Engineering topics
Checco, A
Publications and source records attributed to Checco, A.
Wetting of Nanopatterned Grooved Surfaces
The wetting by perfluoromethylcyclohexane of a well-defined silicon grating with a channel width of 16 nm has been studied using transmission small angle x-ray scattering. Prefilling, capillary filling, and postfilling wetting regimes have been identified. A detailed comparison of the data with theory reveals the importance of long-ranged substrate-fluid and fluid-fluid interactions for determining the wetting behavior on these length scales, especially at the onset of capillary condensation and in the prefilling regime.
Role of Electrostatic Interactions in Two Dimensional Self Assembly of Tobacco Mosaic Viruses on Cationic Lipid Mololayers
We explore two-dimensional self-assembly of tobacco mosaic viruses (TMVs) on a substrate-supported, fluid lipid monolayer by manipulating the electrostatic interactions, with specific focus on the effects of the cationic lipid concentration in the monolayer and the presence of Ca{sup 2+} ions in the surrounding bulk solution. The TMV assemblies were characterized by grazing-incidence X-ray scattering and atomic force microscopy, and the inter-particle interaction quantified through X-ray scattering data analysis. In the absence of Ca{sup 2+} ions, we found that higher charge densities on the lipid monolayer led to poorer in-plane order, which may be attributed to faster adsorption kinetics, due to the surface potential that increases with charge density. At the same time, higher lipid-charge densities also resulted in weaker repulsion between TMVs, due to partial screening of Coulomb repulsion by mobile cationic lipids in the monolayer. The lipid-charge dependence was diminished with increasing concentration of Ca{sup 2+} ions, which also led to tighter packing of TMVs. The results indicate that Ca{sup 2+} ions strengthen the screening of Coulomb repulsion between TMVs and consequently enhance the role of attractive forces. Control experiments involving Na{sup +} ions suggest that the attractive inter-TMV interaction has contributions from both the van der Waals force and the counter-ion-induced attraction that depends on ion valence.
Block Copolymer Self-assembly in Chemically Patterned Squares
The self-assembly of block copolymers thin films laterally confined within square geometries that are incompatible with the bulk packing symmetry of the block copolymer microdomains is investigated. The lateral confinement is provided by chemical patterns made by oxidation nanolithography of octadecyltrichlorosilane-coated silicon surfaces. We find that the size and shape of the confinement affect the order of the block copolymer microdomains and their packing symmetries. Specifically, if the size of the square pattern is smaller than the characteristic grain size the hexagonally packed microdomains form a single-crystal oriented along the edges of the pattern and with 'edge-boundaries' located preferentially at the perimeter of the pattern. If the size of the pattern is comparable with the natural bulk period of the copolymer, the packing symmetry changes from hexagonal to square. In this case the ordering induced by the pattern edges becomes dominant allowing the square lattice to be more stable than the hexagonal one.
Charged Diblock Copolymers at Interfaces: Micelle Dissociation Upon Compression
We use grazing incidence X-ray scattering to study the surface micellization of charged amphiphilic diblock copolymers poly(styrene-block-acrylic acid) at the air-water interface. Scattering interference peaks are consistent with the formation of hexagonally packed micelles. The remarkable increase of inter-micelle distance upon compression is explained by a dissociation of micelles into a brush. Hence, surface micelles reorganize, whereas micelles of the same copolymers in solutions are 'frozen'. We show indeed that the energetic cost of unimer extraction from micelles is much lower for surface than for solution. Finally, a model combining electrostatic interactions and micelle/brush equilibrium explains surface pressure vs. area without free parameters. keywords - soft matter, liquids and polymers, biological physics, chemical physics and physical chemistry.
Morphology of Air Nanobubbles Trapped atHydrophobic Nanopatterned Surfaces
The details of air nanobubble trapping at the interface between water and a nanostructured hydrophobic silicon surface are investigated using X-ray scattering and contact angle measurements. Large-area silicon surfaces containing hexagonally packed, 20 nm wide hydrophobic cavities provide ideal model surfaces for studying the morphology of air nanobubbles trapped inside cavities and its dependence on the cavity depth. Transmission small-angle X-ray scattering measurements show stable trapping of air inside the cavities with a partial water penetration of 5-10 nm into the pores, independent of their large depth variation. This behavior is explained by consideration of capillary effects and the cavity geometry. For parabolic cavities, the liquid can reach a thermodynamically stable configuration - a nearly planar nanobubble meniscus - by partially penetrating into the pores. This microscopic information correlates very well with the macroscopic surface wetting behavior.
