Engineering topics

Campbell, P.

Publications and source records attributed to Campbell, P..

9 records

NASA NTRS2015

Next Generation UAS Based Spectral Systems for Environmental Monitoring

This presentation provides information on the development of a small Unmanned Aerial System(UAS) with a low power, high performance Intelligent Payload Module (IPM) and a hyperspectral imager to enable intelligent gathering of science grade vegetation data over agricultural fields at about 150 ft. The IPM performs real time data processing over the image data and then enables the navigation system to move the UAS to locations where measurements are optimal for science. This is important because the small UAS typically has about 30 minutes of battery power and therefore over large agricultural fields, resource utilization efficiency is important. The key innovation is the shrinking of the IPM and the cross communication with the navigation software to allow the data processing to interact with desired way points while using Field Programmable Gate Arrays to enable high performance on large data volumes produced by the hyperspectral imager.

onboard processing↗

NASA NTRS2010

Diurnal and Directional Responses of Chlorophyll Fluorescence and the PRI in a Cornfield

Determining the health and vigor of vegetation using high spectral resolution remote sensing is an important goal which has application to monitoring agriculture and ecosystem productivity and carbon exchange. Two spectral indices used to assess whether vegetation is performing near-optimally or exhibiting symptoms of environmental stress (e.g., drought or nutrient deficiency, non-optimal temperatures, etc.) are the Photochemical Reflectance Index (PRI) and solar-induced red and far-red Chlorophyll Fluorescence (Fs). Both the PRI and Fs capture the dynamics of photoprotection mechanisms within green foliage: the PRI is based on the association of the reflected radiation in the green spectrum with the xanthophyll cycle, whereas Fs measures the emitted radiation in the red and far-red spectrum. Fs was determined from retrievals in the atmospheric oxygen absorption features centered at 688 and 760 nm using a modified Fraunhofer Line Depth (FLD) method. We previously demonstrated diurnal and seasonal PRI differences for sunlit vs. shaded foliage in a conifer forest canopy, as expressed in the hotspot and darkspot of the Bidirectional Reflectance Function (BRF). In a USDA-ARS experimental field site located in Beltsville, MD, USA, measurements were acquired over a corn crop from a nadir view in 2008 with an ASD FieldSpec Pro (Analytical Spectral Devices, Inc., Boulder, CO, USA) to study the behavior of the PRI for sunlit and shaded foliage as captured in reflectance variations associated with the BRF, in a I m tall canopy in the vegetative growth stage. Those observations were compared to simulations obtained from two radiative transfer models. Measurements were then acquired to examine whether the PRI and Fs were influenced by view zenith and azimuth geometries at different times of day. Those measurements were made in 2010 with the Ocean Optics USB4000 Miniature Fiber Optic Spectrometer (Ocean Optics Inc., Dunedin, Florida, USA) at several times during the day on multiple days throughout the growing season. We found that the PRI consistently had higher values, indicating lower stress, in the BRF darkspot associated with shaded foliage than in the hotspot associated with sunlit foliage. We also found that Fs exhibited differences associated with sunlit and shaded canopy sectors, which were most pronounced for the red/far-red Fs ratio. Values indicated greater physiological stress in afternoons compared to mornings, and in the early senescent canopy as compared to the vegetative growth stage, BRFs for both the PRI and the red/far-red Fs ratio were bowl-shaped for the full azimuth sweep of the canopy. These two spectral indices (PRI, Fs ratio) provided complementary information on the photosynthetic function of the corn canopy.

Middleton, Elizabeth↗

NASA NTRS1999

In vitro activities of four xyloglucan endotransglycosylases from Arabidopsis

Xyloglucan endotransglycosylases (XETs) are encoded by a gene family in Arabidopsis thaliana. These enzymes modify a major structural component of the plant cell wall, xyloglucan, and therefore may influence plant growth and development. We have produced four Arabidopsis XETs (TCH4, Meri-5, EXGT and XTR9) using the baculovirus/insect cell system and compared their biochemical activities. TCH4, as previously demonstrated, and the other three proteins are capable of carrying out transglycosylation of xyloglucans. The K(m) for XLLGol acceptor oligosaccharide is in the range of 20-40 microM for all the XETs except XTR9, which has a Km of 5 microM and is significantly inhibited by high levels of XLLGol. All four enzymes are most active between pH 6.0 and 6.5. TCH4 and XTR9 have temperature optima of 18 degrees C, whereas Meri-5 and EXGT are most active at 28 and 37 degrees C, respectively. Although the activity levels of three of the XETs are not influenced by the presence of fucose on the xyloglucan polymer, XTR9 has a clear preference for non-fucosylated xyloglucan polymer. The four XETs show a marked preference for XLLGol over either XXFGol or XXXGol as acceptor oligosaccharide. All four XETs are glycosylated; however, only the activities of TCH4 and Meri-5 are affected by the removal of the N-glycan with PNGase F. These four enzymes most likely function solely as transglycosylases because xyloglucan endoglucanase activity was not apparent. Subtle differences in biochemical activities may influence the physiological functions of the distinct XETs in vivo.

