Search NASA⌕ Search

Engineering topics

Chen, Xu

Publications and source records attributed to Chen, Xu.

14 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Probing the fatigue enhancement in a thermally aged cast duplex stainless steel by in situ neutron diffraction

After long-term thermal aging at 400 °C for 3000 h and 10,000 h, a cast duplex stainless steel exhibits promoted fatigue performance, including enhanced three-stage cyclic hardening and prolonged fatigue life. Utilizing in situ neutron diffraction, the phase-specific stresses are resolved, and their evolutions over entire fatigue cycling reveal the underlying mechanisms of the fatigue enhancement. It is found that the ferrite phase bears a much higher stress than the austenite matrix under both as-received and aged conditions. The enhanced cyclic hardening in Stage I is attributed to the strengthening of both phases due to thermal aging, while the enhancement in Stage III results from the martensitic transformation induced strengthening. The fatigue life is prolonged thanks to the cyclic hardening and the delay of martensitic transformation in the austenite phase after thermal aging.

Yu, Dunji↗
DOE OSTI2024

Superconductivity in pressurized trilayer La 4 Ni 3 O 10-$δ$ single crystals

In this study, the pursuit of discovering new high-temperature superconductors that diverge from the copper-based model has profound implications for explaining mechanisms behind superconductivity and may also enable new applications. Here our investigation shows that the application of pressure effectively suppresses the spin–charge order in trilayer nickelate La 4 Ni 3 O 10-δ single crystals, leading to the emergence of superconductivity with a maximum critical temperature (T c ) of around 30 K at 69.0 GPa. The d.c. susceptibility measurements confirm a substantial diamagnetic response below T c , indicating the presence of bulk superconductivity with a volume fraction exceeding 80%. In the normal state, we observe a strange metal behaviour, characterized by a linear temperature-dependent resistance extending up to 300 K. Furthermore, the layer-dependent superconductivity observed hints at a unique interlayer coupling mechanism specific to nickelates, setting them apart from cuprates in this regard. Our findings provide crucial insights into the fundamental mechanisms underpinning superconductivity, while also introducing a new material platform to explore the intricate interplay between the spin–charge order, flat band structures, interlayer coupling, strange metal behaviour and high-temperature superconductivity.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Roadmap on commercialization of metal halide perovskite photovoltaics

Perovskite solar cells (PSCs) represent one of the most promising emerging photovoltaic technologies due to their high power conversion efficiency. However, despite the huge progress made not only in terms of the efficiency achieved, but also fundamental understanding of the relevant physics of the devices and issues which affect their efficiency and stability, there are still unresolved problems and obstacles on the path toward commercialization of this promising technology. In this roadmap, we aim to provide a concise and up to date summary of outstanding issues and challenges, and the progress made toward addressing these issues. While the format of this article is not meant to be a comprehensive review of the topic, it provides a collection of the viewpoints of the experts in the field, which covers a broad range of topics related to PSC commercialization, including those relevant for manufacturing (scaling up, different types of devices), operation and stability (various factors), and environmental issues (in particular the use of lead). We hope that the article will provide a useful resource for researchers in the field and that it will facilitate discussions and move forward toward addressing the outstanding challenges in this fast-developing field.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Magnetic ordering suppressed phase transformation of a TRIP-HEA during thermal cycling

Transformation-induced plasticity (TRIP) high-entropy alloys (HEAs) have drawn great attention as they present excellent mechanical properties, and their phase stability is critical for the underlying deformation mechanisms and the application temperature range. In this study, the kinetic phase transformation behavior of a dual-phase TRIP-HEA Fe 50 Mn 30 Co 10 Cr 10 (at. %) was probed by in situ neutron diffraction during thermal cycling between 293 and 425 K. Continuous austenitic and martensitic transformation were visualized through the evolution of hexagonal close-packed phase fraction during thermal cycling. Specifically, thanks to the magnetic sensitivity of neutron diffraction, it was found that the martensitic transformation under cooling became suppressed when the antiferromagnetic ordering started at ~326 K. This temperature was further confirmed as the Néel temperature by magnetization measurements. In this work, thermodynamic calculations revealed that the suppression effect on martensitic transformation is attributed to the consumption of the chemical driving force by the magnetic ordering. The magnetic ordering at such relatively high temperature is associated with the high Mn content. These findings shed light on a potential strategy to achieve better mechanical properties of Mn-containing alloys by manipulating the magnetic property through tuning the Mn content.

36 MATERIALS SCIENCE↗
DOE OSTI2021

A Possible Tidal Disruption Event Candidate in the Black Hole Binary System of OJ 287

The BL Lacertae OJ 287 is a supermassive black hole binary system with complex physics of its irregular flares. During 2016 October–2017 April, a surprising outburst in the X-ray, UV, and optical bands was detected, while no variability was seen in the γ-ray light curve. During the outburst, the X-ray light curves were dominated by the soft X-rays, whose peak in luminosity was ~10 46 erg s -1 —more than 10 times higher than the mean level before the outburst—and a "softer-when-brighter" phenomenon was exhibited. These above phenomena have been reported by some previous works. The hardness ratio showed negligible evolution with flare time and soft X-ray luminosity. Critically, the luminosity of the soft X-rays decayed following a power law of $t$ -5/3 , which occurs in most tidal disruption events (TDEs), and a similar trend can be seen in the UV and optical bands during the soft X-ray declining period. Helium and oxygen narrow emission lines are strengthened prominently in the optical spectra of post outburst epochs, that could be attributed to the surrounding gas caused by TDE. In conclusion, we discuss three possible origins of the event, including the jet's precession, the aftereffects of the black hole–disk impaction, and the TDE. Our results show that the TDE is the more likely scenario to explain the outburst.

