Engineering topics
Chen, Z
Publications and source records attributed to Chen, Z.
Plasma enhanced layer-by-layer deposition and nanocrystallization of hydrogenated amorphous silicon films
Explore the source record for details and available documents.
High Pressure Elastic Behavior of Synthetic Mg 3 Y 2 (SiO 4 ) 3 Garnet up to 9 GPa
The compression behavior of synthetic magnesium- (Mg-) yttrium (Y) garnet Mg 3 Y 2 (SiO 4 ) 3 has been investigated upto about 8.79 GPa at 300 K using in situ angle-dispersive X-ray diffraction and a diamond anvil cell at the beamline X17C, National Synchrotron Light Source, Brookhaven National Laboratory. No phase transition has been observed within the pressure range investigated. The unit-cell parameters and volume decreased systematically with increasing pressure, and a reliable isothermal bulk modulus ( K T 0 ) and its pressure derivative ( K T 0 ′ ) were obtained in this study. The values of zero-pressure volume V 0 , K 0 , and K 0 ′ refined with a third-order Birch-Murnaghan equation of state are V 0 = 1727.9 ± 0.2 Å 3 , K T 0 = 145 ± 3 GPa, and K 0 ′ = 8.5 ± 0.9 . If K T 0 ′ is fixed at 4, K T 0 is obtained as 158 ± 2 GPa.
Effect of Discharge Parameters and Surface Characteristics on Ambient-Gas Plasma Disinfection
Explore the source record for details and available documents.
A multiphase model for pulsed ns-laser ablation of copper in an ambient gas
Laser ablation in an ambient gas is nowadays used in a growing number of applications, such as chemical analysis and pulsed laser deposition. Despite the many applications, the technique is still poorly understood. Therefore models describing the material evolution in time during short pulse laser irradiation can be helpful to unravel the puzzle and finally result in the optimization of the related applications. In the present work, a copper target is immersed in helium, initially set at atmospheric pressure and room temperature. Calculations are performed for a Gaussian-shaped laser pulse with a wavelength of 532 nm, full width at half maximum of 6 ns, and laser fluences up to 10 J/cm{sup 2}. In order to describe the transient behaviour in and above the copper target, hydrodynamic equations are solved. An internal energy method accounting for pressure relaxation is applied for the description of the target. In the plume domain a set of conservation equations is solved, assuming local thermodynamic equilibrium. Calculated crater depths and transmission profiles are compared with experimental results and similar trends are found. Our calculations indicate that for the laser fluence regime under study, explosive boiling could play a fundamental role in the plasma formation of metals under ns-pulsed laser irradiation.
Molecular beam epitaxy growth of high quality p-doped SnS van der Waals epitaxy on a graphene buffer layer
We report on the systematic investigation of optoelectronic properties of tin (IV) sulfide (SnS) van der Waals epitaxies (vdWEs) grown by molecular beam epitaxy (MBE) technique. Energy band simulation using commercial CASTEP code indicates that SnS has an indirect bandgap of size 0.982 eV. Furthermore, our simulation shows that elemental Cu can be used as a p-type dopant for the material. Growth of high quality SnS thin films is accomplished by MBE technique using graphene as the buffer layer. We observed significant reduction in the rocking curve FWHM over the existing published values. Crystallite size in the range of 2-3 {mu}m is observed which is also significantly better than the existing results. Measurement of the absorption coefficient, {alpha}, is performed using a Hitachi U-4100 Spectrophotometer system which demonstrate large values of {alpha} of the order of 10{sup 4} cm{sup -1}. Sharp cutoff in the values of {alpha}, as a function of energy, is observed for the films grown using a graphene buffer layer indicating low concentration of localized states in the bandgap. Cu-doping is achieved by co-evaporation technique. It is demonstrated that the hole concentration of the films can be controlled between 10{sup 16} cm{sup -3} and 5 x 10{sup 17}cm{sup -3} by varying the temperature of the Cu K-cell. Hole mobility as high as 81 cm{sup 2}V{sup -1}s{sup -1} is observed for SnS films on graphene/GaAs(100) substrates. The improvements in the physical properties of the films are attributed to the unique layered structure and chemically saturated bonds at the surface for both SnS and the graphene buffer layer. Consequently, the interaction between the SnS thin films and the graphene buffer layer is dominated by van der Waals force and structural defects at the interface, such as dangling bonds or dislocations, are substantially reduced.
