Search NASASearch

Engineering topics

Carlson, Ann B.

Publications and source records attributed to Carlson, Ann B..

At least 19 records

Evaluation of Time-Averaged CERES TOA SW Product Using CAGEX Data

A major component in the analysis of the Earth's radiation budget is the recovery of daily and monthly averaged radiative parameters using noncontinuous spatial and temporal measurements from polar orbiting satellites. In this study, the accuracy of the top of atmosphere (TOA) shortwave (SW) temporal interpolation model for the Clouds and the Earth's Radiant Energy System (CERES) is investigated using temporally intensive half-hourly TOA fluxes from the CERES/ARM/GEWEX Experiment (CAGEX) over Oklahoma (Charlock et al., 1996).

Carlson, Ann B.

Earth Radiation Budget Experiment (ERBE) Data Sets for Global Environment and Climate Change Studies

For a number of years there has been considerable interest in the earth's radiation budget (ERB) or energy balance, and entails making the best measurements possible of absorbed solar radiation, reflected shortwave radiation (RSW), thermal outgoing longwave radiation (OLR), and net radiation. ERB data are fundamental to the development of realistic climate models and studying natural and anthropogenic perturbations of the climate. Much of the interest and investigations in the earth's energy balance predated the age of earth-orbiting satellites (Hunt et al., 1986). Beginning in the mid 1960's earth-orbiting satellites began to play an important role in making measurements of the earth's radiation flux although much effort had gone into measuring ERB parameters prior to 1960 (House et al., 1986). Beginning in 1974 and extending until the present time, three different satellite experiments (not all operating at the same time) have been making radiation budget measurements almost continually in time. Two of the experiments were totally dedicated to making radiation budget measurements of the earth, and the other experiment flown on NOAA sun-synchronous AVHRR weather satellites produced radiation budget parameters as a by-product. The heat budget data from the AVHRR satellites began collecting data in June 1974 and have operated almost continuously for 23 years producing valuable data for long term climate monitoring.

Bess, T. Dale

DSMC Grid Methodologies for Computing Low-Density, Hypersonic Flows About Reusable Launch Vehicles

Two different grid methodologies are studied for application to DSMC simulations about reusable launch vehicles. One method uses an unstructured, tetrahedral grid while the other uses a structured, variable-resolution Cartesian grid. The relative merits of each method are discussed in terms of accuracy, computational efficiency, and overall ease of use. Both methods are applied to the computation of a low-density, hypersonic flow about a winged single-stage-to-orbit reusable launch vehicle concept at conditions corresponding to an altitude of 120 km. Both methods are shown to give comparable results for both surface and flowfield quantities as well as for the overall aerodynamic behavior. For the conditions simulated, the flowfield about the vehicle is very rarefied but the DSMC simulations show significant departure from free-molecular predictions for the surface friction and heat transfer as well as certain aerodynamic quantities.

Wilmoth, Richard G.

Monte Carlo simulation of radiating reentry flows

The Direct Simulation Monte Carlo (DSMC) method is applied to a radiating, hypersonic, axisymmetric flow over a blunt body in the near continuum regime. The ability of the method to predict the flowfield radiation and the radiative heating is investigated for flow over the Project Fire II configuration at 11.36 kilometers per second at an altitude of 76.42 kilometers. Two methods that differ in the manner in which they treat ionization and estimate electronic excitation are employed. The calculated results are presented and compared with both experimental data and solutions where radiation effects were not included. Differences in the results are discussed. Both methods ignore self absorption and, as a result, overpredict measured radiative heating.

Taylor, Jeff C.

Monte Carlo simulation of a near-continuum shock-shock interaction problem

A complex shock interaction is calculated with direct simulation Monte Carlo (DSMC). The calculation is performed for the near-continuum flow produced when an incident shock impinges on the bow shock of a 0.1 in. radius cowl lip for freestream conditions of approximately Mach 15 and 35 km altitude. Solutions are presented both for a full finite-rate chemistry calculation and for a case with chemical reactions suppressed. In each case, both the undisturbed flow about the cowl lip and the full shock interaction flowfields are calculated. Good agreement has been obtained between the no-chemistry simulation of the undisturbed flow and a perfect gas solution obtained with the viscous shock-layer method. Large differences in calculated surface properties when different chemical models are used demonstrate the necessity of adequately representing the chemistry when making surface property predictions. Preliminary grid refinement studies make it possible to estimate the accuracy of the solutions.

Carlson, Ann B.

Shock interference prediction using direct simulation Monte Carlo

The shock interaction produced when an incident shock impinges on an inlet cowl lip is investigated for a cowl lip radius of 0.1 in. and flight conditions of Mach 15 and 35-km altitude. This problem is of interest in the design of hypersonic flight vehicles because the interference heating at the cowl lip surface from such a shock interaction is expected to be very high and the design of adequate thermal protection in this region will be challenging. Noncontinuum effects may be significant at this combination of altitude and small dimensions. If this is so, a computational solution based on the Navier-Stokes equations could significantly overpredict the surface heating on the cowl lip. Therefore, a kinetic theory solution technique, direct simulation Monte Carlo (DSMC), is used to predict the flowfield and surface heating. The details of modeling this problem and some preliminary results are presented. The same qualitative flow patterns are seen with DSMC and a continuum solution of the shock interference case, but the peak heating predicted with DSMC is somewhat lower.

Carlson, Ann B.

