Search NASA⌕ Search

Engineering topics

Carpenter, Anita S.

Publications and source records attributed to Carpenter, Anita S..

The Magellan aerobraking experiment - Attitude control simulation and preliminary flight results

On May 25, 1993 the Magellan spacecraft began an experiment on 'aerobraking', or use of aerodynamic drag from the Venusian atmosphere to provide deceleration. The Magellan spacecraft will strive to transition from a highly elliptical orbit into a near-circular orbit in approximately 70 days by successively dipping into the atmosphere to gain the necessary reduction in orbital velocity. Magellan will be the first three-axis stabilized spacecraft to perform this type of multipass aerobraking, and will also be attempting to achieve the largest velocity reduction to date, all with a spacecraft that was not designed for this application. This paper addresses redesign of the attitude control system onboard Magellan for use during aerobraking. The dynamics and control of the spacecraft were simulated, and these results are presented and summarized. Modifications necessary to the existing flight control system and, specifically, to the mass expulsion control scheme are discussed. Changes were minimized though, due to the low-cost, high-risk approach to Magellan's aerobraking experiment. Some initial flight results from the first week of aerobraking operations will be highlighted.

Carpenter, Anita S.↗

Control of the Magellan spacecraft during aerobraking

In May 1993 the Magellan spacecraft will be lowered into the Venus atmosphere for the purpose of `aerobraking' to slow the spacecraft and achieve a near-circular orbit. The unprecedented science return of a 99% surface map, already accomplished by Magellan, will then be augmented by new atmospheric data and the opportunity to produce a high-resolution global gravity map from this circular orbit. The aerobraking concept, attitude control modeling and simulation results, and on-board software modifications are presented.

Carpenter, Anita S.↗

Low-g payload placement constraints for space station

Payloads onboard the Space Station will be subjected to a steady state acceleration level dominated by gravity gradient and aerodynamic drag forces. The g-level due to gravity gradient forces depends on the payload location relative to the center of mass, whereas the g-level due to aerodynamic drag may be assumed nearly constant throughout the Space Station. The vector of acceleration due to aerodynamic drag can always be broken down into three orthogonal components, in the direction opposite to the velocity vector, along the local vertical, and perpendicular to the orbit plane. It will be shown that the gravity gradient term has two components, which are orthogonal to one another. One component is along the local vertical and the other is perpendicular to the orbit plane. Thus, the combination of all components form an orthogonal triad of vectors. Addressed here are the payload location constraints to satisfy the requirements of 1 micro-g. The permissible locations are within an open-ended tube having an elliptical cross section, which is aligned with the velocity vector and centered on the system center of mass.

Carpenter, Anita S.↗