Search NASA⌕ Search

Engineering topics

Carl Russell

Publications and source records attributed to Carl Russell.

4 records
All sourcesNASA NTRSDOE OSTI
NASA NTRSDate not supplied

The Multirotor Test Bed – A New NASA Test Capability for Advanced VTOL Rotorcraft Configurations

In November 2019, NASA completed the first wind tunnel test entry of the Multirotor Test Bed (MTB), a new test capability for advanced VTOL rotorcraft configurations. The MTB had been under development since 2017 when the need arose for an easily reconfigurable test stand for multirotor aircraft configurations. With the wide-ranging assortment of aircraft currently targeted at Urban Air Mobility and Unmanned Aircraft System applications, there is a need for validation data that will increase confidence in the computational modeling tools being used to develop these platforms. The MTB fills this need. This paper describes the key features of the MTB as well as its first wind tunnel test entry. A selection of results from the test is presented here, demonstrating the flexible configuration of the MTB and the types of data researchers can generate using this new test capability.

Multirotor Test Bed↗
NASA NTRSDate not supplied

Comparing RotCFD Predictions of the Multirotor Test Bed with Experimental Results

The Multirotor Test Bed (MTB) is a new capability for testing a wide array of advanced vertical take-off and landing (VTOL) rotor configurations, with a primary focus on testing in the U.S. Army 7- by 10-ft Wind Tunnel at NASA Ames Research Center. The MTB was designed to allow adjustment of the vertical, lateral, and longitudinal placement of each rotor, as well as allow tilt adjustment of each rotor and pitch adjustment of the whole assembly. Each rotor can tilt forward 90 deg and backwards 5 deg. In addition, the entire MTB can tilt forward 20 deg and backwards 10 deg. This flexibility allows the system to be tested in many different configurations. There is a six-axis load cell under each rotor assembly, to measure both the steady and dynamic loads produced by each rotor. The wind tunnel scales can measure loads on the full assembly. The overall goal of the MTB project is to help gain a better understanding of the performance, control, interactional aerodynamics, and acoustics of multirotor systems. A hybrid CFD tool called RotCFD (Rotorcraft Computational Fluid Dynamics) was used to simulate the MTB in several testing configurations. This paper explains the method of running the RotCFD simulations and explores the results from the simulations. The objective of this paper is to compare the RotCFD simulation results with the MTB wind tunnel test data, seeking to further validate RotCFD for multirotor systems and assess the influence of aerodynamic interactions on individual rotor performance.

RotCFD↗