Engineering topics

Choueiri, Edgar Y.

Publications and source records attributed to Choueiri, Edgar Y..

5 records

NASA NTRS2008

Current Sheet Formation in a Conical Theta Pinch Faraday Accelerator with Radio-frequency Assisted Discharge

Data from an inductive conical theta pinch accelerator are presented to gain insight into the process of inductive current sheet formation in the presence of a preionized background gas produced by a steady-state RF-discharge. The presence of a preionized plasma has been previously shown to allow for current sheet formation at lower discharge voltages and energies than those found in other pulsed inductive accelerator concepts, leading to greater accelerator efficiencies at lower power levels. Time-resolved magnetic probe measurements are obtained for different background pressures and pulse energies to characterize the effects of these parameters on current sheet formation. Indices are defined that describe time-resolved current sheet characteristics, such as the total current owing in the current sheet, the time-integrated total current ('strength'), and current sheet velocity. It is found that for a given electric field strength, maximums in total current, strength, and velocity occur for one particular background pressure. At other pressures, these current sheet indices are considerably smaller. The trends observed in these indices are explained in terms of the principles behind Townsend breakdown that lead to a dependence on the ratio of the electric field to the background pressure. Time-integrated photographic data are also obtained at the same experimental conditions, and qualitatively they compare quite favorably with the time-resolved magnetic field data.

Polzin, Kurt A.↗

NASA NTRS2007

Current sheet Formation in a Conical Theta Pinch Faraday Accelerator with Radio-Frequency Assisted Discharge

The inductive formation of current sheets in a conical theta pinch FARAD (Faraday Accelerator with Radio-frequency Assisted Discharge) thruster is investigated experimentally with time-integrated photography. The goal is to help in understanding the mechanisms and conditions controlling the strength and extent of the current sheet, which are two indices important for FARAD as a propulsion concept. The profiles of these two indices along the inside walls of the conical acceleration coil are assumed to be related to the profiles of the strength and extent of the luminosity pattern derived from photographs of the discharge. The variations of these profiles as a function of uniform back-fill neutral pressure (with no background magnetic field and all parameters held constant) provided the first clues on the nature and qualitative dependencies of current sheet formation. It was found that there is an optimal pressure for which both indices reach a maximum and that the rate of change in these indices with pressure differs on either side of this optimal pressure. This allowed the inference that current sheet formation follows a Townsend-like breakdown mechanism modified by the existence of a finite pressure-dependent radio-frequency-generated electron density background. The observation that the effective location of the luminosity pattern favors the exit-half of the conical coil is explained as the result of the tendency of the inductive discharge circuit to operate near its minimal self-inductance. Movement of the peak in the luminosity pattern towards the upstream side of the cone with increasing pressure is believed to result from the need of the circuit to compensate for the increase in background plasma resistivity due to increasing pressure.

Hallock, Ashley K.↗

NASA NTRS1992

Numerical simulation of MPD thruster flows with anomalous transport

Anomalous transport effects in an Ar self-field coaxial MPD thruster are presently studied by means of a fully 2D two-fluid numerical code; its calculations are extended to a range of typical operating conditions. An effort is made to compare the spatial distribution of the steady state flow and field properties and thruster power-dissipation values for simulation runs with and without anomalous transport. A conductivity law based on the nonlinear saturation of lower hybrid current-driven instability is used for the calculations. Anomalous-transport simulation runs have indicated that the resistivity in specific areas of the discharge is significantly higher than that calculated in classical runs.

Caldo, Giuliano↗

NASA NTRS1992

Current-driven plasma acceleration versus current-driven energy dissipation. III - Anomalous transport

In the present paper the linear stability description and weak turbulence theory are used to develop a second order description of wave-particle transport and anomalous dissipation. The goal is to arrive at anomalous transport coefficients that can be readily included in fluid flow codes. In particular, expressions are derived for the heating rates of ions and electrons by the unstable waves and for the electron-wave momentum exchange rate that controls the anomalous resistivity effect. Comparative calculations were undertaken assuming four different saturation models: ion trapping, electron trapping, ion resonance broadening, and thermodynamic bound. A foremost finding is the importance of the role of electron Hall parameter in scaling the level of anomalous dissipation for the parameter range of the MPD thruster plasma. Polynomial expressions of the relevant transport coefficients cast solely in terms of macroscopic parameters are also obtained for inclusion in plasma fluid codes for the self-consistent numerical simulation of real thruster flows including microturbulent effects.

Choueiri, Edgar Y.↗

NASA NTRS1992

Recent advances in MPD thruster research at Princeton

A summary of last years anode, plasma, and cathode findings is presented. A summary of this years activities and findings is also presented. A brief discussion of previous and current understanding is given and covers the following topics: existence of microinstabilities; the scaling of Va with the Hall parameter; the scaling of anomalous resistivity with the Hall parameter; the relation between anomalous resistivity and the anode drop; the presence of turbulence in the anode region; numerical simulation with anomalous transport; the use of magnets to decrease dissipation; performance testing with the new anode; the mechanisms behind the ionization sink; and lithiated cathode research.

Jahn, Robert G.↗