Carolyn D Woeber | Search NASA

NASA NTRSDate not supplied

Summary of the 5th Propulsion Aerodynamics Workshop Nozzle Test Case: Heated Nozzle Exhaust Passing Over A Film-Cooled Plate

This paper summarizes findings from the fifth AIAA Propulsion Aerodynamics Workshop nozzle test case. The experimental configuration examined by workshop participants was a subsonic nozzle with a square exit blowing a heated exhaust over a film-cooled plate. Computational fluid dynamics solutions were obtained and compared to experimental measurements of flow velocities and temperatures, as well as plate surface temperatures. The heated nozzle operated with a Mach 0.3 exit flow at a static temperature ratio of 2.7. Cooling air blowing ratios of 0, 1, and 2 were considered. Computational meshes for the flow domain were provided for participants. Workshop participants from eight separate organizations represented government, industry, and academia. A variety of flow solutions were obtained: Most of the flow solutions employed a Reynolds-averaged Navier-Stokes (RANS) approach, but scale-resolving simulations were used in some cases, including wall-modeled large-eddy simulation (LES), and a few hybrid RANS-LES approaches. One Lattice-Boltzmann solver was employed. For heat transfer to the test article, many participants used a conjugate heat transfer approach. Effects of mesh sensitivity, flow solution approach, and wall heat transfer approach are considered. In general, a fully three-dimensional conjugate heat transfer approach enabled better prediction of surface temperatures than simpler wall temperature boundary treatments. Also, the scale resolving approaches provided better prediction of static temperatures in the flow immediately above the plate consisting of the hot jet exhaust boundary layer interacting with the cooling film. Comparisons of plate surface friction drag and heat transfer obtained from the computations are also presented.

nozzle↗

NASA NTRSDate not supplied

HLPW-4/GMGW-3: Overview and Workshop Summary

The Fourth AIAA CFD High Lift Prediction Workshop and the Third Geometry and Mesh Generation Workshop were held collaboratively with the common goal of assessing the numerical prediction capability of current-generation computational fluid dynamics (CFD) technology for swept, medium/high-aspect-ratio wings in high-lift configurations. A key aspect of this joint endeavor was the use of Technology Focus Groups, an innovative new approach for workshops involving close collaboration between participants. These groups, which included both mesh generation and flow solver experts, worked to accelerate advancements for their particular methodologies by addressing key questions of importance {\em prior} to the workshop. The high-lift version of the NASA Common Research Model (CRM-HL) configuration was the focus of this workshop. Measured experimental wind tunnel data were available for comparison. The workshop also included a two-dimensional turbulence model verification exercise based on the CRM-HL wing shape. Altogether, 44 participants submitted a total of 184 data sets of CFD results. This paper provides a high-level summary of the results and conclusions from the workshop. Like at past workshops, fixed-grid Reynolds-averaged Navier-Stokes continued to be inaccurate and inconsistent for high lift. However, mesh adaptation definitively brought more consistency. Scale-resolving methods appeared most promising for predicting high-lift flow physics.

Christopher L Rumsey↗