79 ASTRONOMY AND ASTROPHYSICS↗
DOE OSTI2021

Photometric Study and Absolute Parameter Estimation of Six Totally Eclipsing Contact Binaries

High precision CCD observations of six totally eclipsing contact binaries were presented and analyzed. It is found that only one target is an A-type contact binary (V429 Cam), while the others are W-type contact ones. By analyzing the times of light minima, we discovered that two of them exhibit secular period increase while three manifest long-term period decrease. For V1033 Her, a cyclic variation superimposed on the long-term increase was discovered. By comparing the Gaia distances with those calculated by the absolute parameters of 173 contact binaries, we found that the Gaia distance can be applied to estimate the absolute parameters for most contact binaries. The absolute parameters of our six targets were estimated using their Gaia distances. The evolutionary status of contact binaries was studied, and we found that the A- and W-subtype contact binaries may have different formation channels. The relationship between the spectroscopic and photometric mass ratios for 101 contact binaries was presented. It was discovered that the photometric mass ratios are in good agreement with the spectroscopic ones for almost all of the totally eclipsing systems, which is corresponding to the results derived by Pribulla et al. and Terrell & Wilson.

47 OTHER INSTRUMENTATION↗
DOE OSTI2021

Long‐term continuous cropping affects ecoenzymatic stoichiometry of microbial nutrient acquisition: a case study from a Chinese Mollisol

Abstract BACKGROUND Soil‐ and plant‐produced extracellular enzymes drive nutrient cycling in soils and are assumed to regulate supply and demand for carbon (C) and nutrients within the soil. Thus, agriculture management decisions that alter the balance of plant and supplemental nutrients should directly alter extracellular enzyme activities (EEAs), and EEA stoichiometry in predictable ways. We used a 12‐year experiment that varyied three major continuous grain crops (wheat, soybean, and maize), each crossed with mineral fertilizer (WCF, SCF and MCF, respectively) or not fertilized (WC, SC and MC, respectively, as controls). In response, we measured the phospholipid fatty acids (PLFAs), EEAs and their stoichiometry to examine the changes to soil microbial nutrient demand under the continuous cropping of crops, which differed with respect to the input of plant litter and fertilizer. RESULTS Fertilizer generally decreased soil microbial biomass and enzyme activity compared to non‐fertilized soil. According to enzyme stoichiometry, microbial nutrient demand was generally C‐ and phosphorus (P)‐limited, but not nitrogen (N)‐limited. However, the degree of microbial resource limitation differed among the three crops. The enzymatic C:N ratio was significantly lower by 13.3% and 26.8%, whereas the enzymatic N:P ratio was significantly higher by 9.9% and 42.4%, in MCF than in WCF and SCF, respectively. The abundances of arbuscular mycorrhizal fungi and aerobic PLFAs were significantly higher in MCF than in WCF and SCF. CONCLUSION These findings are crucial for characterizing enzymatic activities and their stoichiometries that drive microbial metabolism with respect to understanding soil nutrient cycles and environmental conditions and optimizing practices of agricultural management. © 2021 Society of Chemical Industry.

Chen, Xu↗
DOE OSTI2020

Sulfuric Acid Improves the Reactivity of Zeolites via Dealumination

The demand for supplementary cementitious materials (SCMs), like fly ash, slag, and silica fume, is projected to rise over the next few decades. However, global decarbonization efforts, such as decommissioning of coal-fired power plants, will limit the supply of SCMs. Therefore, alternative SCM sources are a critical need for the cement and concrete industry. However, the high crystallinity of zeolites limits their pozzolanic reactivity. The goal of this work was to improve the reactivity of two common zeolites, namely clinoptilolite and SSZ-13, by treating them with sulfuric acid. The treatment enhanced zeolite reactivity via dealumination and decreased particle sizes, which led to increased reactivity with calcium hydroxide, as indicated by a 42.0% increase in reaction heat measured by isothermal calorimetry. Here, we elucidate mechanistic understanding that smaller particle sizes induced by acid treatment accelerated peak heat evolution, while free aluminates from dealumination increased heat via direct reaction with aqueous Ca 2+ .

36 MATERIALS SCIENCE↗
DOE OSTI2020

Size effect in stainless steel thin wires under tension

Miniaturization of modern devices drives the exploration into how materials behave in small dimensions. However, the mechanical behaviors of micro-scale specimens under varied loading conditions are still challenging to characterize and predict. In this work, specimen size-dependent weakening effect was experimentally revealed in 316L stainless steel thin wires under tension with wire diameter decreasing from 200 μm down to 61 μm. The underlying mechanisms were primarily associated with surface grain softening and strain localization, which were largely dependent on the number of grains across wire diameter. Through an analog composite model with surface and interior grains that follows the Hall-Petch relation, the extent of surface grain softening was found to coincide with the flow stress reduction due to lack of boundary strengthening. Further using elasto-plastic self-consistent polycrystal modeling, the stress-strain behaviors of interior and surface grains were well described in analogy to those of bulk materials with similar-size grains and extremely large grains, respectively. Subsequently, the analog composite model well simulated the specimen size-dependent weakening effect under tension. This article provided more insights into the size effect exploration and proposed a practical model for describing size-dependent mechanical behaviors of small-scale materials to be applied to miniaturized devices.

316L stainless steel↗