Engineering topics
Publications and source records attributed to Childs, R. E..
Navier-Stokes simulations are used to study the phenomena of wing lift augmentation with spanwise tip blowing. Flowfields calculated for varying blowing conditions are analyzed to determine the mechanisms responsible for providing lift augmentation. It is found that both viscous and inviscid effects are important.
Numerical simulations of a low aspect ratio wing with and without a spanwise directed jet issuing from the wing tip have been performed. The results show that the tip vortex is displaced outward and upward by the blowing. This gives rise to a local lift augmentation mechanism, vortex lift caused by the vortex core being above the wing, and a global mechanism, the reduction of induced velocities due to greater apparent spin.
A multigrid method is used to apply Newton's method to the Euler equations in a two dimensional curvilinear coordinate system. The objective is to obtain rapid convergence for steady state problems. Solutions computed with the method evolve in a non-time-like manner. Stable pressure distributions typically develop in eight to ten Newton-multigrid steps, which is equivalent to the computational work of about 70 iterations with a factored implicit algorithm.
A two-dimensional implicit finite-difference code is applied to the inviscid Euler equations to compute transonic flow past airfoils in order to provide well-documented standard test cases for the general user community. The code is an improved version of Steger's 1976 implicit code. Enhancements include the use of up-wind differencing in supersonic regions before shocks and a variable time step to accelerate convergence. An airfoil grid generation routine based on algebraic techniques is employed. The grids are clustered near shocks to improve resolution. Computed results are compared with other numerical results from the literature.
Integral methods are used to model subsonic flow in planar diffusers operating with or without stall. Turbulent boundary layers are computed with a lag-entrainment method employing new correlations for shape factor and skin friction, which are based on a Coles-Van Driest velocity profile. The inviscid flow is modeled as one dimensional and is easily coupled with the boundary layer method to yield equations that can be solved by integrating in the downstream direction. Analysis of the equations describing flow in a diffuser shows that the boundary layer separation singularity may not be eliminated by viscous-inviscid interaction; a modified interaction scheme is used to guarantee a non-singular equation set. The nature of this singularity offers an explanation for the apparent universality of asymmetric stall in planar diffusers. Results for several flows demonstrate the accuracy and range of applicability of the method.