Search NASA⌕ Search

Engineering topics

Christopher J Bahr

Publications and source records attributed to Christopher J Bahr.

11 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2023

Characterization of Slat Noise Radiation from a High-Lift Common Research Model

A test campaign was conducted in the open-jet test section of the NASA Langley 14- by 22-Foot Subsonic Tunnel on a 10%-scale, semispan version of a High-Lift Common Research Model (CRM-HL) incorporating a leading-edge slat, trailing-edge flap and removable high-fidelity main landing gear. Aerodynamic and far field acoustic measurements were obtained on baseline and acoustically treated model configurations using an ensemble of time-averaged and unsteady surface pressure sensors paired with a traversing 97-microphone phased array viewing the pressure side of the airframe. A modified version of the DAMAS deconvolution method incorporating corrections for shear layer acoustic wave decorrelation was employed to determine the locations and strengths of relevant noise sources along the span of the slat and in the vicinity of the flap edges and landing gear. The main goal of the test campaign was to use the surface pressure and array data to evaluate the effectiveness of various slat noise reduction concepts. It was found that slat-gap fillers produced significant broadband noise reduction with minimal aerodynamic performance penalties for all Mach numbers and airfoil angles of attack that were investigated. The test campaign clearly demonstrated the noise reduction benefits that can be obtained by applying appropriate treatments to leading-edge slats on commercial transport-class aircraft.

Aeronautics Research Mission Directorate↗
NASA NTRS2020

Designing Shading Schemes for Microphone Phased Arrays

A technique is proposed for designing sensor weightings, or array shading functions, for microphone phased arrays. The presented method attempts to maintain mathematical simplicity while maximizing array gain for a desired mainlobe beamwidth. It does so using the two-parameter optimization of a family of functions. The shading design process is described and applied to an array used recently in the NASA Langley Research Center 14- by 22-Foot Subsonic Tunnel. Several variants of the method are compared to an existing shading scheme for the array, along with a more general optimization formulation. Results are presented for both an idealized point source and experimental data from the wind tunnel test. The shading schemes are shown to improve the behavior of array operations, but have a stronger impact on visual interpretation of maps than on source level calculations. The study results show that the two-parameter optimization scheme provides favorable characteristics while maintaining implementation simplicity.

Christopher J Bahr↗
NASA NTRS2019

Automated Classification of Transient Contamination in Stationary Acoustic Data

An automated procedure for the classification of transient contamination of stationary acoustic data is proposed and analyzed. The procedure requires the assumption that the stationary acoustic data of interest can be modeled as a band-limited, Gaussian random process. It also requires that the transient contamination be of higher variance than the acoustic data of interest. When these assumptions are satisfied, it is a blind separation procedure, aside from the initial input specifying how to subdivide the time series of interest. No a priori threshold criterion is required. Simulation results show that for a sufficient number of blocks, the method performs well, as long as the occasional false positive or false negative is acceptable. The effectiveness of the procedure is demonstrated with an application to experimental wind tunnel acoustic test data which are contaminated by hydrodynamic gusts.

binary classification↗
NASA NTRSDate not supplied

Toward Relating Open- and Closed-Test Section Microphone Phased Array Aeroacoustic Measurements

Aeroacoustic measurements utilizing microphone phased arrays are becoming more commonplace in large-scale wind tunnels. However, for such costly tests it is difficult to assess the influence of a given facility's configuration on the acquired data. One such opportunity has recently arisen in the NASA Langley Research Center 14- by 22-Foot Subsonic Tunnel, where the High-Lift configuration of the Common Research Model was tested in both open-jet and closed wall configurations. Acoustic data were acquired on the same model with the same specific hardware at the same Mach number; and for similar model angles of attack, array apertures, and array angles relative to the model location. Initial deconvolution comparisons using DAMAS appear poor. The closed test section results show contamination likely due to background noise and reflections. The open-jet results show severe blurring due to the decorrelation of acoustic waves passing through a turbulent free shear layer. However, accounting for image sources in the DAMAS grid reduces visual artifacts in the closed test section results, and a preliminary coherence correction technique mitigates the blurring in the open-jet results. Qualitatively, both tests identify similar source behavior. Quantitatively, summed spectra of the slat noise agree in some frequency bands but differ in others. Proposals that may mitigate the difference are given for each configuration, such as correcting for the array protective cover and applying background subtraction in the closed wall configuration, and further developing the coherence loss correction for deconvolution methods in the open-jet setup.

