Search NASA⌕ Search

Engineering topics

Chaderjian, Neal M.

Publications and source records attributed to Chaderjian, Neal M..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1995

Progress in Navier-Stokes Simulation of Delta Wing Maneuver Aerodynamics

This paper will summarize recent progress in the numerical simulation of high incidence vortical flow about a generic 65 degree sweep delta wing using the three dimensional, time-dependent, Reynolds averaged, Navier-Stokes (RANS) equations. Computations have been carried out at 15 and 30 degrees angle of attack under subsonic turbulent flow conditions, and compared with experimental data provided by Hanff, Jenkins, and their colleagues. This work has already been published elsewhere and widely disseminated. Computations carried out at 15 degrees angle of attack included static roll angles ranging up to 65 degrees, and a large-amplitude (40 degree), high rate (7 Hz), forced roll motion. There was very good agreement between computed and experimental forces and moments, and static surface pressures. There was a significant hysteresis of the dynamic rolling moment due to the high rate of roll motion. At this angle of attack, no vortex breakdown was observed in the computations or experiment. Computations were also carried out at 30 degrees angle of attack, where vortex breakdown was present in both the computations and experiment. There was overall good agreement in the computed and experimental forces and moments. The static rolling moment varied with roll angle in a highly nonlinear manner, and exhibited three stable trim points and two unstable trim points. This behavior was attributed to the presence of vortex breakdown. Two large-amplitude (30 degrees), high-rate (10 Hz) forced roll motions were computed. The dynamics of the vortex breakdown motion was dramatically visualized by tracking the time-dependent motion of particles released near the delta wing apex. This numerical visualization is analogous to experimental smoke flow techniques. In one of the dynamic cases the breakdown was found to move off the wing, convected downwind of the trailing edge, and later reformed near the trailing edge through an instability of the vortex core. A damped free-to-roll motion was also computed by releasing the wing from rest at 40 degrees of roll. The wing went to the same trim point as in the experiment.

Chaderjian, Neal M.↗
NASA NTRS1994

Navier-Stokes prediction of large-amplitude forced and free-to-roll delta-wing oscillations

The three-dimensional Reynolds-averaged, Navier-Stokes (RANS) equations are used to numerically simulate nonsteady vortical flow about a 65 degree sweep delta wing at 30 degrees angle of attack. Two large-amplitude, high-rate, forced-roll motions and a damped free-to-roll motion are presented. The free-to-roll motion is computed by coupling the time-dependent RANS equations to the flight dynamic equation of motion. The computed results are compared with experimental forces, moments, and roll-angle time histories. The overall agreement is good. Vortex breakdown is present in each case, which causes significant time lags in the vortex breakdown motions relative to the body motions. This behavior strongly influences the dynamic forces and moments.

Chaderjian, Neal M.↗
NASA NTRS1993

Navier-Stokes prediction of a delta wing in roll with vortex breakdown

The three-dimensional, Reynolds-averaged, Navier-Stokes (RANS) equations are used to numerically simulate vortical flow about a 65 degree sweep delta wing. Subsonic turbulent flow computations are presented for this delta wing at 30 degrees angle of attack and static roll angles up to 42 degrees. This work is part of an on going effort to validate the RANS approach for predicting high-incidence vortical flows, with the eventual application to wing rock. The flow is unsteady and includes spiral-type vortex breakdown. The breakdown positions, mean surface pressures, rolling moments, normal forces, and streamwise center-of-pressure locations compare reasonably well with experiment. In some cases, the primary vortex suction peaks are significantly underpredicted due to grid coarseness. Nevertheless, the computations are able to predict the same nonlinear variation of rolling moment with roll angle that appeared in the experiment. This nonlinearity includes regions of local static roll instability, which is attributed to vortex breakdown.

