Search NASA⌕ Search

Engineering topics

Chen, Li

Publications and source records attributed to Chen, Li.

114 records · Page 7

Wide Range SET Pulse Measurement

A method for measuring a wide range of SET pulses is demonstrated. Use of dynamic logic, faster than ordinary CMOS, allows capture of short pulses. A weighted binning of SET lengths allows measurement of a wide range of pulse lengths with compact circuitry. A pulse-length-conservative pulse combiner tree routes SETs from combinational logic to the measurement circuit, allowing SET measurements in circuits that cannot easily be arranged in long chains. The method is applied to add-multiplex combinational logic, and to an array of NFET routing switches, at .35 micron. Pulses are captured in a chain of Domino Logic AND gates. Propagation through the chain is frozen on the trailing edge by dropping low the second "enable" input to the AND gates. Capacitive loading is increased in the latter stages to create an approximately logarithmic weighted binning, so that a broad range of pulse lengths can be captured with a 10 stage capture chain. Simulations show pulses can be captured which are 1/5th the length of those typically captured with leading edge triggered latch methods, and less than the length of those captured with a trailing edge latch method. After capture, the pulse pattern is transferred to an SEU protected shift register for readout. 64 instances of each of two types of logic are used as targets. One is a full adder with a 4 to 1 mux on its inputs. The other is a 4 x 4 NFET routing matrix. The outputs are passed through buffered XNOR comparators to identify pulses, which are merged in a buffered not-nand (OR) tree designed to avoid pulse absorption as much as possible. The output from each of the two test circuits are input into separate pulse measurement circuits. Test inputs were provided so that the circuit could be bench tested and calibrated. A third SET measurement circuit with no inputs was used to judge the contribution from direct hits on the measurement circuit. Heavy ions were used with an LET range from 12 to 176. At LET of 21 and below, the very small number of SETs were not significantly higher in the test over the control circuits. At higher LET the test circuit SETs are one or two orders of magnitude greater than for the control circuit. The NFET circuit produces more and slightly longer SETs as expected. But the differences do not appear to be significant enough to modify strategies now used to avoid capture of SETs in chips such as FPGAs. Complete data and graphs will be in the full paper / presentation. In the summary figure below left, NOCL is the reference circuit without any input, and number of stages triggered is plotted. Simulation at right shows the smallest pulse captured (stage 2) at about 300 ps. Our conclusion is that the method is promising, but that improvements in the merge network are desirable before applying in a deep submicron process

Shuler, Robert L.↗

Observation on long afterglow of Tb{sup 3+} in CaWO{sub 4}

Graphical abstract: The afterglow of Tb{sup 3+} is observed in CaWO{sub 4} matrix. The main emission of the afterglow is ascribed to the {sup 5}D{sub 4} {yields} {sup 7}F{sub 5} and {sup 5}D{sub 4} {yields} {sup 7}F{sub 6}. Emission due to {sup 5}D{sub 3} {yields} {sup 7}F{sub 4} and {sup 5}D{sub 3} {yields} {sup 7}F{sub 5} is weak. The cross-relaxation dominate the afterglow emission and it enhances the transition from {sup 5}D{sub 4} whereas from {sup 5}D{sub 3}. Highlights: Black-Right-Pointing-Pointer A green long afterglow is observed from Tb{sup 3+} in CaWO{sub 4} matrix. Black-Right-Pointing-Pointer Two traps which may have a strong influence on the afterglow properties are revealed by TL. Black-Right-Pointing-Pointer A mechanism model based on energy transfer from WO{sub 4}{sup 2-} group to Tb{sup 3+} followed by cross-relaxation is proposed. -- Abstract: The Tb{sup 3+} doped CaWO{sub 4} phosphors are synthesized via high temperature solid state reaction. The X-ray diffraction shows that small amount of Tb{sup 3+} does not have a significant influence on the structure of CaWO{sub 4}. A broad absorption band of the WO{sub 4}{sup 2-} group is observed from photoluminescence and the energy transfer from WO{sub 4}{sup 2-} group to Tb{sup 3+} ions induces the f-f transition. The cross-relaxation between two adjacent Tb{sup 3+} ions weakens {sup 5}D{sub 3}-{sup 7}F{sub j} transitions and enhances the {sup 5}D{sub 4}-{sup 7}F{sub j} transitions, leading to a green long afterglow of the phosphors. The thermoluminescence curves centered around 75 Degree-Sign C reveal the trap depth for afterglow generation is about 0.74-0.77 eV. The optimum Tb{sup 3+} concentration for afterglow properties is about 1%. A deep hole trap is induced when Tb{sup 3+} concentration exceeds 1% and it suppresses the thermoluminescence and the decay properties.