Pressure-Induced Disordered Substitution Alloy in Sb[subscript 2]Te[subscript 3]
A new type of disordered substitution alloy of Sb and Te at above 15.1 GPa was discovered by performing in situ high-pressure angle-dispersive X-ray diffraction experiments on antimony telluride (Sb{sub 2}Te{sub 3}), a topological insulator and thermoelectric material, at room temperature. In this disordered substitution alloy, Sb{sub 2}Te{sub 3} crystallizes into a monoclinic structure with the space group C2/m, which is different from the corresponding high-pressure phase of the similar isostructural compound Bi{sub 2}Te{sub 3}. Above 19.8 GPa, Sb{sub 2}Te{sub 3} adopts a body-centered-cubic structure with the disordered atomic array in the crystal lattice. The in situ high-pressure experiments down to about 13 K show that Sb{sub 2}Te{sub 3} undergoes the same phase-transition sequence with increasing pressure at low temperature, with almost the same phase-transition pressures.
Plasmonic graphene transparent conductors.
Plasmonic graphene is fabricated using thermally assisted self-assembly of silver nanoparticles on graphene. The localized surface-plasmonic effect is demonstrated with the resonance frequency shifting from 446 to 495 nm when the lateral dimension of the Ag nanoparticles increases from about 50 to 150 nm. Finite-difference time-domain simulations are employed to confirm the experimentally observed light-scattering enhancement in the solar spectrum in plasmonic graphene and the decrease of both the plasmonic resonance frequency and amplitude with increasing graphene thickness. In addition, plasmonic graphene shows much-improved electrical conductance by a factor of 2-4 as compared to the original graphene, making the plasmonic graphene a promising advanced transparent conductor with enhanced light scattering for thin-film optoelectronic devices.
Novel tri-modal defect structure in Nb-doped MOCVD YBa{sub 2}Cu{sub 3}O{sub 7}: a paradigm for pinning landscape control
No abstract prepared.
Novel tri-modal defect structure in Nb-doped MOCVD YBa2Cu3O7: A paradigm for pinning landscape control
Immobilization of vortices, or flux pinning, is both an enduring scientific issue and one of the most important problems in optimizing high temperature superconductors (HTS) for commercial use. Here, we demonstrate a practical approach to the creation of a multi-modal flux pinning landscape in YBa2Cu3O7 (YBCO) films employing an industrially scalable metal organic chemical vapor deposition technique. Through controlled additions of Nb, we have achieved a novel distribution of crystallographic defects that immobilize (pin) vortices in the YBCO matrix. That is, with only the addition of a single dopant element, a tri-modal defect structure that threads through the YBCO matrix laterally (parallel to the ab planes of YBCO), vertically (parallel to the YBCO c-axis), and isotropically in the form of random spherical defects is induced. For optimally doped samples, the influence of these multi-modal nanocrystalline defect structures on the flux pinning properties manifests itself as a superior improvement in the critical current density (Jc) for all magnetic field orientations. The results demonstrate the possibility of achieving an ideal flux pinning landscape (from an orientation and strength viewpoint), which permits the design of HTS wires with fully-tuneable properties by processes suitable for large-scale manufacturing.
X-ray Diffraction of Cubic Gd2)3/Er under High Pressure
In this paper, we report the in situ high pressure X-ray diffraction studies on Er{sup 3+} doped Gd{sub 2}O{sub 3} in a diamond anvil cell up to 39.8 GPa at room temperature. Several phase transitions have been identified in our studies. The structural transformation from a starting cubic phase to a hexagonal phase occurred during the sample compression process, at 8.57 GPa. And the hexagonal phase was stable from 12.5 GPa up to the highest pressure in this study but was not quenchable and transformed to a monoclinic phase after pressure release. An anomalous high pressure behavior in the hexagonal type Gd{sub 2}O{sub 3} phase was observed, which might be caused by an electron transition influenced by Er{sup 3+} ions doping. By fitting the compression data to the Birch-Murnaghan equation of state, the bulk moduli of the cubic and two hexagonal (at p < 19.9 GPa and p > 27.0 GPa) Gd{sub 2}O{sub 3} phases were determined to be 164 {+-} 3, 185 {+-} 7, and 150 {+-} 10 GPa with B'{sub 0} = 4, respectively.
X-ray Diffraction Study of Arsenopyrite at High Pressure
The high-pressure X-ray diffraction study of a natural arsenopyrite was investigated up to 28.2 GPa using in situ angle-dispersive X-ray diffraction and a diamond anvil cell at National Synchrotron Light Source, Brookhaven National Laboratory. The 16:3:1 methanol-ethanol-water mixture was used as a pressure-transmitting medium. Pressures were measured using the ruby-fluorescence method. No phase change has been observed up to 28.2 GPa. The isothermal equation of state (EOS) was determined. The values of K{sub 0}, and K'{sub 0} refined with a third-order Birch-Murnaghan EOS are K{sub 0} = 123(9) GPa, and K'{sub 0} = 5.2(8). Furthermore, we confirm that the linear compressibilities ({beta}) along a, b and c directions of arsenopyrite is elastically isotropic ({beta}{sub a} = 6.82 x 10{sup -4}, {beta}{sub b} = 6.17 x 10{sup -4} and {beta}{sub c} = 6.57 x 10{sup -4} GPa{sup -1}).