microphone array↗
NASA NTRSDate not supplied

Overview of Aeroacoustic Testing of the High-Lift Common Research Model

This paper presents an overview of the experimental data obtained in a 2020/2021 aeroacoustic test of the high-lift variant of the common research model. The breadth of the aerodynamic and acoustic measurements is highlighted along with some key results. Aerodynamic data were observed to be consistent with previous observations, and the acoustic measurements were repeatable once some background noise and shear layer issues were resolved. The primary purpose of the test was to evaluate the noise reduction potential of slat noise reduction devices, and a slat-gap filler was found to produce substantial noise reduction over a broad frequency range. The gap filler was designed to meet practical implementation considerations at full scale and constructed out of shape-memory alloys that would allow the slat to be articulated. However, additional structural testing will be required to demonstrate the performance of the gap filler during slat deployment and retraction. Over 3,500 test points were collected during the test, and only a small fraction of the experimental data has been processed in a preliminary manner. Nonetheless, the results presented demonstrate the quality of the dataset and reveal some insights about slat noise.

Aeroacoustics↗
NASA NTRSDate not supplied

Accounting for the Influence of Decorrelation in Microphone Phased Array Deconvolution Methods

Microphone phased arrays are a common tool for use in aeroacoustic wind tunnel testing. The analysis of acquired array data is known to suffer from decorrelation effects, where the coherence of an acoustic wave measured by a pair of microphones is degraded as the wave passes through a turbulent free shear layer or boundary layer. This paper describes, in detail, how to mitigate the influence of decorrelation effects when processing array data with deconvolution methods. This is done using the DAMAS algorithm as an example, applied to recent airframe noise test data acquired in the NASA Langley 14- by 22-Foot Subsonic Tunnel. Two ways of handling the turbulent propagation modeling, both assuming plane wave propagation, are described. Results show that while turbulence model fit parameters may differ, both methods output extremely similar deconvolution results. Further improvements likely require more accurate mean shear layer data prior to developing more involved turbulence models.

microphone array↗
NASA NTRSDate not supplied

Phased Array Characterization of Slat Noise Radiation from a High-Lift Common Research Model

A test campaign was conducted in the open-jet test section of the NASA Langley 14- by 22-Foot Subsonic Tunnel on a 10%-scale, semispan version of a High-Lift Common Research Model (CRM-HL) incorporating a leading-edge slat, trailing-edge flap and removable high-fidelity main landing gear. Far field acoustic measurements were obtained on baseline and acoustically treated model configurations using a traversing 97-microphone phased array that viewed the pressure side of the airframe. A modified version of the DAMAS deconvolution method incorporating corrections for shear layer acoustic wave decorrelation was employed to determine the locations and strengths of relevant noise sources along the span of the slat and in the vicinity of the flap edges and landing gear. The main goal of the test campaign was to use the array data to evaluate the effectiveness of various slat noise reduction concepts. It was found that slat-gap fillers produced significant broadband noise reduction for all Mach numbers and airfoil angles of attack that were investigated. Mach number scaling revealed an approximate velocity to the sixth power relationship for the slat noise at higher frequencies. Directivity measurements obtained from integration of DAMAS pressure-squared values over defined geometric zones around the model showed that baseline slat noise radiation approximated a dipole as a function of polar emission angle, becoming approximately omnidirectional with the introduction of the slat-gap filler. The test campaign clearly demonstrated the noise reduction benefits that can be obtained by applying appropriate treatments to leading edge slats on commercial transport-class aircraft.

William M Humphreys, Jr.↗
NASA NTRSDate not supplied

Noise Scattering Study for a NACA 0012 Airfoil with a Shielding Flap

Noise scattering measurements for a NACA 0012 airfoil with a flap were conducted. The effects of the flap relative placement and geometry on noise shielding are examined. This scattering test supports the development of a noise reduction concept (referred as the Shielding Flap) applicable to a NATO MULDICON vehicle. Together with the NASA PAASc scattering prediction method, the experimental study presented here was used for the initial exploration and development of the Shielding Flap concept.

noise shielding↗