Chaderjian, Neal M.↗
NASA NTRS1992

Navier-Stokes prediction of large-amplitude delta-wing roll oscillations characterizing wing rock

High-incidence vortical flow about a 65-deg sweep delta wing undergoing static roll and large-amplitude, high-rate-of-roll oscillations is simulated numerically using the time-dependent, three-dimensional, Reynolds-averaged, Navier-Stokes equations. Turbulent computations are presented for static roll angles up through 42 degrees. The effects of roll angle on the vortex aerodynamics are discussed, and the solution accuracy is evaluated by comparison with experimental data. The effects of grid refinement and zonal boundary condition treatment on solution accuracy are assessed at zero roll angle. Numerical simulation of a forced periodic roll motion is also presented.

Chaderjian, Neal M.↗
NASA NTRS1991

Numerical algorithm comparison for the accurate and efficient computation of high-incidence vortical flow

Computations from two Navier-Stokes codes, NSS and F3D, are presented for a tangent-ogive-cylinder body at high angle of attack. Features of this steady flow include a pair of primary vortices on the leeward side of the body as well as secondary vortices. The topological and physical plausibility of this vortical structure is discussed. The accuracy of these codes are assessed by comparison of the numerical solutions with experimental data. The effects of turbulence model, numerical dissipation, and grid refinement are presented. The overall efficiency of these codes are also assessed by examining their convergence rates, computational time per time step, and maximum allowable time step for time-accurate computations. Overall, the numerical results from both codes compared equally well with experimental data, however, the NSS code was found to be significantly more efficient than the F3D code.

Chaderjian, Neal M.↗
NASA NTRS1990

Navier-Stokes predictions of the flowfield around the F-18 (HARV) wing and fuselage at large incidence

In support of the NASA High Alpha Technology Program, Navier-Stokes solutions have been obtained using the Chimera overset grid scheme for flow over the wing, fuselage, and wing leading-edge extension (LEX) of the F/A-18 High Alpha Research Vehicle (HARV) at high incidence. Solutions are also presented for flow over the fuselage forebody at high angles of attack. The solutions are for turbulent flows at high-Reynolds-number flight-test conditions, and are compared with available qualitative and quantitative experimental data. Comparisons of predicted surface flow patterns, off-surface flow visualization, and surface-pressure distributions are in good agreement with flight-test data. The ability of the numerical method to predict the bursting of the LEX vortex as it encounters the adverse pressure gradient field of the wing is demonstrated, and the capability of predicting high-angle-of-attack aerodynamics around realistic aircraft configurations is established.

Cummings, Russell M.↗
NASA NTRS1990

Unsteady transonic Navier-Stokes computations for an oscillating wing using single and multiple zones

Modern jet transports and maneuvering tactical fighters operating in the transonic regime often give rise to time-dependent fluid physics that interact with flexible structural components, e.g., vortical flow, shocks, and separation. Efficient computational fluid dynamic (CFD) methods are required to study such computationally intensive problems. In this work a numerical method is presented to address this problem. Time-dependent, compressible, Navier-Stokes equations are used to simulate unsteady transonic flow about a three-dimensional rigid wing undergoing a forced periodic motion in angle of attack. An efficient, implicit, diagonal algorithm is utilized because of its low operation count per time step compared to other methods that solve systems of block matrix equations. The formal time accuracy is addressed theoretically and demonstrated numerically by comparison of computational results with experimental data. A zonal grid approach, capable of treating complex geometries, is presented and its time accuracy is demonstrated by comparing a zonal computation with a single grid computation and experimental data.

Chaderjian, Neal M.↗
NASA NTRS1990

Navier-Stokes computations about complex configurations including a complete F-16 aircraft

Transonic Navier-Stokes (TNS) code solutions gathered from the literature for three-dimensional geometries, including two different wings and a complete F-16A aircraft, are presently discussed. The TNS codes use a zonal grid approach whose number of zones vary from four to 54. The Euler equations are solved in zones away from no-slip surfaces, and the thin-layer TNS equations are solved in all zones immediately adjacent to no-slip surfaces. In the case of 'corner' zones possessing no-slip boundary conditions on two different surfaces, a thin-layer formulation along both directions is employed. Employing these features, a zonal construction with the requisite set of boundary conditions can be devised for almost any application.