Wetting of Nanopatterned Grooved Surfaces
The wetting by perfluoromethylcyclohexane of a well-defined silicon grating with a channel width of 16 nm has been studied using transmission small angle x-ray scattering. Prefilling, capillary filling, and postfilling wetting regimes have been identified. A detailed comparison of the data with theory reveals the importance of long-ranged substrate-fluid and fluid-fluid interactions for determining the wetting behavior on these length scales, especially at the onset of capillary condensation and in the prefilling regime.
Charged Diblock Copolymers at Interfaces: Micelle Dissociation Upon Compression
We use grazing incidence X-ray scattering to study the surface micellization of charged amphiphilic diblock copolymers poly(styrene-block-acrylic acid) at the air-water interface. Scattering interference peaks are consistent with the formation of hexagonally packed micelles. The remarkable increase of inter-micelle distance upon compression is explained by a dissociation of micelles into a brush. Hence, surface micelles reorganize, whereas micelles of the same copolymers in solutions are 'frozen'. We show indeed that the energetic cost of unimer extraction from micelles is much lower for surface than for solution. Finally, a model combining electrostatic interactions and micelle/brush equilibrium explains surface pressure vs. area without free parameters.
Structure and Interaction in 2D Assemblies of Tobacco Mosaic Viruses
We created two-dimensional (2D) assemblies of tobacco mosaic viruses (TMVs) and characterized their structures using Atomic Force Microscopy (AFM) and X-ray scattering. The TMVs were adsorbed on an oppositely charged, fluid lipid monolayer supported by a solid substrate and submerged in a buffer solution. The lipid monolayer confined the viral particles within a plane, while providing them with lateral mobility so that overall the TMV assembly behaved like a 2D liquid. We controlled the inter-particle interaction by adjusting the chemical condition in the buffer to induce ordered TMV assemblies. We found that the presence of the lipid layer was essential for forming ordered TMV assemblies. Packed TMV assemblies formed on the lipid layer, with an average inter-particle spacing of 42 nm. By introducing Ca{sup 2+} ions into the buffer solution, we were able to improve the in-plane order within the TMV assemblies and reduce the average inter-particle spacing to 20 nm, compared to the TMV diameter of 18 nm. Quantitative analysis of the X-ray scattering data shows that the structural order within the TMV assemblies prepared under a Ca{sup 2+}-free buffer solution is consistent with purely repulsive, electrostatic inter-particle interaction. In contrast, the structural order within Ca{sup 2+}-induced TMV assemblies is consistent with the behavior of a fluid of sticky rods, implying the presence of a strong attraction between TMVs. In addition to the screening of Coulomb repulsion, this behavior is likely the result of counterion-induced as well as membrane-mediated attractions.
Structure and interaction in 2D assemblies of tobacco mosaic viruses
We created two-dimensional (2D) assemblies of tobacco mosaic viruses (TMVs) and characterized their structures using Atomic Force Microscopy (AFM) and X-ray scattering. The TMVs were adsorbed on an oppositely charged, fluid lipid monolayer supported by a solid substrate and submerged in a buffer solution. The lipid monolayer confined the viral particles within a plane, while providing them with lateral mobility so that overall the TMV assembly behaved like a 2D liquid. We controlled the inter-particle interaction by adjusting the chemical condition in the buffer to induce ordered TMV assemblies. We found that the presence of the lipid layer was essential for forming ordered TMV assemblies. Packed TMV assemblies formed on the lipid layer, with an average inter-particle spacing of 42 nm. By introducing Ca2+ ions into the buffer solution, we were able to improve the in-plane order within the TMV assemblies and reduce the average inter-particle spacing to 20 nm, compared to the TMV diameter of 18 nm. Quantitative analysis of the X-ray scattering data shows that the structural order within the TMV assemblies prepared under a Ca{sup 2+}-free buffer solution is consistent with purely repulsive, electrostatic inter-particle interaction. In contrast, the structural order within Ca{sup 2+}-induced TMV assemblies is consistent with the behavior of a fluid of sticky rods, implying the presence of a strong attraction between TMVs. In addition to the screening of Coulomb repulsion, this behavior is likely the result of counterion-induced as well as membrane-mediated attractions.
Equilibrating Nanoparticle Monolayers Using Wetting Films
Monolayers of bimodal gold nanoparticles on silicon are investigated by a combination of microscopy (dry monolayers) and x-ray diffraction (dry and wet monolayers). In the presence of an excess of small particles, the nanoscale packing structure closely resembles the small-particle-rich scenario of the structural crossover transition that has been predicted and also observed with micron-scale hard-sphere colloids. Structural morphology is monitored in situ during monolayer dissolution and reassembly within the thin liquid wetting film. This approach allows investigation of size and solvent effects on nanoparticles in quasi-two-dimensional confinement.