36 MATERIALS SCIENCE↗

Hydrothermal synthesis of hierarchical titanium silicalite-1 using single template

Graphical abstract: . Hierarchical nano-crystalline TS-1 can be simply synthesized using tetrapropylammonium hydroxide as single template in presence of a 'seed' gel. Research highlights: {yields} Hierarchical nano-crystalline TS-1 can be directly synthesized using tetrapropylammonium hydroxide (TPAOH) as single template in presence of a 'seed' gel. The presence of seed favored the aggregation of TS-1 nanoparticles and thus lead to the interstitial voids that contributed to secondary mesoporosity. The presence of seed could accelerate the crystallization rate and reduce the amount of template, TPAOH. -- Abstract: Hierarchical nano-crystalline TS-1 can be directly synthesized using tetrapropylammonium hydroxide (TPAOH) as single template in the presence of a 'seed' gel. The hierarchical nano-crystalline TS-1 was characterized by scanning electron microscopy, transmission electron microscopy, powder X-ray diffraction, UV-Vis diffuse reflectance spectroscopy and nitrogen adsorption-desoprtion. Compared with the conventional TS-1, the hierarchical nano-crystalline TS-1 contained an additional porosity including supermicro/mesopores, which attributed to the interstitial voids existing between the nanocrystals. The secondary porosity in the TS-1 material provided an enhanced external surface area and high mesopore volume in favor of fast diffusion of both reactants and products, which resulted in an enhanced activity in the epoxidation of bulky molecules cyclohexene using aqueous H{sub 2}O{sub 2} solution as oxidant.

36 MATERIALS SCIENCE↗

Chemical Synthesis and Optical Properties of CdS Poly(Lactic Acid) Nanocomposites and Their Transparent Fluorescent Films

This paper describes the chemical synthesis of cadmium sulfide (CdS) polymer nanocomposites by covalently grafting poly(lactic acid) (PLA) onto the surfaces of CdS nanocrystals (NCs). Synthesis of the nanocomposites involved two steps. Lactic acid (LA) capped CdS NCs were first prepared by reacting cadmium chloride (CdCl2) with sodium sulfide (Na2S) using LA as the organic ligand in H2O/N,N-dimethylformamide (DMF) solution. Next CdS PLA nanocomposites were formed by in situ ring-opening polymerization of lactide on the surface of modified CdS NCs. Transparent fluorescent films were then successfully prepared by blending as-prepared CdS PLA nanocomposites with high-molecular-weight PLA. The as-prepared CdS NCs and their nanocomposites were studied by transmission electron microscopic imaging, thermogravimetric analyses, and spectroscopic measurements (ultraviolet-visible absorption and photoluminescence). The spectroscopic studies revealed that the CdS polymer nanocomposites exhibited good optical properties in terms of their photoluminescence and transparency.

36 MATERIALS SCIENCE↗

SEE Tolerant Self-Calibrating Simple Fractional-N PLL

We show a reliable on-chip clock multiplier for SEE testing or RHBD applications. Fine control of clock frequency is provided without complex delta-sigma schemes. Conflicts that can occur with voted PLLs are discussed, and how to avoid them.

Shuler, Robert L.↗

Metformin reduces lipid accumulation in macrophages by inhibiting FOXO1-mediated transcription of fatty acid-binding protein 4

Objective: The accumulation of lipids in macrophages contributes to the development of atherosclerosis. Strategies to reduce lipid accumulation in macrophages may have therapeutic potential for preventing and treating atherosclerosis and cardiovascular complications. The antidiabetic drug metformin has been reported to reduce lipid accumulation in adipocytes. In this study, we examined the effects of metformin on lipid accumulation in macrophages and investigated the mechanisms involved. Methods and results: We observed that metformin significantly reduced palmitic acid (PA)-induced intracellular lipid accumulation in macrophages. Metformin promoted the expression of carnitine palmitoyltransferase I (CPT-1), while reduced the expression of fatty acid-binding protein 4 (FABP4) which was involved in PA-induced lipid accumulation. Quantitative real-time PCR showed that metformin regulates FABP4 expression at the transcriptional level. We identified forkhead transcription factor FOXO1 as a positive regulator of FABP4 expression. Inhibiting FOXO1 expression with FOXO1 siRNA significantly reduced basal and PA-induced FABP4 expression. Overexpression of wild-type FOXO1 and constitutively active FOXO1 significantly increased FABP4 expression, whereas dominant negative FOXO1 dramatically decreased FABP4 expression. Metformin reduced FABP4 expression by promoting FOXO1 nuclear exclusion and subsequently inhibiting its activity. Conclusions: Taken together, these results suggest that metformin reduces lipid accumulation in macrophages by repressing FOXO1-mediated FABP4 transcription. Thus, metformin may have a protective effect against lipid accumulation in macrophages and may serve as a therapeutic agent for preventing and treating atherosclerosis in metabolic syndrome.

60 APPLIED LIFE SCIENCES↗