Monte Carlo simulation of reentry flows with ionization

The Direct Simulation Monte Carlo method is applied to a rarefied, weakly ionized, hypersonic flow over a blunt axisymmetric body. An ionization model based on the concept of ambipolar diffusion is used and a model for the sheath is presented. The effects of the new modeling techniques are investigated for flow over the Project Fire II configuration at 11.37 km/s at an altitude of 84.6 km. The calculated results are presented and compared with both experimental data and solutions where ionization effects were not included. In general, the calculated results overpredict the experimental values by about 15-20 percent.

Taylor, Jeff C.

Procedure for Adapting Direct Simulation Monte Carlo Meshes

A technique is presented for adapting computational meshes used in the G2 version of the direct simulation Monte Carlo method. The physical ideas underlying the technique are discussed, and adaptation formulas are developed for use on solutions generated from an initial mesh. The effect of statistical scatter on adaptation is addressed, and results demonstrate the ability of this technique to achieve more accurate results without increasing necessary computational resources.

Woronowicz, Michael S.

Radiation modeling with direct simulation Monte Carlo

Improvements in the modeling of radiation in low density shock waves with direct simulation Monte Carlo (DSMC) are the subject of this study. A new scheme to determine the relaxation collision numbers for excitation of electronic states is proposed. This scheme attempts to move the DSMC programs toward a more detailed modeling of the physics and more reliance on available experimental data. The new method is compared with the current modeling technique and both techniques are compared with available data. The differences in the results are evaluated. The test case is based on an AVCO-Everett shock tube experiment, a 10-km/s standing shock wave in air at 0.1 Torr. The new method agrees with the available data as well as the results from the earlier scheme and is more easily extrapolated to different flow conditions.

Carlson, Ann B.

Direct Simulation Monte Carlo with ionization and radiation

The Direct Simulation Monte Carlo (DSMC) method is applied to a 10 km/s flow at 0.1 torr. The assumptions used to model plasmas and electronic excitation with DSMC are investigated and new models for these processes are proposed. The results from the new modeling techniques are compared with results obtained using the previous models and the significant differences are discussed.

Carlson, Ann B.

Radiation Modeling with Direct Simulation Monte Carlo

Improvements in the modeling of radiation in low density shock waves with direct simulation Monte Carlo (DSMC) are the subject of this study. A new scheme to determine the relaxation collision numbers for excitation of electronic states is proposed. This scheme attempts to move the DSMC programs toward a more detailed modeling of the physics and more reliance on available rate data. The new method is compared with the current modeling technique and both techniques are compared with available experimental data. The differences in the results are evaluated. The test case is based on experimental measurements from the AVCO-Everett Research Laboratory electric arc-driven shock tube of a normal shock wave in air at 10 km/s and .1 Torr. The new method agrees with the available data as well as the results from the earlier scheme and is more easily extrapolated to di erent ow conditions.

Carlson, Ann B.

Direct simulation of reentry flows with ionization

The Direct Simulation Monte Carlo (DSMC) method is applied in this paper to the study of rarefied hypersonic reentry flows. The assumptions and simplifications involved with the treatment of ionization, free electrons and the electric field are investigated. A new method is presented for the calculation of the electric field and handling of charged particles with DSMC. In addition, a two-step model for electron impact ionization is implemented. The flowfield representing a 10 km/sec shock at an altitude of 65 km is calculated. The effects of the new modeling techniques on the calculation results are presented and discussed.

Carlson, Ann B.

Direct simulation Monte Carlo with ionization and radiation

Improvements in the modeling of radiation in low density shock waves with Direct Simulation Monte Carlo (DSMC) are the subject of this study. The physical processes which determine the amount of radiation in a shock wave were investigated and the way in which they were modeled with DSMC was evaluated. Three physical processes were identified for which an improvement in the modeling technique could result in improved radiation predictions. New physical modeling schemes are introduced in this report for the three processes. First a method for determining the electric field and its effect on the flow is introduced. Second, a two step reaction process for electron impact ionization reactions is evaluated. Finally, a new scheme to determine the relaxation collision numbers for excitation of electronic states is proposed. Each new scheme attempts to move the DSMC method toward more accurate physics or more reliance on experimental data. The new schemes are all compared to the current modeling techniques and the differences in the results are evaluated. In all cases the results agree with the available data as well as, or better than the results from earlier schemes.

Carlson, Ann B.

Monte Carlo simulation of reentry plasmas

Attention is given to the treatment of ionization and plasma effects in the direct simulation Monte Carlo method. The requirements for accurate modeling of reentry plasmas are discussed along with the difficulties these requirements present. The current method for modeling such plasmas is reviewed and an alternative method is presented. Both methods are applied to the flow of a 10 km/s shock wave in air at 0.1 torr; a flowfield directly relevant to the projected aeroassisted orbital transfer vehicle. The results are compared and the differences between the methods are discussed.

Carlson, Ann B.

Direct Simulation of Reentry Flows with Ionization

The Direct Simulation Monte Carlo (DSMC) method is applied in this paper to the study of rarefied, hypersonic, reentry flows. The assumptions and simplifications involved with the treatment of ionization, free electrons and the electric field are investigated. A new method is presented for the calculation of the electric field and handling of charged particles with DSMC. In addition, a two-step model for electron impact ionization is implemented. The flow field representing a 10 km/sec shock at an altitude of 65 km is calculated. The effects of the new modeling techniques on the calculation results are presented and discussed.

Carlson, Ann B.