Engineering topics

Chuang, Po-Ya Abel

Publications and source records attributed to Chuang, Po-Ya Abel.

3 records

DOE OSTI2023

Numerical investigation and experimental validation of water condensation in the gas diffusion layer with different properties

Liquid water in porous media hinders the transport of reactant to catalyst layer, where the electrochemical reactions occur, which in turn, reduces performance and lifetime of a proton exchange membrane fuel cell (PEMFC). In this study, two types of gas diffusion layer (GDL) materials are used to study the two-phase saturation distribution in a PEMFC. The correlations between the effective and anisotropic transport properties and porosity of the two GDLs are solved by the pore scale model. In addition, the anisotropic liquid water permeability and the relationship between saturation pressure and capillary pressure is determined by using the Lattice-Boltzmann method. Fuel cell performance as well as liquid water distribution in the GDL using neutron radiography are obtained for validation. Under wet conditions, the cell with Freudenberg GDL performs better than that using Toray GDL, especially at high current densities. The results of the two-phase model simulation show that the peak water saturation for Toray GDL occurs in the catalyst layer and can reach 40%, while the peak water saturation for Freudenberg GDL occurs inside the GDL directly under the ribs and only reaches 25% saturation. The combined results provide key insights to enable high power density operation of a PEMFC through GDL material optimization.

42 ENGINEERING↗

DOE OSTI2022

Analytical-based simulation approach for an anion exchange membrane fuel cell

An analytical and empirical-based 1-D, non-isothermal, steady-state model for anion exchange membrane fuel cell capable of capturing two-phase phenomena is presented in this study. Coupled multi-physics including mass and charge transport, electrochemical reactions, heat transfer, and two-phase water transport are considered in the model and the simulated results are compared to experimental data. To better represent actual material properties and localized conditions, the model applies multilayer discretization in the gas diffusion electrode to enhance prediction accuracy. The model successfully predicts the baseline performance at 70 °C, 131 kPa abs., 92% RH with pure H 2 /O 2 gas as well as the limiting current at 10% H 2 . The robust simulation approach allows for simplistic and accurate estimation of cell performance without the complications of applying two-phase parameters and expensive computational need for numerical models. In addition, the results from the sensitivity studies of material properties and operating conditions provide valuable insights on water management strategies and optimal component design for advancing anion exchange membrane fuel cell technology.

1-D model↗

DOE OSTI2021

Experimental and computational study of the microporous layer and hydrophobic treatment in the gas diffusion layer of a proton exchange membrane fuel cell

Enabling fuel cell operation at high current density is critical for developing competitive alternative power system to replace internal combustion engine. However, liquid water management continues to be a challenge for high humidity or high current density operation. Water condensation in the porous media hinders efficient oxygen transport to the catalyst layer, which in turns, reduces fuel cell performance. To improve water management capability, the gas diffusion layer is often impregnated with Polytetrafluoroethylene (PTFE) and coated with a thin microporous layer, which have shown to improve fuel cell performance, especially under wet conditions. However, the fundamental mechanism that drives the performance enhancement is still not well understood. In this work, the effects of PTFE impregnation and MPL were studied using both experimental and computational techniques. Both limiting current and polarization tests under dry and wet operating condition are conducted to study the oxygen transport resistance and fuel cell performance. In addition, a 2-D, two-phase, multi-physics PEMFC model is developed to simulate performance and gain a fundamental understanding of local water saturation and oxygen concentration. The combined results show that 5 wt% PTFE impregnation with MPL significantly enhances liquid water management, which enables higher current density operation of a fuel cell.

25 ENERGY STORAGE↗