Search NASA⌕ Search

Engineering topics

Catherines, J. J.

Publications and source records attributed to Catherines, J. J..

14 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Vibration characteristics of a laser heterodyne spectrometer tunable diode laser system using a mechanical cooler platform

The Langley Research Center redesigned the cooler test bed hardware for the refrigerator for the purpose of isolating the tunable diode laser (TDL) from the cold tip in a laser heterodyne spectrometer system. Deflection in the lateral and vertical directions were managed on the cold tip and on the TDL. Measurements were analyzed over the frequency range of 0.100 Hz. The results show that the TDL responds approximately one order of magnitude less than that of the cold tip. The redesign of the system provided for adequately isolating the TDL for future operation.

Catherines, J. J.↗
NASA NTRS1978

Interior noise studies for general aviation types of aircraft. I - Field studies. II - Laboratory studies

Sources of the interior noise level of typical light aircraft are identified for stationary conditions on the ground and in flight. In addition, the relationship between the exterior near- and far-field noise around an aircraft and the interior noise field is examined. The sound transmission paths of a light aircraft fuselage are investigated, and the relative effectiveness of several components of the fuselage for sound attenuation is assessed. The fuselage furnishes an acoustic attenuation of about 20 dB; windows and metallic areas appear to transmit approximately equal amounts of sound energy.

Jha, S. K.↗
NASA NTRS1976

Measurement, analysis, and prediction of aircraft interior noise

Considerations of comfort of passengers and crew in light aircraft and helicopters indicate substantial benefits may be obtained by the reduction of interior noise levels. This paper discusses an ongoing research effort to reduce interior noise in such vehicles. Data from both field and laboratory studies for a light aircraft are presented. The laboratory data indicate that structural vibration is an efficient source of interior noise and should be considered in the reduction of interior noise. Flight data taken on a helicopter before and after installation of acoustic treatment demonstrate that over 30 dB of noise reduction can be obtained in certain portions of the spectra. However, subjective evaluations of the treated vehicle indicate that further reductions in interior noise are desirable. An existing interior noise prediction method which was developed for large jet transports was applied to study low-frequency noise in a light aircraft fuselage. The results indicate that improvements in the analytical model may be necessary for the prediction of interior noise of light aircraft.

Howlett, J. T.↗
NASA NTRS1976

Sources and characteristics of interior noise in general aviation aircraft

A field study was conducted to examine the interior noise characteristics of a general aviation aircraft. The goals were to identify the major noise sources and their relative contribution and to establish the noise transmission paths and their relative importance. Tests were performed on an aircraft operating under stationary conditions on the ground. Results show that the interior noise level of light aircraft is dominated by broadband, low frequencies (below 1,000 Hz). Both the propeller and the engine are dominant sources, however, the contribution from the propeller is significantly more than the engine at its fundamental blade passage frequency. The data suggest that the airborne path is more dominant than the structure-borne path in the transmission of broadband, low frequency noise which apparently results from the exhaust.

Catherines, J. J.↗
NASA NTRS1976

Sources and characteristics of interior noise in general aviation aircraft

A field study has been conducted to examine the interior noise characteristics of a general aviation aircraft. The purposes of the study were to identify the major noise sources and their relative contribution and to establish the noise transmission paths and their relative importance. Tests were performed on an aircraft operating under stationary conditions on the ground. The results show that the interior noise level of light aircraft is dominated by broadband, low frequencies (below 1,000 Hz). Both the propeller and the engine are dominant sources; however, the contribution from the propeller is significantly more than the engine at its fundamental blade passage frequency. The data suggests that the airborne path is more dominant than the structure-borne path in the transmission of broadband, low-frequency noise which apparently results from the exhaust.

Catherines, J. J.↗
NASA NTRS1975

Vibrations measured in the passenger cabins of two jet transport aircraft

Accelerations in the lateral and vertical directions were measured at two locations on the floor of a three-jet-engine aircraft and at two locations on the floor of a two-jet-engine aircraft during a total of 13 flights, each of which included taxiing, takeoff, ascent, cruise, descent, and landing. Accelerations over the frequency range 0 to 25 Hz were recorded continuously on magnetic tape and were synchronized with the VGH recorders in the aircraft so that vibratory accelerations could be correlated with the operating conditions of the aircraft. From the results it was indicated that the methodology used in segmenting the data, which were obtained in a continuous and repetitive manner, contributes to establishing baseline data representative of the flight characteristics of aircraft. Significant differences among flight conductions were found to occur. The lateral accelerations were approximately 15 percent of the vertical accelerations during flight but as much as 50 to 100 percent of the vertical accelerations during ground operations. The variation between the responses of the two aircraft was not statistically significant. The results also showed that more than 90 percent of the vibratory energy measured during flight occurred in the 0- to 3.0-Hz frequency range. Generally, the vibration amplitudes were normally distributed.

Catherines, J. J.↗
NASA NTRS1975

Interior noise levels of two propeller-driven light aircraft

The relationships between aircraft operating conditions and interior noise and the degree to which ground testing can be used in lieu of flight testing for performing interior noise research were studied. The results show that the noise inside light aircraft is strongly influenced by the rotational speed of the engine and propeller. Both the overall noise and low frequency spectra levels were observed to decrease with increasing high speed rpm operations during flight. This phenomenon and its significance is not presently understood. Comparison of spectra obtained in flight with spectra obtained on the ground suggests that identification of frequency components and relative amplitude of propeller and engine noise sources may be evaluated on stationary aircraft.

Catherines, J. J.↗
NASA NTRS1975

Interior noise levels of two propeller driven light aircraft

A test program is described with the objective of determining the relationship between aircraft operating conditions and interior noise and of determining the degree to which ground testing can be used in lieu of flight testing for performing interior noise research. Measurements are presented for single and twin engine aircraft for 2 or 4 passengers. It was found that noise levels are strongly influenced by the rotational speed of the engine and propeller. Both the overall noise and low frequency spectra levels were observed to decrease with increasing high speed rpm operation during flight. Comparison of spectra obtained in flight with spectra obtained on the ground suggests that identification of frequency components and relative amplitude of propeller and engine noise sources may be evaluated on stationary aircraft.

Catherines, J. J.↗
NASA NTRS1973

Using computers to analyze continuous data.

Dynamic field measurements often involve large quantities of continuous data, which must be analyzed and interpreted to obtain meaningful information. The processing can often be accomplished by tape-recording the data in analog form, performing off-line digitalization, and using the result as an input to statistical programs on a digital computer. A time series analysis was used to obtain power spectral density (PSD) curves to identify dominant frequencies. Representative PSD plots were obtained for STOL aircraft during cruise. Vibrational energy was clearly concentrated below 0.1 Hz, and was much higher in the vertical than in the lateral direction.

Catherines, J. J.↗
NASA NTRS1972

A method for the measurement and analysis of ride vibrations of transportation systems

The measurement and recording of ride vibrations which affect passenger comfort in transportation systems and the subsequent data-reduction methods necessary for interpreting the data present exceptional instrumentation requirements and necessitate the use of computers for specialized analysis techniques. A method is presented for both measuring and analyzing ride vibrations of the type encountered in ground and air transportation systems. A portable system for measuring and recording low-frequency, low-amplitude accelerations and specialized data-reduction procedures are described. Sample vibration measurements in the form of statistical parameters representative of typical transportation systems are also presented to demonstrate the utility of the techniques.

Catherines, J. J.↗