Search NASA⌕ Search

Engineering topics

Chupas, Peter J.

Publications and source records attributed to Chupas, Peter J..

Validation of non-negative matrix factorization for rapid assessment of large sets of atomic pair distribution function data

The use of the non-negative matrix factorization (NMF) technique is validated for automatically extracting physically relevant components from atomic pair distribution function (PDF) data from time-series data such as in situ experiments. The use of two matrix-factorization techniques, principal component analysis and NMF, on PDF data is compared in the context of a chemical synthesis reaction taking place in a synchrotron beam, applying the approach to synthetic data where the correct composition is known and on measured PDFs from previously published experimental data. The NMF approach yields mathematical components that are very close to the PDFs of the chemical components of the system and a time evolution of the weights that closely follows the ground truth. Lastly, it is discussed how this would appear in a streaming context if the analysis were being carried out at the beamline as the experiment progressed.

36 MATERIALS SCIENCE↗

Intrinsic Kinetic Limitations in Substituted Lithium-Layered Transition-Metal Oxide Electrodes

Substituted Li-layered transition-metal oxide (LTMO) electrodes such as Li x Ni y Mn z Co 1-y-z O 2 (NMC) and Li x Ni y Co 1-y-z Al z O 2 (NCA) show reduced first cycle Coulombic efficiency (90-87% under standard cycling conditions) in comparison with the archetypal Li x CoO 2 (LCO; similar to 98% efficiency). Focusing on Li x Ni 0.8 Co 0.15 Al 0.0.5 O 2 as a model compound, we use operando synchrotron X-ray diffraction (XRD) and nuclear magnetic resonance (NMR) spectroscopy to demonstrate that the apparent first-cycle capacity loss is a kinetic effect linked to limited Li mobility at x > 0.88, with near full capacity recovered during a potentiostatic hold following the galvanostatic charge- discharge cycle. This kinetic capacity loss, unlike many capacity losses in LTMOs, is independent of the cutoff voltage during delithiation and it is a reversible process. The kinetic limitation manifests not only as the kinetic capacity loss during discharge but as a subtle bimodal compositional distribution early in charge and, also, a dramatic increase of the charge-discharge voltage hysteresis at x > 0.88. 7 Li NMR measurements indicate that the kinetic limitation reflects limited Li transport at x > 0.86. Electrochemical measurements on a wider range of LTMOs including Li x (Ni,Fe) y Co 1-y O 2 suggest that 5% substitution is sufficient to induce the kinetic limitation and that the effect is not limited to Ni substitution. In this paper, we outline how, in addition to a reduction in the number of Li vacancies and shrinkage of the Li-layer size, the intrinsic charge storage mechanism (two-phase vs solid-solution) and localization of charge give rise to additional kinetic barriers in NCA and nonmetallic LTMOs in general.

25 ENERGY STORAGE↗