolution from many sites in North America. These include locations where typical diurnal variations in CO 2 concentration during summer months exceeds 150 ppm. These variations are larger than the seasonal variations that exist between averaged CO 2 concentrations in winter and summer, and they are highly correlated with diurnal variations in temperature and RH. Diurnal variations are dependent on the height above ground at which CO 2 concentrations are measured, with smaller variations existing at heights of 10 m or more than at ground level. We illustrate the potential implications of these short-term variations for the operation and optimization of a DAC process with process-level calculations for a specific adsorption-based process using amine-rich adsorbents.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

“Hybridizing heat-integrated 3D printed modules with mass manufacturable, low pressure drop fiber sorbents” (Final Report)

The overall objective of this proposal was to research, develop, and evaluate a modular direct air capture (DAC) system that is simple and scalable. This system was based on the adsorption of CO 2 into commercial polyamines supported by porous fiber sorbents, which can be produced at kilometer per hour scales using our pre-pilot spinning line. We have housed these fiber materials in novel 3D printed modular housing systems that provide easy-to-manufacture and localized heat integration and flow control. This hybridization of fiber sorbent technology with modular housing provided several advantages that led to lower air pressure drops, higher sorbent productivity, as well as ease of manufacturing and assembly unrivaled by existing and emerging heat integrated contactor designs. The modular housing was fabricated with the following features, at a minimum: (i) a tapered air intake to reduce pressure drop related to entrance effects, (ii) a structured network of heat transfer channels to enable localized cooling and heating during adsorption and desorption, respectively, and (iii) low pressure drop supports for the fiber sorbents. This hybrid manufacturing approach provides a facile method for taking fiber sorbents from lab scale to pilot scale as it dramatically simplifies the fabrication of heat integrated contactor structures.

42 ENGINEERING↗