Non-NASA Center↗

NASA NTRS1998

Co- and/or post-translational modifications are critical for TCH4 XET activity

TCH4 encodes a xyloglucan endotransglycosylase (XET) of Arabidopsis thaliana. XETs endolytically cleave and religate xyloglucan polymers; xyloglucan is one of the primary structural components of the plant cell wall. Therefore, XET function may affect cell shape and plant morphogenesis. To gain insight into the biochemical function of TCH4, we defined structural requirements for optimal XET activity. Recombinant baculoviruses were designed to produce distinct forms of TCH4. TCH4 protein engineered to be synthesized in the cytosol and thus lack normal co- and post-translational modifications is virtually inactive. TCH4 proteins, with and without a polyhistidine tag, that harbor an intact N-terminus are directed to the secretory pathway. Thus, as predicted, the N-terminal region of TCH4 functions as a signal peptide. TCH4 is shown to have at least one disulfide bond as monitored by a mobility shift in SDS-PAGE in the presence of dithiothreitol (DTT). This disulfide bond(s) is essential for full XET activity. TCH4 is glycosylated in vivo; glycosidases that remove N-linked glycosylation eliminated 98% of the XET activity. Thus, co- and/or post-translational modifications are critical for optimal TCH4 XET activity. Furthermore, using site-specific mutagenesis, we demonstrated that the first glutamate residue of the conserved DEIDFEFL motif (E97) is essential for activity. A change to glutamine at this position resulted in an inactive protein; a change to aspartic acid caused protein mislocalization. These data support the hypothesis that, in analogy to Bacillus beta-glucanases, this region may be the active site of XET enzymes.

NASA Discipline Cell Biology↗

NASA NTRS1997

Plant responses to environmental stress: regulation and functions of the Arabidopsis TCH genes

Expression of the Arabidopsis TCH genes is markedly upregulated in response to a variety of environmental stimuli including the seemingly innocuous stimulus of touch. Understanding the mechanism(s) and factors that control TCH gene regulation will shed light on the signaling pathways that enable plants to respond to environmental conditions. The TCH proteins include calmodulin, calmodulin-related proteins and a xyloglucan endotransglycosylase. Expression analyses and localization of protein accumulation indicates that the potential sites of TCH protein function include expanding cells and tissues under mechanical strain. We hypothesize that at least a subset of the TCH proteins may collaborate in cell wall biogenesis.

Review, Tutorial↗

NASA NTRS1996

Life in a changing world: TCH gene regulation of expression and responses to environmental signals

The Arabidopsis TCH genes were discovered as a consequence of their marked upregulation of expression in response to seemingly innocuous stimuli such as touch. Further analyses have indicated that these genes are upregulated by a variety of diverse stimuli. Understanding the mechanism(s) and factors that control TCH gene regulation will shed light on the signaling pathways that enable plants to respond to changing environmental conditions. The TCH proteins include calmodulin, calmodulin-related proteins and a xyloglucan endotransglycosylase. Expression analyses and localization of protein accumulation indicate that the potential sites of TCH protein function include expanding cells and tissues under mechanical strain. We hypothesize that the TCH proteins may collaborate in cell wall biogenesis.

NASA Discipline Plant Biology↗

NASA NTRS1981

Axial-field permanent magnet motors for electric vehicles

The modelling of an anisotropic alnico magnet for the purpose of field computation involves assigning a value for the material's permeability in the transverse direction. This is generally based upon the preferred direction properties, being all that are easily available. By analyzing the rotation of intrinsic magnetization due to the self demagnetizing field, it is shown that the common assumptions relating the transverse to the preferred direction are not accurate. Transverse magnetization characteristics are needed, and these are given for Alnico 5, 5-7, and 8 magnets, yielding appropriate permeability values.

Campbell, P.↗

NASA NTRS1980

Electric vehicle traction motors - The development of an advanced motor concept

An axial-field permanent magnet traction motor is described, similar to several advanced motors that are being developed in the United States. This type of machine has several advantages over conventional dc motors, particularly in the electric vehicle application. The rapidly changing cost of magnetic materials, particularly cobalt, makes it important to study the utilization of permanent magnet materials in such machines. The impact of different magnets on machine design is evaluated, and the advantages of using iron powder composites in the armature are assessed.

Campbell, P.↗

NASA NTRS1978

HEAO observations of X-ray bursts from MXB1730-335

The March 18, 1978 burst activity of the rapid burster MXB 1730-335 was studied by examining 58 minutes of quick-look data for the A2 and A4 experiments on HEAO 1. Very large, moderately sized, and small bursts are characterized. Type II bursts were found to show a spectral softening during burst decay. The existence of flux was sought in the 85-160 keV energy range, and it was found that the large type II bursts contain less than 5% of their total X-ray energy in this range. The implications of the lack of a hard X-ray flux with respect to accretion instability models of X-ray bursts are considered.

Hoffman, J. A.↗