Holst, Terry L.↗
NASA NTRS1990

Numerical simulation of high-incidence flow over the F-18 aircraft

Navier-Stokes solutions have been obtained using the Chimera overset grid scheme for flow over the wing, fuselage, and wing leading-edge extension (LEX) of the F-18 aircraft at high incidence. Solutions are also presented for flow over the fuselage forebody at high angles of attack. The solutions are for turbulent flows at high-Reynolds number flight-test conditions, and are compared with available qualitative and quantitative experimental data. Comparisons of predicted surface flow patterns, off-surface flow visualizations, and surface-pressure distributions are in good agreement with flight-test data. The ability of the numerical method to predict the bursting of the LEX vortex as it encounters the adverse pressure gradient field of the wing is demonstrated.

Cummings, Russell M.↗
NASA NTRS1989

Transonic viscous flow computations about a complete aircraft using the Navier-Stokes equations

A numerical approach for simulating the viscous transonic flow about the complete F-16A fighter aircraft is presented using the Navier-Stokes equations. This finite difference approach utilizes a body conforming zonal grid system to provide appropriate viscous clustering near all body surfaces. A comparison between computational and experimental pressure coefficients is good, and integrated quantities such as lift and drag are within 2.6 percent and 1.6 percent, respectively. The versatility of the method is demonstrated by further modeling the flow inside the inlet up to the compressor face and the exhaust nozzle plume. Results for the F-16A in sideslip are also presented and indicate the proper trends.

Chaderjian, Neal M.↗
NASA NTRS1988

The numerical simulation of transonic separated flow about the complete F-16A

The thin-layer, Reynolds-averaged, Navier-Stokes equations are used to simulate the transonic viscous flow about the complete F-16A fighter aircraft. These computations demonstrate how computational fluid dynamics (CFD) can be used to simulate turbulent viscous flow about realistic aircraft geometries. A zonal grid approach is used to provide adequate viscous grid clustering on all aircraft surfaces. Zonal grids extend inside the F-16A inlet and up to the compressor face while power on conditions are modeled by employing a zonal grid extending from the exhaust nozzle to the far field. A simple solution adaptive grid procedure is used on the wing surface and good agreement with experimental data is obtained. Computations for the F-16A in side slip are also presented.

Flores, Jolen↗
NASA NTRS1988

Navier-Stokes simulation of transonic wing flow fields using a zonal grid approach

The transonic Navier-Stokes code was used to simulate flow fields about isolated wings for workshop wind-tunnel and free-air cases using the thin-layer Reynolds-averaged Navier-Stokes equations. An implicit finite-difference scheme based on a diagonal version of the Beam-Warming algorithm was used to integrate the governing equations. A zonal grid approach was used to allow efficient grid refinement near the wing surface. The flow field was sensitive to the turbulent transition model, and flow unsteadiness was observed for a wind-tunnel case but not for the corresponding free-air case. The specification of experimental pressure at the wind-tunnel exit plane is the primary reason for the difference of these two numerical solutions.

Chaderjian, Neal M.↗
NASA NTRS1988

Navier-Stokes simulation of transonic wing flow fields using a zonal grid approach

The transonic Navier-Stokes code was used to simulate flow fields about isolated wings for workshop wind-tunnel and free-air cases using the thin-layer Reynolds-averaged Navier-Stokes equations. An implicit finite-difference scheme based on a diagonal version of the Beam-Warming algorithm was used to integrate the governing equations. A zonal grid approach was used to allow efficient grid refinement near the wing surface. The flow field was sensitive to the turbulent transition model, and flow unsteadiness was observed for a wind-tunnel case but not for the corresponding free-air case. The specification of experimental pressure at the wind-tunnel exit plane is the primary reason for the difference of these two numerical solutions.

Chaderjian, Neal M.↗