Search NASA⌕ Search

Engineering topics

Choi, Minsu

Publications and source records attributed to Choi, Minsu.

Surface triggered stabilization of metastable charge-ordered phase in SrTiO 3

Charge ordering (CO), characterized by a periodic modulation of electron density and lattice distortion, has been a fundamental topic in condensed matter physics, serving as a potential platform for inducing novel functional properties. The charge-ordered phase is known to occur in a doped system with high d-electron occupancy, rather than low occupancy. Here, we report the realization of the charge-ordered phase in electron-doped (100) SrTiO 3 epitaxial thin films that have the lowest d-electron occupancy i.e., d 1 -d 0 . Theoretical calculation predicts the presence of a metastable CO state in the bulk state of electron-doped SrTiO 3 . Atomic scale analysis reveals that (100) surface distortion favors electron-lattice coupling for the charge-ordered state, and triggering the stabilization of the CO phase from a correlated metal state. This stabilization extends up to six unit cells from the top surface to the interior. Our approach offers an insight into the means of stabilizing a new phase of matter, extending CO phase to the lowest electron occupancy and encompassing a wide range of 3d transition metal oxides.

36 MATERIALS SCIENCE↗

Impact of wildfires on regional ozone and PM 2.5 : Considering the light absorption of Brown carbon

The influence of wildfire brown carbon (BrC) in moderating the formation of O 3 and fine particulate matter (PM 2.5 ) due to its absorption of ultraviolet (UV) radiation is, for the first time, investigated using a modified community multiscale air quality (CMAQ) model. The wavelength-dependent imaginary refractive index of the organic carbon from wildfires, which are needed by the CMAQ model for its inline photolysis rate calculation, are generated experimentally from wood burning aerosols from a combustion chamber. On high emission days of the Bastrop County Complex fire in Texas in early September 2011, BrC UV absorption reduces the daytime average NO 2 photolysis rate by up to 38% in the core region of the wildfire plume compared to the base scenario that does not consider BrC absorption. Consequently, O 3 production in the smoke plume is suppressed compared to the base scenario due to reduced HO x radical concentrations. Further, in the core region, the predicted O 3 increase due to wildfire reaches as high as 47–123 ppb without considering BrC absorption, the predicted increase of O 3 is 5–15% lower when BrC absorption is considered. Similarly, considering the BrC UV absorption leads to approximately 1% (or ~2–3 µgm -3 ) lower estimation of the wildfire emissions’ impact on total PM 2.5 . This change is small because secondary aerosols, which are the components affected by BrC absorption, only account for a small fraction of the total PM 2.5 in wildfire impacted regions in this study. In addition, our study shows that assumptions about aerosol mixing state (core-shell vs. homogeneous) in the inline photolysis rate calculation would not significantly affect out assessment of the impact of wildfire BrC light absorption on O 3 and PM 2.5 .

54 ENVIRONMENTAL SCIENCES↗

New formation and fate of Isoprene SOA markers revealed by field data-constrained modeling

Particulate 2-methyltetrols (2-MT) and 2-methylglyceric acid (2-MG) are typically used to indicate the abundance of isoprene-derived secondary organic aerosols (SOA). However, their formation and fate are not fully understood. In this study, we showed that particulate 2-MT and 2-MG collected at multiple monitoring sites under a wide range of atmospheric and emission conditions, with concentrations spanning six orders of magnitudes, are well reproduced with an expanded isoprene-SOA scheme implemented into the Community Multiscale Air Quality (CMAQ) model. The scheme considers their three-phase (gas-aqueous-organic phase) partitioning, formation from acid-driven multiphase reactions, and degradation by OH radicals in the gas and aqueous phases. The model results reveal that a non-aqueous formation pathway or direct biogenic emission is needed to supplement the commonly assumed acid-driven multiphase reaction process to explain the observed 2-MT concentrations. This missing pathway contributes to 20–40% of 2-MT in areas with aerosol pH < 2 and more than 70% under less acidic conditions (pH~2–5), such as those encountered in the western US and China. The typical summertime gas-phase photochemical lifetimes of 2-MT and 2-MG are estimated to be 4–6 and 20–30 h, respectively, and their aqueous lifetimes are approximately 20–40 h. Our simulations show that predicted 2-MT is mainly influenced by its aqueous phase loss to OH, but 2-MG is more sensitive to gas phase OH loss due to the preferential partitioning of the two tracers in the aqueous and gas phases, respectively.

54 ENVIRONMENTAL SCIENCES↗