Engineering topics

Chuang, K. L.

Publications and source records attributed to Chuang, K. L..

4 records

NASA NTRS1990

An Optimal Design For Steerable Dish Antenna With BWG

New design proposed for highly-efficient 34-m-diameter millimeter-wavelength antennas of NASA's Deep Space Network. Incorporates axial beam waveguide, BWG, and improved structure to maintain shape and alignment of reflecting surfaces. General approach to conceptual construction of structure to modularize overall system so critical constraint conditions pertaining to microwave optics and structural performance satisfied. Design retrofitted to existing NASA Deep Space Network 34-m antennas, or used as basis to build large ground-based steerable antennas. Engineering concepts involved in design adapted to design of other large, steerable antennas for telecommunications, radio astronomy, and military uses.

Chuang, K. L.↗

NASA NTRS1988

An optimal structure for a 34-meter millimeter-wave center-fed BWG antenna: The Cross-Box concept

An approach to the design of the planned NASA/JPL 34 m elevation-over-azimuth (Az-El) antenna structure at the Venus site (DSS-13) is presented. The antenna structural configuration accommodates a large (2.44 m) beam waveguide (BWG) tube centrally routed through the reflector-alidade structure, an elevation wheel design, and an optimal structural geometry. The design encompasses a cross-box elevation wheel-reflector base substructure that preserves homology while satisfying many constraints, such as structure weight, surface tolerance, stresses, natural frequency, and various functional constraints. The functional requirements are set to ensure that microwave performance at millimeter wavelengths is adequate. The cross-box configuration was modeled, optimized, and found to satisfy all DSN HEF baseline antenna specifications. In addition, the structure design was conceptualized and analyzed with an emphasis on preserving the structure envelope and keeping modifications relative to the HEF antennas to a minimum, thus enabling the transferability of the BWG technology for future retrofitting. Good performance results were obtained.

Chuang, K. L.↗

NASA NTRS1987

Statistical analysis of the 70 meter antenna surface distortions

Statistical analysis of surface distortions of the 70 meter NASA/JPL antenna, located at Goldstone, was performed. The purpose of this analysis is to verify whether deviations due to gravity loading can be treated as quasi-random variables with normal distribution. Histograms of the RF pathlength error distribution for several antenna elevation positions were generated. The results indicate that the deviations from the ideal antenna surface are not normally distributed. The observed density distribution for all antenna elevation angles is taller and narrower than the normal density, which results in large positive values of kurtosis and a significant amount of skewness. The skewness of the distribution changes from positive to negative as the antenna elevation changes from zenith to horizon.

Kiedron, K.↗

NASA NTRS1987

Structural design options for the new 34 meter beam waveguide antenna

In addition to the successful network of 34 m High Efficiency antennas recently built by JPL, the Deep Space Network (DSN) is embarking on the construction of a 34 m high performance, research and development antenna with beam waveguide optics at the Venus site. The construction of this antenna presents many engineering challenges in the area of structural, mechanical, RF, and pointing system design. A set of functional and structural design requirements is outlined to guide analysts in the final configuration selection. Five design concepts are presented covering both the conventional center-fed beam optics as well as the nonconventional, by-pass beam configuration. The merits of each concept are discussed with an emphasis on obtaining a homologous design. The preliminary results of structural optimization efforts, currently in progress, are promising, indicating the feasibility of meeting, as a minimum, all X-band (8.4 GHz) requirements, with a goal towards meeting Ka-band (32 GHz) quality performance, at the present budget constraints.

Katow, S.↗